نوع مقاله : پژوهشی
نویسندگان
1 گروه مهندسی عمران، دانشکده تحصیلات تکمیلی،موسسه جهاد دانشگاهی خوزستان، اهواز، ایران
2 معاون آموزشی و تحصیلات تکمیلی، استادیار گروه آموزشی عمران، موسسه آموزشی عالی جهاددانشگاهی خوزستان، اهواز، ایران
3 استادیار، دانشکده عمران و معماری، دانشگاه ملایر
چکیده
کلیدواژه‌ها
موضوعات
عنوان مقاله [English]
نویسندگان [English]
The shear wall is one of the most important systems to resist lateral loads in the building. In addition to controlling the lateral displacement of the structure and dealing with the lateral force, this system significantly increases the stiffness of the structure.The purpose of this article is to investigate the nonlinear behavior of semi-supported steel composite shear wall at the edges under monotonic and cyclic loading near and far-fault. In this article, after verification, firstly, the semi-supported steel shear wall is modeled and analyzed in ETABS software to select the boundary members and select the critical opening, then the base model of the semi-supported steel shear wall is converted to a semi-supported composite shear wall and in Finally, it is modeled and checked in ABAQUS software. Among the investigated variables are reducing the thickness of the concrete coating on both sides of the steel plate of the wall, the results showed that the addition of concrete to the SSSW model (converting the model to SSCSW) increases the initial in-plane hardness by 350% and results in the domain of the built models showed that Also, when concrete was added to the SSSW model, the ductility increased by 150% in two states near and far from the fault. And comparing the ultimate strength (peak of the cyclic diagram) also showed that regardless of the type of cyclic loading pattern, the calculated value for SSCSW is 28% higher than SSSW. using concrete coating on one side of the steel plate of the wall and increasing the thickness of the steel plate of the wall.In steel shear wall, to avoid nonlinearization of boundary elements, capacity-based design is performed, which results in a significant increase in the amount of steel used in boundary elements. To reduce the boundary element steel, a semi-supported steel shear wall (SSSW) has been proposed and its efficiency has been proven in previous studies.In addition, it seemed that the use of concrete coating on steel plate could improve the strength and ductility of the SSSW system. For this purpose, an 8-storey building equipped with SSSW was first designed and its most critical opening was converted to a composite model (SSCSW) and its finite element model was produced.This model was presented against near and far fault cycle loading analysis and cyclic curve, capacity, dissipation energy, This model was presented against near and far fault cycle loading analysis and cyclic curve.capacity, dissipation energy,
کلیدواژه‌ها [English]
)