Hostname: page-component-848d4c4894-p2v8j Total loading time: 0.001 Render date: 2024-05-23T02:34:16.015Z Has data issue: false hasContentIssue false

Enhanced sedimentation in narrow tilted channels

Published online by Cambridge University Press:  20 April 2006

Eric Herbolzheimer
Affiliation:
Department of Chemical Engineering, Stanford University, Stanford, CA 94305 Present address: Chemical Engineering, California Institute of Technology, Pasadena, CA 91125.
Andreas Acrivos
Affiliation:
Department of Chemical Engineering, Stanford University, Stanford, CA 94305

Abstract

The analysis of Acrivos & Herbolzheimer (1979) is extended to describe the sedimentation of dilute suspensions in tilted two-dimensional channels in which the spacing between the plates is small compared with their length. The theory assumes that the flow is laminar and that the suspension consists of monodisperse spherical beads having small particle Reynolds number. Expressions for the flow fields in the clearfluid region and in the suspension, as well as for the location of the interface separating these two regions, are obtained asymptotically in the limit of Λ [Gt ] 1 with $R\Lambda^{-\frac{1}{3}}\ll 1$, where R and A are as defined in the previous work. The present analysis differs from that given earlier in that the aspect ratio, i.e. the ratio of the height of the suspension to the channel width, is now taken to be O(A1/3) rather than O(1) as was the case before. Under these conditions, the solution of the time-dependent equations leads to the surprising prediction that the clear-fluid layer which forms beneath the downward-facing plate attains a steady shape only along the lower portion of the channel while, in contrast, its thickness increases with time for locations along the channel that are above some critical point. Because of this transient behaviour, the well-known Ponder-Nakamura-Kuroda (PNK) formula overestimates the rate at which the top of the suspension region falls with time; however, the PNK results for the volumetric settling rate still hold under the conditions considered in this paper. It is shown that this discontinuity in the interface shape can be suppressed in continuous settling systems but only if the feed and withdrawal locations are chosen properly.

Batch sedimentation experiments were conducted in a channel with parallel flat walls under the following sets of conditions: H0/b ≈ 90, 5° ≤ θ ≤ 45°, 0·01 ≤ c0 ≤ 0·025, 1·7 × 107 < Λ < 3·5 × 107, and 1·8 < R < 2·1, where θ is the angle of inclination of the vessel from the vertical, and c0 is the initial volume fraction of solids in the suspension. The experimental observations were found to be in excellent agreement with the theoretical predictions.

Type
Research Article
Copyright
© 1981 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Acrivos, A. & Herbolzheimer, E. 1979 Sedimentation in settling tanks with inclined walls. J. Fluid Mech. 92, 435457.Google Scholar
Barnea, E. & Mizrahi, J. 1973 A generalized approach to the fluid dynamics of particulate systems: Part 1. General correlation for fluidization and sedimentation in solid multiparticle systems. Chem. Engng J. 5, 171189.Google Scholar
Boycott, A. E. 1920 Sedimentation of blood corpuscles. Nature 104, 532.Google Scholar
Herbolzheimer, E. 1980 Enhanced sedimentation in settling vessels having inclined walls. Ph.D. dissertation, Stanford University.
Nakamura, N. & Kuroda, K. 1937 La cause de l'accélération de la vitesse de sédimentation des suspensions dans les récipients inclinés. Keijo J. Med. 8, 256296.Google Scholar
Ponder, E. 1925 On sedimentation and rouleaux formation. Quart. J. Exp. Physiol. 15, 235252.Google Scholar
Probstein, R. F. & Hicks, R. E. 1978 Lamella settlers: a new operating mode for high performance. Ind. Water Engng 15, 68.Google Scholar
Probstein, R. F., Yung, D. & Hicks, R. E. 1977 A model for lamella settlers. Presented at ‘Theory, Practice, and Process Principles for Physical Separations’, Engng Foundation Conf., Asilomar, California.