사출성형제품 이형 후 상온 냉각 중 크립 현상에 관한 연구

김유정; 방희선

doi:10.7736/JKSPE.023.011

주제분류

...

저널정보

Korean Society for Precision Engineering
Journal of the Korean Society for Precision Engineering 학술저널
Journal of the Korean Society for Precision Engineering Vol.40 No.8
2023.08 639 - 645 (7page)
DOI : 10.7736/JKSPE.023.011

저자정보

김유정 (조선대학교)
방희선 (조선대학교)

이용수
내서재: 0

내서재에 추가
되었습니다. 내서재에서
삭제되었습니다.

초록·키워드

오류제보하기

Recently, with the expansion of application of polymer composite materials, high levels of deformation compensation actions have been developed. However, there is a problem of high-temperature viscoelasticity that occurs over time after completing the injection molding process. In this study, changes of mechanical properties of the Moldflow program for injection molding were analyzed to verify the viscoelasticity phenomenon through deformation analysis. In addition, deformation analysis of plastic injection molded products according to arrangement of three ribs was conducted and two products with different geometric shapes of the same function were compared. As a result, it was possible to reflect the viscoelastic effect by reducing the elastic modulus and shear modulus of the material. It was confirmed that the geometric shape with thick ribs formed in multiple longitudinal directions was mainly responsible. On the surface of the product where the rib arrangement was parallel and perpendicular to the flow direction, the orientation was orthogonal to the linear direction and the maximum residual stress was 81.17 MPa, which showed the largest value. It was judged that viscoelastic phenomena could be predicted and that an arrangement of parallel and perpendicular ribs that might intersect should be avoided.

#Fiber-reinforced polymer (섬유강화플라스틱) #Composite materials (복합재료) #Injection molding (사출성형) #Viscoelasticity (점탄성)