This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Analysis of Fuel Spray Characteristics and Combustion Phenomena under High Pressure Fuel Injection
Annotation ability available
Sector:
Language:
English
Abstract
Two types of high pressure injection equipment, which can produce a pressure of 250MPa, have been developed. One is a hydraulic pressure intensified type, having a “GRADUAL RISE AND SHARP CUT” injection rate pattern. The other is a pressure accumulator type, having a “SQUARE” injection rate pattern. These equipments have been evaluated with a high pressure vessel for analyzing the effect of injection pressure and injection rate upon the characteristics of non-evaporating fuel spray. High speed photography, shadow photography, holography and image analysis techniques were used for these studies. It was found that the fuel injected under high pressure forms finer droplets and produces a leaner mixture. It was also found that several differences exist in the structure of fuel spray between the accumulator type and the pressure intensified type. The reasons for these differences are discussed herein. One of these injection equipments was installed on a glass piston engine for observing combustion phenomena. The combustion with high pressure injection showed quite superior characteristics.
Recommended Content
Authors
- T. Minami - Advanced Combustion Engineering Institute Co., Ltd.
- I. Yamaguchi - Advanced Combustion Engineering Institute Co., Ltd.
- M. Shintani - Advanced Combustion Engineering Institute Co., Ltd.
- K. Tsujimura - Advanced Combustion Engineering Institute Co., Ltd.
- T. Suzuki - Advanced Combustion Engineering Institute Co., Ltd.
Citation
Minami, T., Yamaguchi, I., Shintani, M., Tsujimura, K. et al., "Analysis of Fuel Spray Characteristics and Combustion Phenomena under High Pressure Fuel Injection," SAE Technical Paper 900438, 1990, https://doi.org/10.4271/900438.Also In
References
- Kato T. Tujimura K. Shintani M. Minami T. Yamaguchi I. “Spray Characteristics and Combustion Improvement of D. I. Diesel Engine with High Pressure Fuel Injection” SAE Paper No. 890265
- Kamimoto T. Yokota H. Kobayashi H. “A New Technique for the Measurement of Sauter Mean Diameter of Droplets in Unsteady Dense Sprays” SAE Paper No. 890316
- Sakane A. Hirata S. Shimotsu M. Sumimoto T. “Study of Fuel Distribution in Diesel Spray (Effects of Nozzle Diameter, Injection Pressure and Gas Density)” Trans.JSME 52 487 1987 1122 1128