p.1136
p.1142
p.1147
p.1153
p.1159
p.1165
p.1171
p.1176
p.1182
Feasibility of Cast and Wrought Co-Al-W-X Gamma-Prime Superalloys
Abstract:
In 2006, J. Sato et al. discovered the L12 gamma-prime phase in the Co-Al-W alloy system. Since that time there has been a significant academic effort to characterize and understand the thermodynamics, the structure, and properties of alloys in this system. That work has shown that such alloys have promise as next generation high temperature materials due to the ability to engineer a high gamma-prime content alloy with a higher gamma prime solvus and higher melting point than many Ni-base gamma-prime strengthened alloys. Furthermore, a relatively narrow range of solidification temperature and large range of temperature between the gamma-prime solvus and the solidus are two characteristics that suggest cast and wrought versions of the alloys should be able to be manufactured routinely. However, to date all published research has been on small, laboratory scale samples typically less than about 2 kg, cast and hot rolled or cast as single crystals. This paper describes ATI’s experience in assessing the feasibility of manufacturing a cast and wrought billet product in the Co-Al-W-X alloy system. Three 22 kg heats were produced to examine a small range of alloy compositions of potential commercial interest: Co-9Al-9W, Co-9Al-9W-2Ti, and Co-9Al-9W-2Ti-0.02B, respectively. Each heat was vacuum induction melted and vacuum arc remelted. The as-cast microstructure will be presented. Ingots were homogenized and hot worked. The microstructure at various stages of production are shown and hot working behavior is described.
Info:
Periodical:
Pages:
1159-1164
Citation:
Online since:
May 2014
Authors:
Price:
Permissions: