中国光学, 2019, 12 (1): 138, 网络出版: 2019-03-06   

3种主动合成孔径成像技术极限探测能力的分析与比较

Analysis and comparison of limit detection capabilities of three active synthetic aperture imaging techniques
作者单位
1 中国科学院 长春光学精密机械与物理研究所 光电探测部, 吉林 长春130033
2 中国科学院大学, 北京100049
摘要
为了深入研究可行的中高轨成像技术, 本文从探测能力角度(用最低发射激光功率表示)深入分析和比较3种主动干涉合成孔径成像技术--傅立叶望远镜(又称为相干场成像或条纹场扫描成像)、成像相关术(又称为强度相关成像)和剪切光束成像。本文利用光电倍增管的信噪比模型和激光作用距离方程, 较为细致地分析每种技术在满足单次信噪比(SNR=5)条件下的极限探测能力。通过仿真分析得出:傅立叶望远镜、成像相关术和剪切光束成像所需的最低单光束单脉冲能量分别为114 J、073 MJ和31 MJ。最终得出傅立叶望远镜是上述3种主动成像技术中在目前技术水平下最适合中高轨目标(约36 000 km)高分辨成像的可用技术的结论。
Abstract
In order to deeply study the feasibility GEO imaging techniques, this paper deeply analyzes and compares three techniques for active interferometric synthetic aperture imaging by means of sensitivity. These techniques are Fourier telescopy, imaging correlography and sheared-beam imaging. Using a SNR(signal to noise ratio) model for photomultiplier tubes and laser range equations, this paper gives a detailed analysis of the limit detection capability of each technique when SNR is 5. Through simulation, it was found that the lowest single pulse energies for Fourier telescopy, imaging correlography and sheared-beam imaging were 114 J, 073 MJ and 31 MJ, respectively. The conclusion is that Fourier telescopy is the best among these three imaging techniques, making it most suitable for GEO imaging in the present era.

董磊, 卢振武, 刘欣悦. 3种主动合成孔径成像技术极限探测能力的分析与比较[J]. 中国光学, 2019, 12(1): 138. DONG Lei, LU Zhen-wu, LIU Xin-yue. Analysis and comparison of limit detection capabilities of three active synthetic aperture imaging techniques[J]. Chinese Optics, 2019, 12(1): 138.

本文已被 1 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!