Diagnostic System for Rapid and Sensitive Differential Detection of Pathogens

Naturally emerging and deliberately released pathogens demand new detection strategies to allow early recognition and containment. We describe a diagnostic system for rapid, sensitive, multiplex discrimination of microbial gene sequences and report its application for detecting 22 respiratory pathogens in clinical samples.

Naturally emerging and deliberately released pathogens demand new detection strategies to allow early recognition and containment. We describe a diagnostic system for rapid, sensitive, multiplex discrimination of microbial gene sequences and report its application for detecting 22 respiratory pathogens in clinical samples.

E fficient laboratory diagnosis of infectious diseases is
increasingly important to clinical management and public health. Methods to directly detect nucleic acids of microbial pathogens in clinical specimens are rapid, sensitive, and may succeed when culturing the organism fails. Clinical syndromes are infrequently specific for single pathogens; thus, assays are needed that allow multiple agents to be simultaneously considered. Current multiplex assays employ gel-based formats in which products are distinguished by size, fluorescent reporter dyes that vary in color, or secondary enzyme hybridization assays. Gelbased assays are reported that detect 2-8 different targets with sensitivities of 2-100 PFU or <1-5 PFU, depending on whether amplification is carried out in a single or nested format, respectively (1)(2)(3)(4). Fluorescence reporter systems achieve quantitative detection with sensitivity similar to that of nested amplification; however, their capacity to simultaneously query multiple targets is limited to the number of fluorescent emission peaks that can be unequivocally resolved. At present, up to 4 fluorescent reporter dyes can be detected simultaneously (5,6). Multiplex detection of up to 9 pathogens has been achieved in hybridization enzyme systems; however, the method requires cumbersome postamplification processing (7).

The Study
To address the need for sensitive multiplex assays in diagnostic molecular microbiology, we created a polymerase chain reaction (PCR) platform in which microbial gene targets are coded by a library of 64 distinct Masscode tags (Qiagen Masscode technology, Qiagen, Hilden, Germany). A schematic representation of this approach is shown in Figure 1. Microbial nucleic acids (RNA, DNA, or both) are amplified by multiplex reverse transcription (RT)-PCR using primers labeled by a photocleavable link to molecular tags of different molecular weight. After removing unincorporated primers, tags are released by UV irradiation and analyzed by mass spectrometry. The identity of the microbe in the clinical sample is determined by its cognate tags.
As a first test of this technology, we focused on respiratory disease because differential diagnosis is a common clinical challenge, with implications for outbreak control and individual case management. Multiplex primer sets were designed to identify up to 22 respiratory pathogens in a single Mass Tag PCR reaction; sensitivity was established by using synthetic DNA and RNA standards as well as titered viral stocks; the utility of Mass Tag PCR was determined in blinded analysis of previously diagnosed clinical specimens.
Oligonucleotide primers were designed in conserved genomic regions to detect the broadest number of members for a given pathogen species by efficiently amplifying a 50-to 300-bp product. In some instances, we selected established primer sets; in others, we used a software program designed to cull sequence information from GenBank, perform multiple alignments, and maximize multiplex performance by selecting primers with uniform melting temperatures and minimal cross-hybridization potential (Appendix Table, available at http://www.cdc. gov/ncidod/eid/vol11no02/04-0492_app.htm). Primers, synthesized with a 5′ C6 spacer and aminohexyl modification, were covalently conjugated by a photocleavable link to Masscode tags (Qiagen Masscode technology) (8,9). Masscode tags have a modular structure, including a tetrafluorophenyl ester for tag conjugation to primary amines; an o-nitrobenzyl photolabile linker for photoredox cleavage of the tag from the analyte; a mass spectrometry sensitivity enhancer, which improves the efficiency of atmospheric pressure chemical ionization of the cleaved tag; and a variable mass unit for variation of the cleaved tag mass (8,(10)(11)(12) primer sets are labeled with distinct molecular weight tags. Thus, amplification of a microbial gene target produces a dual signal that allows assessment of specificity. Gene target standards were cloned by PCR into pCR2.1-TOPO (Invitrogen, Carlsbad, CA, USA) by using DNA template (bacterial and DNA viral targets) or cDNA template (RNA viral targets) obtained by reverse transcription of extracts from infected cultured cells or by assembly of overlapping synthetic polynucleotides. Assays were initially established by using plasmid standards diluted in 2.5-µg/mL human placenta DNA (Sigma, St. Louis, MO, USA) and subjected to PCR amplification with a multiplex PCR kit (Qiagen), primers at 0.5 µmol/L each, and the following cycling protocol: an annealing step with a temperature reduction in 1°C increments from 65°C to 51°C during the first 15 cycles and then continuing with a cycling profile of 94°C for 20 s, 50°C for 20 s, and 72°C for 30 s in an MJ PTC200 thermal cycler (MJ Research, Waltham, MA, USA). Amplification products were separated from unused primers by using QIAquick 96 PCR purification cartridges (Qiagen, with modified binding and wash buffers). Masscode tags were decoupled from amplified products through UV light-induced photolysis in a flow cell and analyzed in a single quadrapole mass spectrometer using positive-mode atmospheric pressure chemical ionization (Agilent Technologies, Palo Alto, CA, USA). A detection threshold of 100 DNA copies was determined for 19 of 22 cloned targets by using a 22-plex assay ( Table 1).
Many respiratory pathogens have RNA genomes; thus, where indicated, assay sensitivity was determined by using synthetic RNA standards or RNA extracts of viral stocks. Synthetic RNA standards were generated by using T7 polymerase and linearized plasmid DNA. After quantita-tion by UV spectrometry, RNA was serially diluted in 2.5µg/mL yeast tRNA (Sigma), reverse transcribed with random hexamers by using Superscript II (Invitrogen, Carlsbad, CA, USA), and used as template for Mass Tag PCR. As anticipated, sensitivity was reduced by the use of RNA instead of DNA templates ( Table 1). The sensitivity of Mass Tag PCR to detect live virus was tested by using RNA extracted from serial dilutions of titered stocks of coronaviruses (severe acute respiratory syndrome [SARS] and OC43) and parainfluenzaviruses (HPIV 2 and 3). A 100-µL volume of each dilution was analyzed. RNA extracted from a 1-TCID 50 /mL dilution, representing 0.025 TCID 50 per PCR reaction, was consistently positive in Mass Tag PCR.
RNA extracted from banked sputum, nasal swabs, and pulmonary washes of persons with respiratory infection was tested by using an assay panel comprising 30 gene targets that represented 22 respiratory pathogens. Infection in each of these persons had been previously diagnosed through virus isolation, conventional nested RT-PCR, or both. Reverse transcription was performed using random hexamers, and Mass Tag PCR results were consistent in all cases with the established diagnosis. Infections with respiratory syncytial virus, human parainfluenza virus, SARS coronavirus, adenovirus, enterovirus, metapneumovirus, and influenza virus were correctly identified (Table 2 and  to RNA obtained from banked samples of cerebrospinal fluid and brain tissue that had been previously characterized by conventional diagnostic RT-PCR. Two of 3 cases of West Nile virus encephalitis were correctly identified. Eleven of 12 cases of enteroviral meningitis were detected representing serotypes CV-B2, CV-B3, CV-B5, E-6, E-11, E-13, E-18, and E-30 (data not shown).

Conclusions
Our results indicate that Mass Tag PCR is a sensitive and specific tool for molecular characterization of microflora. The advantage of Mass Tag PCR is its capacity for multiplex analysis. Although the use of degenerate primers (e.g., enteroviruses and adenoviruses, Appendix Table and Table 1) may reduce sensitivity, the limit of multiplexing to detect specific targets will likely be defined by the maximal primer concentration that can be accommodated in a PCR mix. Analysis requires the purification of product from unincorporated primers and mass spectroscopy. Although these steps are now performed manually, and mass spectrometers are not yet widely distributed in clinical laboratories, the increasing popularity of mass spectrometry in biomedical sciences and the advent of smaller, lower-cost instruments could facilitate wider use and integrated instrumentation. In addition to developing additional pathogen panels, our continuing work is focused on optimizing multiplexing, sensitivity, and throughput. Potential applications include differential diagnosis of infectious diseases, blood product surveillance, forensic microbiology, and biodefense.