Reliable precipitation forcing is essential for calculating the water balance, seasonal snowpack, glacier mass balance, streamflow, and other hydrological variables. However, satellite precipitation is often the only forcing available to run hydrological models in data-scarce regions, compromising hydrological calculations when unreliable. The IMERG product estimates precipitation quasi-globally from a combination of passive microwave and infrared satellites, which are intercalibrated based on GPM’s DPR and GMI instruments. Current GPM-DPR radar algorithms have satisfactorily estimated rainfall, but a limited consideration of PSD, attenuation correction, and ground clutter have degraded snowfall estimation, especially in mountain regions. This study aims to improve satellite radar snowfall estimates for this situation. Nearly two years (between 2019 and 2022) of aloft precipitation concentration, surface hydrometeor size, number and fall velocity, and surface precipitation rate from a high elevation site in the Canadian Rockies and collocated GPM-DPR reflectivities were used to develop a new snowfall estimation algorithm. Snowfall estimates using the new algorithm and measured GPM-DPR reflectivities were compared to other GPM-DPR-based products, including CORRA, which is employed to intercalibrate IMERG. Snowfall rates estimated with measured Ka reflectivities, and from CORRA were compared to MRR-2 observations, and had correlation, bias, and RMSE of 0.58 and 0.07, 0.43 and -0.38 mm h-1, and 0.83 and 0.85 mm h-1, respectively. Predictions using measured Ka reflectivity suggest that enhanced satellite radar snowfall estimates can be achieved using a simple measured reflectivity algorithm. These improved snowfall estimates can be adopted to intercalibrate IMERG in cold mountain regions, thereby improving regional precipitation estimates.