Ultraviolet Photoluminescence of Zno Quantum Dots Sputtered at Room-temperature References and Links

We observe ultraviolet photoluminescence from sputtered ZnO quantum dots which are fabricated with no annealing steps. The nanocrystals are embedded in amorphous SiO 2 and exhibit a narrow size distribution of 3.5 ± 0.6 nm. Photoluminescence and transmittance measurements show a shift of ultraviolet emission and absorption of the dots compared to bulk ZnO material. This work paves the way for cheap nanoop-tical devices in the ultraviolet which are fabricated in a single sputtering run. A gallium nitride single-photon source operating at 200 K, " Nature Mater 5, 887–892 (2006). Colloidal ZnO quantum dots in ultraviolet pillar microcavities, " Opt. " Preparation and characterization of ZnO particles embedded in SiO 2 matrix by reactive magnetron sputtering, " J. The structure and optical properties of ZnO nanocrystals embedded in SiO 2 fabricated by radio-frequency sputtering, " Nanotech-nology 20, 075601 (2009). Structural and photoluminescence characteristics of ZnO films by room temperature sputtering and rapid thermal annealing process, " Appl. Photoluminescence study of ZnO films prepared by thermal oxidation of Zn metallic films in air, " J. High-quality ZnO thin films prepared by low temperature oxidation of metallic Zn, " Appl.

Zinc oxide (ZnO) is a direct semiconductor with a wide bandgap of 3.4 eV.Therefore, it is a promising candidate for ultraviolet (UV) single-photon and opto-spintronic applications [1].An important objective in this area is the fabrication of an efficient single-photon source in the UV for free-space quantum communications and calibration purposes [2].To increase its efficiency, a monolithic system consisting of a UV nanoemitter located inside an optical cavity is beneficial.Recently, colloidal ZnO quantum dots have been successfully embedded in a dielectric pillar microcavity by combining radio-frequency sputtering and wet chemical preparation steps [3].However, a monolithic device consisting of both sputtered dielectric Bragg mirrors and sputtered ZnO quantum dots fabricated in one single process would be highly desirable -similar to the simple production of computer hard drives via sputtering.Today, ZnO quantum dots embedded in SiO 2 surroundings [4,5,6] as well as planar UV microcavities made of dielectric Bragg mirrors [3] may be readily fabricated via magnetron sputtering.However, thermal annealing is necessary up till now to prepare ZnO quantum dots showing UV emission.Such steps would lead to the degradation of the device.For example, thermally induced interdiffusion among the alternating dielectric layers degrades the Bragg mirrors and hence the performance of the optical cavity.This work demonstrates that ZnO quantum dots showing the desired photon emission in the UV can be prepared by sputtering without annealing.
ZnO quantum dots are fabricated by reactive radio frequency magnetron sputtering of ZnO and SiO 2 multilayers onto Al 2 O 3 (0001) and Si(001) substrates or carbon-coated Cu grids.A high vacuum base pressure of 2.5 × 10 −8 Torr ensures a stable and clean deposition environment.Si and ZnO targets are used at sputtering powers of 200 W and 30 W, respectively.The sputtering process is carried out in Ar (15 sccm) and O 2 (3 sccm) atmosphere.The working pressure is kept at 1.5 mTorr for deposition of SiO 2 and at 5 mTorr for deposition of ZnO.The entire fabrication process is carried out at room-temperature with no annealing steps.Compared to the amorphous SiO 2 , the dark ZnO regions show a stripe-like structure proving the crystallinity of the material.ZnO regions do not appear as connected layers, but as separated quantum dots.Their diameters, however, are difficult to estimate from these HRTEM side-view images since the quantum dots are arranged behind each other.are amorphous, the ZnO quantum dot shows a hexagonal crystal structure.The crystallinity is confirmed by the diffractogram (Fig. 2(c)), which corresponds to the HRTEM image.Fig. 3(a) shows a representative top-view HRTEM image of ZnO quantum dots embedded in SiO 2 .In this image the quantum dots are well separated.Evaluation of several HRTEM images allows counting the ZnO quantum dots with a resolution of 1 nm in diameter.This leads to the size distribution presented in Fig. 3(b).The average quantum dot diameter is 3.5 ± 0.6 nm, i. e. the sputtered quantum dots are almost monodisperse.No quantum dots with a diameter less than 2 nm or larger than 5 nm are found.This size distribution is comparable or even narrower than that of sputtered, but annealed, ZnO dots [5,6].Our measurements on the trilayer also prove that the formation of the ZnO quantum dots does not depend on the number of sputtered layers.This fact is important, since for optimum light-matter coupling only a single layer of quantum dots should be placed in the antinode of an optical microcavity.Assuming direct transitions for a semiconductor with parabolic bands, the bandgap E g may be extracted from α = A • hν − E g , where A is a constant and hν is the photon energy [7].Thus, the bandgap may be obtained by extrapolation of the linear part of α 2 to the energy axis, leading to E QD g = 3.40(2) eV.Note that this simplified model does not account for excitonic effects and therefore slightly underestimates the bandgap [8].
To directly compare the optical properties of the ZnO quantum dots with bulk ZnO, a reference sample consisting of a thick ZnO layer (330 nm) has been prepared by sputtering.It is deposited at room-temperature, but annealed for 3 h at 500 • C in 5 sccm O 2 and 20 sccm N 2 .Similiar thin-film preparation procedures, involving annealing steps between 400 • C and 600 • C, have been reported earlier to result in strong UV emission between 3.27 eV and 3.31 eV and suppression of defect photoluminescence in bulk ZnO [9,10,11].Evaluation of the optical transmittance (not shown) of the 330 nm ZnO layer results in a bandgap of E bulk g = 3.28(1) eV.When comparing the two retrieved bandgap values for bulk ZnO and ZnO quantum dots, we find a large blueshift of 120 meV which will be addressed later.
To demonstrate the ability of the sputtered quantum dots to serve as light emitters in the UV, we perform photoluminescence emission measurements.The sample is optically excited by a HeCd laser (P ex = 0.5 mW) at a wavelength of 325 nm.The room-temperature photoluminescence spectrum of the ZnO quantum dots in Fig. 5(a) clearly displays UV emission centered at E QD PL = 3.31 eV with a full width at half maximum (FWHM) of 83 meV.This UV emission is usually attributed to free exciton transitions [4,12].The FWHM is comparable to that of highquality bulk ZnO which shows a typical FWHM of 80 meV to 120 meV and is evidence for the good crystalline quality of the sample [10,11,12,13].The additional broad emission band in the visible region of the spectrum is attributed to electron-hole recombination of oxygen vacancies [14].To our knowledge this is the first report of UV emission at room-temperature from non-annealed sputtered ZnO quantum dots.In our fabrication process, the high crystalline quality and few surface defects needed to exhibit UV emission at room-temperature are achieved by using low sputtering rates of about 0.05 Å/s.Fig. 5(b) depicts the UV emission of the ZnO quantum dots compared to the UV emission of the sputtered bulk ZnO layer.Similiar to the transmittance measurements, the photoluminescence emission of the quantum dots at 3.31 eV shows a prominent blueshift compared to photoluminescence emission of 3.25 eV of the ZnO bulk layer.However, with 60 meV the shift is less pronounced than in transmittance measurements.We attribute the observed blueshift observed both in transmittance and photoluminescence measurements of ZnO quantum dots compared to bulk material to quantum confinement [4,15,16,17,18].Since the exciton Bohr radius in ZnO is 2.34 nm [19], our quantum dots with a diameter of 3.5 ± 0.6 nm are in the moderate confinement regime.Assuming free-standing spherical ZnO quantum dots, the shift of interband transitions due to confinement for a dot diameter of 3.5 nm may be estimated using the model of Brus [20] to be 300 meV.Electron and hole effective masses and the permittivity of ZnO are taken from [19].The calculated value is larger than our observed one of 120 meV.This discrepancy might be explained by the strong change of energy shift within only a small range of quantum dot diameter: the theoretical shift due to quantum confinement for ZnO quantum dots with a diameter of 2 nm is 1.40 eV, while it is only 70 meV for 5 nm ZnO quantum dots.Additional contributions to the blueshift could be caused by the confinement due to charges inside the quantum dots or dielectric surroundings [21].
Fonoberov et al. theoretically investigated the UV photoluminescence emission in ZnO nanocrystals with diameters between 2 − 6 nm, originating either from confined excitons or possible surface-bound ionized acceptor-exciton complexes [22].The computed energy shifts cannot be directly compared to our experimental data, since the calculations have been performed for ZnO quantum dots with either water or air as ambient media, but not with SiO 2 surroundings.However, radiative lifetime measurements of the exciton might unambiguously distinguish between quantum confinement or surface-bound exciton states [13,22,23,24].
We not only find energy shifts of the onset of transmission and UV photoluminescence emission of the ZnO quantum dots with respect to bulk material.We also observe a Stokes shift, i. e. an energy difference between absorption and emission (= E QD g − E QD PL ) of the ZnO quantum dots, which amounts to 90 meV (Fig. 6).This value agrees well with Stokes shifts of slightly larger ZnO quantum dots observed ealier [16].The Stokes shift is caused by the inhomogenous broadening of the exciton density of states [25] due to the slightly different sizes of the ZnO quantum dots.In photoluminescence measurements, excitons are generated after relaxation processes at the low-energy side of the inhomogeneously broadened quantum dot ensemble.In contrast, absorption appears over the entire energy range leading to the observed energy shift between absorption and emission: while strong absorption sets in above 3.5 eV, the excitonic photoluminescence emission can be observed at lower energies where the absorption is still weak.In summary, ZnO quantum dots with an average diameter of 3.5 ± 0.6 nm showing roomtemperature UV photoluminescence were prepared for the first time by magnetron sputtering without any annealing steps.This important improvement allows for the fabrication of nanooptical devices such as microcavities with incorporated ZnO quantum dots in a single sputtering run.The crystallinity and narrow size distribution of the prepared quantum dots are verified by HRTEM imaging.Room-temperature photoluminescence spectra show the characteristic free exciton UV emission which has not been observed for room-temperature-sputtered ZnO quantum dots before.Optical transmittance and photoluminescence spectra both show a blueshift of the quantum dot absorption and emission, respectivly, as compared to bulk ZnO material.This finding is attributed to moderate quantum confinement.

Fig. 1 (
a) illustrates the sample structure.First, a SiO 2 bottom layer of 15 nm thickness is deposited onto the Al 2 O 3 (0001) or Si(001) substrates to eliminate any influence of the substrate #138828 -$15.00USD Received 8 Dec 2010; revised 3 Jan 2011; accepted 3 Jan 2011; published 13 Jan 2011 (C) 2011 OSA on the growth of the quantum dots.The bottom layer is followed by ten alternating layers of ZnO (2 nm nominal thickness) and SiO 2 (5 nm nominal thickness) resulting in a total film thickness of 85 nm.Microstructural investigations of the sputter-deposited ZnO quantum dots are performed by high resolution transmission electron microscopy (HRTEM) using a Philips CM 200 FEG ST microscope at 200 kV acceleration voltage.Fig. 1(b) shows a representative HRTEM image (side-view) of the nominally 2-nm-thick ZnO layers embedded in amorphous SiO 2 .ZnO quantum dots may be identified as dark regions within the bright SiO 2 surroundings.

Fig. 3 .
Fig. 3. (Color online) (a) Top-view HRTEM image of a single layer of ZnO quantum dots embedded in amorphous SiO 2 .(b) histogramm of the size distribution of the sputtered ZnO quantum dots.

Fig. 4 .
Fig. 4. (Color online) Square of the optical absorption coefficient vs. photon energy of the ZnO quantum dots, demonstrating the onset of absorption above 3.5 eV.

Fig. 5 .
Fig. 5. (Color online) (a) Room-temperature photoluminescence (PL) spectrum of the ZnO quantum dots showing UV exciton-related as well as visible defect-related emission.(b) Comparison of UV photoluminescence emission of the sputtered ZnO quantum dots with a sputtered and annealed bulk ZnO layer of 330 nm thickness.

Fig. 6 .
Fig. 6. (Color online) Square of the optical absorption coefficient and UV photoluminescence of ZnO quantum dots, illustrating the Stokes shift.