Comparative study of Drinking Water Quality Parameters of three Manmade Reservoirs i.e. Kolar, Kaliasote and Kerwa Dam

A physico-chemical study of the Kerwa dam, Kolar dam and Kaliasote dam of Bhopal has been carried out to examine the suitability of surface water for drinking purposes. Water Samples were collected from two sampling stations of each dam and analyzed (APHA, AWWA, WEF, 1998) for the physico–chemical parameters such as temperature, pH, electrical conductivity, total hardness, calcium hardness, magnesium hardness, sulphate, fluoride and chemical oxygen demand (COD) to know the present status of the water bodies. The concentrations of investigated parameters in the water samples were within the permissible limits of the World Health Organization drinking water quality guidelines except for the values of COD and total hardness. The value of COD was found in the range of 18 mg/ l to 30 mg/l which was much higher than the maximum permissible limits as prescribed by WHO standards (1993). The value of total hardness ranges from 118 mg/l to 170 mg/l which is also above the permissible limit as prescribed by WHO standards.


INTRODUCTION
The Kerwa, Kolar and Kaliasote dam are the three main dams of Bhopal city as they are used for various activities like drinking, irrigation, recreational etc. Kolar dam (latitude 22° 57' 37" and longitude 77° 20' 24") is a major masonry dam which is located about 32 km from Bhopal near Lawakhedi village in Sehore District.It is constructed across the Kolar River near Birpur, a tributary of Narmada.The dam is about 45 m high.This reservoir has a catchment area of 508 km2.The gross storage capacity is 270 M cum and live storage capacity is 265 M cum Kaliasote dam (latitude 25° 11' 45' N and longitude 77° 24' E) was constructed near village Chuna Bhatti across the river Kaliasote, a tributary of Betwa River in Huzur Tehsil of Bhopal District.The Kaliasote dam is 1080 m long.Its height is 34.25 m and has gross storage capacity of 35.387 M cum.The Dam is used for irrigation and recreational purposes.Kerwa dam is situated in the subtropical region of the Bhopal District.Kerwa Dam was constructed on Kerwa River near Bhopal city.This reservoir has a catchment area of 34.50 km 2 and its gross storage capacity is 25 M cum.The water of this dam is used for multipurpose activities like drinking, irrigation, fish culture etc. Continuous expansion of Bhopal city in terms of area and population has negative impacts on these dams.These dams are loosing their beauty and identity because of pollution and encroachment.

MATERIAL AND METHODS
For the present investigations the Kerwa dam, Kolar dam and Kaliasote dam of Bhopal (M.P) were selected.Two sampling stations were chosen from each dam and surface water samples were collected from all the six sampling stations (namely S1, S2, T1, T2 and U1, U2) in the month of June 2010.The sampling station S1, T1 and U1 belongs to coastal region where as S2, T2 and U2 belongs to centre region of water bodies.Each water sample was analyzed for nine parameters such as temperature, pH, electrical conductivity, total hardness, calcium hardness, magnesium hardness, sulphate, fluoride and chemical oxygen demand by standard methods prescribed by APHA, AWWA, WEF (1998) and NEERI (1991).

RESULTS AND DISCUSSIONS
The data revealed that there were considerable variations in the examined samples.The results of analysis of various physico-chemical parameters of water of Kerwa dam, Kolar dam and Kaliasote dam was summarized in table 1.A comparison of physico-chemical characteristics of the studied water samples has also been made with WHO standards (1993) and BIS standards (1991).These parameters are discussed below:

Temperature
Temperature was in the range of 25.2 o C to 32 o .Temperature is one of the most important factors in aquatic environment (Singh et al, 2005).Temperature also affects solubility of oxygen in water.Solubility of oxygen in water increases with decreasing temperature (Joshi et al, 2001).Water temperatures fluctuate naturally both daily and seasonally.Aquatic organisms often have narrow temperature tolerances.Thus, although water bodies have the ability to buffer against atmospheric temperature extremes, even moderate changes in water temperatures can have serious impacts on aquatic life, including bacteria, algae, invertebrates and fish.

Hydrogen Ion concentration (pH)
pH indicates the intensity of acidic or basic character at a given temperature.Measurement of pH is one of the most important and most frequently used tests in determining water quality.Every phase of water treatment and water supply like acid-base neutralization, water softening, precipitation, coagulation, disinfection, corrosion control etc is pH dependent.The pH of the water samples were found in the range of 7.40 to 8.20 i.e. slightly alkaline.The maximum value of pH was recorded at sampling station U2 of Kaliasote dam which is 8.20 and the minimum value of pH was recorded at sampling station T1 of Kolar dam which is 7.40.The maximum permissible limit of pH as prescribed by WHO is 7.0 to 8.50.All the reservoirs have pH values within the desirable and suitable range.

Electrical Conductivity
It is a measure of the ability of an aqueous solution to carry an electric current.It depends on the presence of ions, on their total concentration, mobility and temperature of measurement.Higher value of conductivity shows higher concentration of dissolved ions.Conductivity of water sample was found in the range of 222-385 micromhos per cm 2 , which is much below the WHO standards.Electrical conductivity is considered to be a rapid and good measure of dissolved solids.Conductivity is an important criterion in determining the suitability of water for irrigation.The maximum value of electrical conductivity (385 mg/l) was found at U2 sampling station of Kaliasote dam followed by U1 sampling station of same dam.The high value of conductivity was due to presence of dissolved salts.The least value (222 mg/l) was recorded at S1 sampling station of Kerwa dam.The value of electrical conductivity follows the order Kerwa dam < Kolar dam < Kaliasote dam.

Total hardness
The hardness of water is not pollution parameter but indicates water quality mainly in terms of Ca 2+ and Mg 2+ expressed as CaCO 3 (De, A.K, 2006).The total hardness was found to be in the range of 118 mg/l to 170 mg/l.It was found to be 170 mg/l at S2 sampling station of Kerwa dam followed by T2 sampling station of Kolar dam.The least value (118 mg/l) was recorded for S1 sampling station of Kerwa dam.Thus the lowest and highest values of total hardness were observed at Kerwa dam.It is much higher than the permissible limit as prescribed by WHO but well within the permissible limits as prescribed by BIS standards.The total

Calcium hardness
The main sources of calcium in natural water are various types of rocks, industrial waste and sewage.There is evidence that hard water plays a role in heart diseases (Sastry et al 1998).Its value was found in the range of 60 mg/l to 112 mg/ l which is slightly higher than the permissible limit as prescribed by WHO but well within the permissible limits as prescribed by BIS standards.T2 sampling station of Kolar dam has highest value of calcium hardness i.e. 112 mg/l followed by S2 sampling station of Kerwa dam.The minimum value (60 mg/l) of calcium hardness was observed at S1 sampling station of Kerwa dam.

Magnesium hardness
Its value was found in the range of 30 mg/ l to 70 mg/l.Its value is slightly higher than the permissible limits as prescribed by WHO but well within the permissible limits as prescribed by BIS standards.The maximum value of magnesium hardness (70 mg/l) was found at S2 sampling station of Kerwa dam.The high value of magnesium hardness was due to human settlement around the dam.The least value (30 mg/l) was recorded at T1 sampling station of Kolar dam.Higher concentration of magnesium makes the water unpalatable and act as laxative to human beings.

Fig. 1 :
Fig. 1: Comparision of various physico-chemical parameters of Kerwa dam, Kolar dam and Kaliasote dam with WHO standards and BIS standards