HPTLC Analysis of Solanum xanthocarpum Schrad. and Wendl., a Siddha Medicinal Herb

In the present study, HPTLC is used to detect the presence and amount of triterpenoids and phytosterols in different plant parts (fruit, stem, leaf, and root) of Solanum xanthocarpum Schrad. and Wendl.; such analysis is done for the first time. Each plant part has its own medicinal value and is used as Siddha medicinal herb. The employed statistical analysis ensures that the developed method is reproducible and selective. The results show that the fruit samples contain highest amount of tested phytochemicals. This method can be used as an important tool to ensure the therapeutic dose in herbal formulations, standardization, and quality control of bulk drugs.


Introduction
Solanum xanthocarpum Schrad. and Wendl., commonly known as Kantkari, belongs to family Solanaceae. It comprises 90 genera and 2000-3000 species. It is distributed to plains and lower hills of India. It is an herbaceous spiny perennial herb with prominent nodes and internodes. Roots are almost cylindrical and tapering. Flowers are purple colored and few flower axillary cymes with glabrous, globular berry are green when young and turn yellow at maturity. e seeds are smooth, compressed, and reniform with bitter taste. It is known for its traditional medical value, and recent scientific studies have emphasized the possible use of this plant in the modern medicine system. India is rich with its biodiversity and knowledge of rich ancient traditional systems of medicine like Ayurveda, Siddha, Unani, Amchi, and local health traditions [1]. Wild plants serve as an indispensable constituent of the human diet. ey supply with minerals, vitamins, protein, and certain hormone precursors [2][3][4]. Roots, stem, leaves, flowers, and fruits are useful parts of this herb as siddha medicinal herb [5]. However, there is need to study the inexpensive nutritive value of these wild plants so that these can be exploited for their pharmaceutical preparations.

Experimental
At present triterpenoids and phytosterols are separated from methanolic extracts in different plant parts (fruit, stem, leaf, and root) in S. xanthocarpum by using high-performance thin layer chromatography (HPTLC). Details of qualification and quantification of different mobile phases used are mentioned in Table 1. Part-based separation of bioactive compounds from the wild samples is done first.

Plant Material.
Plant samples were collected from different localities of Indian ar desert, Rajasthan. e specimens were collected and deposited in the herbarium of Punjabi University, Patiala, with accession numbers 59194 and 59931. e plants parts, i.e., fruit, leaf, stem, and root samples, were separated washed and dried at room temperature (25°C-30°C).

Stock Solution.
All the organic solvents as well standards of analytical grade used in the present study were purchased from Merck (Darmstadt, Germany). Solutions of standards were prepared by using 1 : 1 methanol.

Apparatus.
For the acquisition, a Camag HPTLC system comprising a Linomat-V automatic sample applicator and Camag TLC scanner III with win CATS 4 software for interpretation of data was used. A Camag 100 µL precision syringe from Hamilton, Bonaduz, Switzerland, was used for sample application under gentle stream of nitrogen. Camag aluminum precoated silica gel 60-F254 plates with 200 µm thickness × 5 µm particle size from Merck (Darmstadt, Germany) was used. For the plate development, a Camag twin-trough chamber 20 cm W × 10 cm H was used.

Chromatography.
Chromatographic studies were performed using the following conditions: HPTLC was carried out using aluminum plates precoated with silica gel 60F 254 . Combinations of different mobile phases were used to quantify different standards ( Table 1); volume of mobile phase was kept up to 20 mL; chamber saturation time: 30 min; temperature: 25 + 18°C; relative humidity: 35%-40%; migration distance: 80 mm; migration time: 30 min; wavelength of detection (Table 1); scanning speed: 20 mm/s; data resolution: 100 mm/step; and band width: 4mm. A Camag video documentation system was used for imaging and archiving the thin layer chromatograms. e object was captured by means of a highly sensitive digital camera. Image acquisition processing and archiving were controlled via Win CATS software.

Preparation of Derivative Reagent.
Anisaldehyde sulphuric acid was prepared by dissolving 5 mL of p-anisaldehyde solution in 1 ml of 98% sulphuric acid and 50 ml of acetic acid. After development and derivatization of the plate, measurements were made by winCATS software. Concentration of the target analytes in the separated bands was determined from the intensity of the reflected light indicated and the peak areas produced were correlated to the analyte concentrations using six-level linear calibration curves.
2.6. Chromatographic Separation. Each extract of 5 µL S. xanthocarpum solution was spotted on the HPTLC silica gel plate, 4 mm band length, using a Camag ATS4 automatic TLC sampler spotting device. e TLC plate was developed in the ascending mode in a twin-trough chamber presaturated for 30 mins with particular mobile phase. Linear ascending plate development was performed until a migration of distance 8 cm from the origin was reached.
e plate was removed from the chamber, air dried, derivation with p-ansaldehyde sulphuric acid, heated, and scanned in the absorbance/reflectance mode of a Camag TLC scanner 3 (Figures 1-7). Peak area data were recorded using Camag Win CATS software.

Calibration Curve.
A standard solution volume of 2-10 µL of all the analyzed sugars was used. Concentration of the target analysts in the separated bands were determined from the intensity of the reflected light indicated, and the produced peak areas were correlated to the analyst concentrations using six-level linear calibration curves. e employed statistical analysis ensures that the developed method is reproducible and selective. is method can be used as an important tool to ensure the therapeutic dose in herbal formulations, standardization, and quality control of bulk drugs.

Validation of HPTLC Densitometry
Method Specificity 3.1. Specificity. e specificity of the method was ascertained by analyzing standard compounds and samples. e spots for standards in samples were confirmed by comparing the Rf and spectra of the spots with that of the standards. e peak purity of all standards were assessed by comparing the spectra at three different levels, i.e., peak start, peak apex, and peak end positions of the spot.

Precision.
To define deviations due to the instrument, six different samples of the same were spotted on HPTLC silica gel plates and analyzed to determine variations arising due to method itself (Table 1).

Recovery.
e recovery of the method was determined at two levels, i.e., 50% and 100%, by adding a known amount of particular standard to the extracts of plant part, and the mixtures were analyzed by the proposed method. e ruggedness of the proposed method was studied using reagents from different lots and different manufacturers.

Limit of Detection and Limit of Quantitation.
e limit of detection (LOD) and limit of quantitation (LOQ) were determined, and data pertaining to LOD, LOQ, interday,   and intraday precision are given in Table 1. e significant difference between the amounts of particular compound in each plant is also mentioned in Table 3.

Sample Preparation.
Plant parts like fruit, leaf, stem, and root of the plants were extracted with methanol by using the Soxhlet apparatus. e plant material was shade-dried and   coarsely powdered before Soxhlet apparatus application. 10 g of each dried and powdered aerial plant parts was applied to the methanolic extraction independently in the Soxhlet apparatus. e extracts were concentrated using a rota-evaporator and then lyophilized. Powdered extracts was weighed, and 5 mg of each was dissolved in 5 mL of methanol to obtain 1 mg/1 mL concentration.

Results
Plant samples were collected from different localities of Indian ar desert, Rajasthan. Present studies reveal unequal concentration of bioactive compounds in different plant parts. is phenomenon is very common in many secondary metabolities [6,7]. Different solvents are examined for the separation of these bioactive compounds, and the best combinations for separation are listed in Tables 1 and 2. Triterpenoids detected are lupeol, oleanolic acid, and ursolic acid. e fruit (6.81 ± 0.23 µg/mg DWE) and stem (6.179 ± 0.61 µg/mg DWE) samples of the plant are rich in lupeol content. It is completely absent in leaf samples and present in very less amount in root samples (Figure 1; Table 3). Roots are found to be quite rich in oleanolic acid (24.67 ± 0.582 µg/mg DWE) and ursolic acid (8.48 ± 0.31 µg/mg DWE) followed by stem samples (6.39 ± 0.97 µg/mg DWE; 1.07 ± 0.19 µg/mg DWE), (Figures 2 and 3; Table 3). Among the triterpenoids, earlier oleanolic acid was isolated using paper, thin layer, and column chromatography [8]. ere is no earlier report of part-based isolation or separation of these triterpenoids by using HPTLC in wild samples of the plant.
Amount of β-sitosterol is reported to be high in stem samples of the plant (20.85 ± 0.96 µg/mg DWE) followed by the leaf samples (19.89 ± 1.53 µg/mg DWE) and root samples (8.04 ± 0.055 µg/mg DWE). e least amount of β-sitosterol was reported in fruits (6.42 ± 0.91 µg/mg DWE) of the plant (Figure 4). e root samples are quite rich in phytosterodial composition (28.19 ± 0.01 µg/mg DW) of campesterol and ergosterol (24.27 ± 0.28 µg/mg DW; Figures 5 and 6). Withaferin A and withanolide A and B were also tested for their presence. But only withanolide B was present. Withanolide B is also separated along with other bioactive compounds (Tables 1 and 2). It is present only in the fruit (17.59 ± 0.12 µg/mg DWE) and the root samples (10.09 ± 0.14 µg/mg DWE) of the plant (Figure 7). Phytosterols are the most important constituents which increases the medicinal value of the plant. Earlier, there was no report of determination of different bioactive compounds from the plant by using HPTLC. At present, the methanolic extract of the plant are used to separate different bioactive compounds (Tables 1 and 2). e plant is reported to be very rich in phytosteroidal content (Table 3).
Among triterpinoids, earliar oleanolic acid was isolated using paper, thin layer, and column chromatography [9], and lupeol was reported in fruits in tissue cultures of solanum xanthocarpum [10]. Phytosterols are the most important constituents which increases its medicinal value of  the plant. Heble et al. [11] reported the presence of β-sitosterol through tissue culture techniques. e plant was estimated for its fatty acids content in [12].

Discussion
A simple, rapid, reliable method is developed and validated for the qualitative and quantitative determination of different phytochemicals in plant matrices. A significant difference was obtained among the different plant parts. e highest amount of most of the compounds was noted in fruit samples of the plant. e results clearly show that the fruits are the very supplier of different phytochemicals mainly phytosterols and should be explored more in the production of medicinal drugs in pharmaceutical companies.

Data Availability
e data used to support the findings of this study are available from the corresponding author upon request.

Conflicts of Interest
e authors declare that they have no conflicts of interest.