Abstract
Full wave profiles are used to determine the Hugoniot elastic limit and the spall strength of armco iron samples with an as-received structure and the samples recovered after preliminary loading by plane shock waves with an amplitude of 8, 17, and 35 GPa. The measurements are performed at a shock compression pressure below and above the polymorphic a–e transition pressure. Metallographic analysis of the structure of armco iron shows that a developed twinned structure forms inside grains in the samples subjected to preliminary compression and recovered and that the twin concentration and size increase with the shock compression pressure. The spall strength of armco iron under shock loading below the phase transition pressure increases by approximately 10% due to its preliminary deformation twinning at the maximum shock compression pressure. The spallation of samples with various structures at a shock compression pressure above the phase transition proceeds at almost the same tensile stresses. The polymorphic transition in armco iron weakly affects its strength characteristics.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Shock Waves and High-Strain-Rate Phenomena in Metals, Ed. by M. A. Meyers and L. E. Murr (Plenum, New York, 1981).
L. M. Barker and R. E. Hollenbach, J. Appl. Phys. 45, 4872 (1974).
N. V. Kharitonov, G. V. Stepanov, and A. Ya. Krasovskii, Probl. Prochn., No. 9, 52 (1974).
S. E. Atroshchenko, I. O. Pashkov, and I. M. Ryadinskaya, Fiz. Met. Metalloved. 19, 797 (1965).
S. E. Atroshchenko, I. O. Pashkov, and I. M. Ryadinskaya, Fiz. Met. Metalloved. 19, 923 (1965).
E. A. Kozlov, I. V. Telichko, D. M. Gorbachev, D. G. Pankratov, A. V. Dobromyslov, and N. I. Taluts, Fiz. Met. Metalloved. 99 (3), 83 (2005).
A. V. Dobromyslov, E. A. Kozlov, and N. I. Taluts, Fiz. Met. Metalloved. 106, 548 (2008).
G. I. Kanel’, S. V. Razorenov, A. V. Utkin, and V. E. Fortov, Shock-Wave Phenomena in Condensed Media (Yanus-K, Moscow, 1996).
L. M. Barker and R. E. Hollenbach, J. Appl. Phys. 43, 4669 (1972).
S. V. Razorenov, G. I. Kanel, A. S. Savinykh, and V. E. Fortov, “Large tensions and strength of iron in different structure states,” in Shock Compression of Condensed Matter-2005, Ed. by M. D. Furnish, M. Elert, T. P. Russell, and C. T. White, (AIP, Melville, New York, 2006); AIP Conf. Proc. 845, 650 (2006).
G. V. Garkushin, O. N. Ignatova, G. I. Kanel’, L. Meier, and S. V. Razorenov, Mekh. Tverd. Tela, No. 4, 155 (2010).
G. V. Garkushin, S. V. Razorenov, G. I. Kanel’, V. A. Skripnyak, V. A. Kraskoveikin, and A. A. Kozulin, Phys. Solid State 57, 337 (2015).
R. Z. Valiev and I. V. Alexandrov, Nanostructured Materials Produced by Severe Plastic Deformation (Logos, Moscow, 2000).
G. I. Kanel’, Prikl. Mekh. Tekh. Fiz. 42, 194 (2001).
G. I. Kanel’, S. V. Razorenov, and V. E. Fortov, Mekh. Tverd. Tela, No. 4, 86 (2005).
G. I. Kanel’, S. V. Razorenov, A. S. Savinykh, E. B. Zaretskii, and Yu. R. Kolobov, “Study of structural levels determining resistance to fast deformation and fracture of metals and alloys,” RF Preprint No. 1-478, OIVT RAN (Joint Institute of High Temperature, Moscow, 2004).
G. V. Garkushin, S. V. Razorenov, and O. N. Ignatova, Deform. Razrush. Mater., No. 4, 38 (2008).
V. A. Ogorodnikov, A. G. Ivanov, and E. S. Tyun’kin, Fiz. Goreniya Vzryva, No. 1, 94 (1992).
G. V. Garkushin and S. V. Razorenov, Tech. Phys. 60, 1021 (2015).
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © G.V. Garkushin, N.S. Naumova, S.A. Atroshenko, S.V. Razorenov, 2016, published in Zhurnal Tekhnicheskoi Fiziki, 2016, Vol. 61, No. 1, pp. 86–92.
Rights and permissions
About this article
Cite this article
Garkushin, G.V., Naumova, N.S., Atroshenko, S.A. et al. Influence of the reversible α–ε phase transition and preliminary shock compression on the spall strength of armco iron. Tech. Phys. 61, 84–90 (2016). https://doi.org/10.1134/S1063784216010102
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S1063784216010102