|
As process technologies move from planar transistor to 3D transistor like FinFet and multi-gate, it is important to accurately predict topography in FEOL CMP processes. These incoming topographies when stacked up can have huge impact in BEOL copper processes, where copper pooling becomes catastrophic yield loss. A calibration methodology to characterize STI CMP step is developed as shown in Figure 1; moreover, this STI CMP model is validated from silicon data collected from product chips not used in calibration stage. Additionally, wafer experimental setup and metrology plan are instrumental to an accurate model with high predictive power. After a model is generated, spec limits and threshold to establish hotspots criteria can be defined. Such definition requires working closely with foundry process engineering and integration team and reviewing past failure analysis (FA) to come up a reasonable metrics. Conventionally, a potential STI weak point can be found when nitride residues remains in the active region after nitride strip. Another source of STI hotspots occurs when nitride erosion is too much, and active region can suffer severe damage. |
ACCESS THE FULL ARTICLE
No SPIE Account? Create one
CITATIONS
Cited by 1 scholarly publication.
Chemical mechanical planarization
Calibration
Oxides
Data modeling
Polishing
Back end of line
Front end of line
