Paper
13 May 1994 Total evaluation of W-Ti absorber for x-ray mask
Kenji Marumoto, Hideki Yabe, Sunao Aya, Koji Kise, Yasuji Matsui
Author Affiliations +
Abstract
W-Ti film was comprehensively investigated for its application as an x-ray mask absorber. A stress-free and amorphous W-Ti film was successfully deposited by dc sputtering with a W-Ti (1 wt%) target using a gas mixture of Ar and N2. To obtain much lower stress, we firstly improve the accuracy of stress measurement up to +/- 1 MPa, and ultra-low stress film was obtained by step-annealing. The stress of the film has been found stable enough to apply to x- ray masks in an air atmosphere and for x-ray exposure. The density, composition, and microstructure of the film were also evaluated by SEM, XD, XPS, and TDS. The film surface was very smooth and the roughness measured by AFM was about 2 nm. The etching properties of the absorber using a Cr mask, ITO stopper and electron cyclotron resonance (ECR) discharge plasmas were also investigated in order to achieve a resolution of below 0.1 micrometers . Highly selective and anisotropic etching has been realized using a mixture of SF6 and CHF3, by cooling the stage to about -50 degree(s)C under controlled plasma conditions. Moreover, the microfabrication of a smooth W-Ti absorber has been demonstrated for lines and spaces patterns of 0.06 micrometers and for 1-Gbit-class dynamic random access memory patterns.
© (1994) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kenji Marumoto, Hideki Yabe, Sunao Aya, Koji Kise, and Yasuji Matsui "Total evaluation of W-Ti absorber for x-ray mask", Proc. SPIE 2194, Electron-Beam, X-Ray, and Ion-Beam Submicrometer Lithographies for Manufacturing IV, (13 May 1994); https://doi.org/10.1117/12.175808
Lens.org Logo
CITATIONS
Cited by 9 scholarly publications and 2 patents.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Etching

Photomasks

Semiconducting wafers

Annealing

X-rays

Sputter deposition

Chromium

RELATED CONTENT

Utilize AIMS simulation to estimate profile side-wall angle
Proceedings of SPIE (October 20 2006)
EUVL square mask patterning with TaN absorber
Proceedings of SPIE (December 27 2002)
Practical LEEPL masks for sub-65-nm node
Proceedings of SPIE (December 06 2004)
Characteristics of Ta4B/SiC x-ray mask blanks
Proceedings of SPIE (July 24 1996)

Back to Top