Paper • The following article is Open access

Parameter optimisation and failure load prediction of resistance spot welding of aluminium alloy 57547

, , and

Published under licence by IOP Publishing Ltd
, , Citation A Duric et al 2019 IOP Conf. Ser.: Mater. Sci. Eng. 659 012042 DOI 10.1088/1757-899X/659/1/012042

Download Article PDF

Article metrics

127 Total downloads

Share this article

Author e-mails

aleksija.djuric@ues.rs.ba

Author affiliations

1 University of East Sarajevo, Faculty of Mechanical Engineering, Vuka Karadžoća 30, 71123 East Sarajevo, RS, B&H

2 University of Ljubljana, Faculty of Mechanical Engineering, Aškerčeva cesta 6, 1000 Ljubljana, Slovenia

3 University of Niš, Faculty of Mechanical Engineering, Aleksandra Medvedeva 14, 18106 Niš, Serbia

Buy this article in print

Journal RSS
Sign up for new issue notifications
1757-899X/659/1/012042

Abstract

This paper will also present single objective optimization and Failure load prediction of Resistance spot welding of Aluminium alloy 57547. The experimental studies were conducted under varying welding currents I, electrode forces F, welding times T, pred preheating currents IA. The settings of welding parameters were determined by using the Taguchi experimental design of L9 Orthogonal array method. For optimization and prediction will be used analysis of Signal-to-Noise (S/N) ratio and Response surface modelling RSM.

Export citation and abstract BibTeX RIS

Previous article in issue
Next article in issue

Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI.

Please wait… references are loading.
10.1088/1757-899X/659/1/012042