Issue 35, 2021

Gel-polymer electrolytes based on polyurethane ionomers for lithium power sources

Abstract

Polyurethanes based on the aminoethers of ortho-phosphoric acid and polyisocyanates of an aliphatic nature were studied as a substrate for the preparation of new polymer electrolyte. The conductivity of polyurethane ionomer samples obtained using the optimal amount of aliphatic polyisocyanates and after keeping them in a 1 M LiBF4 solution in γ-butyrolactone reaches 0.62 mS cm−1. It has been established that the transport of positively charged ions through the polymer matrix is due to the formation of clusters of phosphate ions and their association into the conducting channels. The introduction of carboxylate ions into the conducting channels by modifying the aminoethers of ortho-phosphoric acid with phthalic anhydride leads to an increase in their size and rise in the mobility of cations. As a result, the conductivity of polyurethane gel electrolytes increased to 2.1 mS cm−1.

Graphical abstract: Gel-polymer electrolytes based on polyurethane ionomers for lithium power sources

Article information

Article type
Paper
Submitted
17 Feb 2021
Accepted
08 Jun 2021
First published
17 Jun 2021
This article is Open Access
Creative Commons BY-NC license

RSC Adv., 2021,11, 21548-21559

Gel-polymer electrolytes based on polyurethane ionomers for lithium power sources

I. M. Davletbaeva, A. A. Nizamov, A. V. Yudina, G. R. Baymuratova, O. V. Yarmolenko, O. O. Sazonov and R. S. Davletbaev, RSC Adv., 2021, 11, 21548 DOI: 10.1039/D1RA01312B

This article is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported Licence. You can use material from this article in other publications, without requesting further permission from the RSC, provided that the correct acknowledgement is given and it is not used for commercial purposes.

To request permission to reproduce material from this article in a commercial publication, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party commercial publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements