Issue 42, 2017

Strain induced atomic structure at the Ir-doped LaAlO3/SrTiO3 interface

Abstract

The structure of Ir-doped LaAlO3/SrTiO3(001) interfaces was investigated on the atomic scale using probe-corrected transmission electron microscopy in high-angle annular dark-field scanning mode (HAADF-STEM) and electron energy loss spectroscopy (EELS), combined with first-principles calculations. We report the evolution of the strain state experimentally measured in a 5 unit-cell thick LaAlO3 film as a function of the Ir concentration in the topmost SrTiO3 layer. It is shown that the LaAlO3 layers remain fully elastically strained up to 3% of Ir doping, whereas a higher doping level seems to promote strain relaxation through enhanced cationic interdiffusion. The observed differences between the energy loss near edge structure (ELNES) of Ti-L2,3 and O-K edges at non-doped and Ir-doped interfaces are consistent with the location of the Ir dopants at the interface, up to 3% of Ir doping. These findings, supported by the results of density functional theory (DFT) calculations, provide strong evidence that the effect of dopant concentrations on the properties of this kind of interface should not be analyzed without obtaining essential information from the fine structural and chemical analysis of the grown structures.

Graphical abstract: Strain induced atomic structure at the Ir-doped LaAlO3/SrTiO3 interface

Supplementary files

Article information

Article type
Paper
Submitted
30 Aug 2017
Accepted
30 Sep 2017
First published
02 Oct 2017

Phys. Chem. Chem. Phys., 2017,19, 28676-28683

Strain induced atomic structure at the Ir-doped LaAlO3/SrTiO3 interface

M. Lee, R. Arras, B. Warot-Fonrose, T. Hungria, M. Lippmaa, H. Daimon and M. J. Casanove, Phys. Chem. Chem. Phys., 2017, 19, 28676 DOI: 10.1039/C7CP05918C

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements