Abstract
Municipal solid wastes generated each year contain potentially useful and recyclable materials for composites. Simultaneously, interest is high for the use of natural fibers, such as flax (Linum usitatissimum L.), in composites thus providing cost and environmental benefits. To investigate the utility of these materials, composites containing flax fibers with recycled high density polyethylene (HDPE) were created and compared with similar products made with wood pulp, glass, and carbon fibers. Flax was either enzyme- or dew-retted to observe composite property differences between diverse levels of enzyme formulations and retting techniques. Coupling agents would strengthen binding between fibers and HDPE but in this study fibers were not modified in anyway to observe mechanical property differences between natural fiber composites. Composites with flax fibers from various retting methods, i.e., dew- vs. enzyme-retting, behaved differently; dew-retted fiber composites resulted in both lower strength and percent elongation. The lowest level of enzyme-retting and the most economical process produces composites that do not appear to differ from the highest level of enzyme-retting. Flax fibers improved the modulus of elasticity over wood pulp and HDPE alone and were less dense than glass or carbon fiber composites. Likely, differences in surface properties of the various flax fibers, while poorly defined and requiring further research, caused various interactions with the resin that influenced composite properties.
Similar content being viewed by others
REFERENCES
R.Myers (2000)Flax:A crop from America 's past with renewed interest,Jefferson Institute,601 West Nifong,Suite 1D, Columbia,MO 65203,pp.4 http://je.ersoninstitute.org/pubs/.ax.shtml
D.Oomah (2001)J.Sci.Agric. 81(9)889-894.
Anonymous (1995)Using straw as a farm heating fuel, Pamphlet 719,Prairie Agricultural Machinery Institute, Saskatchewan,Canada,pp.8 http://www.pami.ca/pdfs/ reports_research_updates/using_straw_as_a_farm_heating_ fue 1_719.pdf
B.Smeder and S.Liljedahl (1996)Indust.Crops Products.5 (2) 149-162.
DaimlerChrysler (2001)Natural fibers replace glass fibers, Umwelt-Umweltbericht 2001 Environmental Report,pp.3 http://www.daimlerchrysler.com
Office of Solid Waste and Emergency Response (2002)Municipal solid waste in the United States:2000 facts and figures (Publication EPA530-R-02-001),(EPA FORM 5305W), pp.165 http://www.epa.gov/epaoswer/non-hw/muncpl/report-00/report-00.pdf
A.Bledzki, S.Reihmane,and J.Gassan (1996)J.of Appl. Polymer Sci.59,1329-1336.
M.Defosse (2003)Mod.Plast.80,25-29.http://www. modplas.com
G.Stephens (1997)A Manual for Fiber Flax Production,The Connecticut Agricultural Experiment Station,New Haven, CT.pp.18
B.Robinson and T.Hutcheson (1932)Adaptation of Fiber Flax to South Atlantic States,Circ.231,U.S.DA.,Washington,DC,pp.1-21
Anonymous (1992)Growing Flax,The Flax Council of Canada,Winnipeg,Manitoba.pp.28
J.Foulk, D.Akin,and R.Dodd (2000)New low cost.ax bers for composites.In Proc Soc.Automo.Eng.Int.Congr.& Exp.,SAE Tech.Paper 2000-01-1133,Warrendale,PA,pp.11
J. Frederick (2000)unpublished data.
C.Loadholt (1965)The Influence of Nitrogen,Phosphorus, Potassium and Micronutrients on the Yield and Quality of Fiber Flax on Two South Carolina Coastal Plain Soils.M.S.thesis, Clemson University,Clemson,SC,USA,pp.100
C.Parks, J.Frederick, P.Porter,and E.Murdock (1993)Growing Flax in South Carolina,Clemson University,Cooperative Ext.Service,Clemson,SC.pp.16
J.Foulk, D.Akin,and R.Dodd (2003)Crop Management doi:10.1094/CM-2003-0124-01-RS,6 pp.http://www. plantmanagementnetwork.org
D.Akin, J.Foulk, R.Dodd,and D.McAlister (2001) J.Biotechnol.89,193-203.
C.Pattanakul, S.Selke, C.Lai,and J.Miltz (1990)J.Applied Polymer Sci. 43,2147-2150.
D.Akin, J.Foulk,and R.Dodd (2002)Textile Res.J.72(6) 510-514.
ASTM Standards D-638-00 (2001)Standard Test Method for Tensile Properties of Plastics,American Society for Testing and Materials,Philadelphia,PA.pp.44-56.
ASTM Standards D-1622-93 (1994)Standard Test Method for Apparent Density of Rigid Cellular Plastics,American Society for Testing and Materials,Philadelphia,PA.pp.369-371.
ASTM Standards D-570-98 (1999)Standard Test Method For Water Absorption of Plastics,American Society for Testing and Materials,Philadelphia,PA.pp.31-33.
V.Tserki, P.Matzinos,and C.Panayiotou (2003)Applied Polymer Sci.88(7)1825-1835.
D.Akin, D.Himmelsbach,and H.Morrison (2000)J.Polymers Environment 8 (3)103-109.
J.Evans, D.Akin, W.Morrison, D.Himmelsbach,and J.Foulk (2002)Textile Res.J.72 (7),579-585.
N.Cheremisinio.(1997)Handbook of Engineering Polymeric Materials,Marcel Dekker Inc., New York,888 pp.
MatWeb.com (2003)The Online Materials Database Overview, High density polyethylene (HDPE),1 pp.http://www. matweb.com
L.Groom, L.Mott,and S.Shaler (2002)Wood Fiber Sci.34 (1),14-27.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Foulk, J.A., Chao, W.Y., Akin, D.E. et al. Enzyme-Retted Flax Fiber and Recycled Polyethylene Composites. Journal of Polymers and the Environment 12, 165–171 (2004). https://doi.org/10.1023/B:JOOE.0000038548.73494.59
Issue Date:
DOI: https://doi.org/10.1023/B:JOOE.0000038548.73494.59