Skip to main content
SpringerLink
Log in

Cargo Pendulation Reduction of Ship-Mounted Cranes

  • Published:
Nonlinear Dynamics Aims and scope Submit manuscript

Abstract

Ship-mounted cranes are used to transfer cargo from large container ships to smaller lighters when deep-water ports are not available. The wave-induced motion of the crane ship can produce large pendulations of the cargo being hoisted and cause operations to be suspended. In this work, we show that it is possible to reduce these pendulations significantly by controlling the slew and luff angles of the boom. Such a control can be achieved with the heavy equipment that is already part of the crane so that retrofitting existing cranes would require a small effort. Moreover, the control is superimposed on the commands of the operator transparently. The successful control strategy is based on delayed feedback of the angles of the cargo-hoisting cable in and out of the plane of the boom and crane tower. Its effectiveness is demonstrated in a fully nonlinear three-dimensional computer simulation and in an experiment with a 1/24th-scale model of a T-ACS (The Auxiliary Crane Ship) crane mounted on a platform moving with three degrees of freedom. The results demonstrate that the pendulations can be significantly reduced, and therefore the range of sea conditions in which cargo-transfer operations can take place can be greatly expanded.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Vaughers, T., ‘Joint logistics over the shore operations’, Naval Engineers Journal 106(3), 1994, 256–263.

    Google Scholar 

  2. Vaughers, T. and Mardiros, M., ‘Joint logistics over the shore operation in rough seas’, Naval Engineers Journal, May 1997, 385–393.

  3. Parker, G., Petterson, B., Dohrmann, C., and Robinett, R., ‘Command shaping for residual vibration free crane maneuvers’, in Proceedings of the American Control Conference, 1995, pp. 934–938.

  4. Golafshani, A. and Aplevich, J., ‘Computation of time-optimal trajectories for tower cranes’, in Proceedings of the IEEE Conference on Control Applications, IEEE, New York, 1995, pp. 1134–1139.

    Google Scholar 

  5. Sakawa, Y. and Nakazumi, A., ‘Modeling and control of a rotary crane’, ASME Journal of Dynamic Systems, Measurement, and Control 107 1985, 200–206.

    Google Scholar 

  6. Parker, G., Groom, K., Hurtado, J., Feddema, J., Robinett, R., and Leban, F., ‘Experimental verification of a command shaping boom crane control system’, in Proceedings of the American Control Conference, 1999, pp. 86–90.

  7. Parker, G., Robinett, R., Driessen, B., and Dohrmann, C., ‘Operator-in-the-loop control of rotary crane’, in Proceedings of the SPIE Conference, Vol. 2721, 1996, pp. 364–372.

    Google Scholar 

  8. Lewis, D., Parker, G. G., Driessen, B., and Robinett, R. D., ‘Command shaping control of an operator-in-the-loop boom crane’, in Proceedings of the American Control Conference, 1998, pp. 2643–2647.

  9. Gustafsson, T., ‘Modelling and control of a rotary crane’, in Proceedings of the 3rd European Control Conference, 1995, pp. 3805–3810.

  10. Burg, T., Dawson, D., Rahn, C., and Rhodes, W., ‘Nonlinear control of an overhead crane via the saturating control approach of teel’, in Proceedings of the 1996 IEEE International Conference on Robotics and Automation, IEEE, New York, 1996, pp. 3155–3160.

    Google Scholar 

  11. Imazeki, M., Mutaguchi, M., Iwasaki, I., and Tanida, K., ‘Active mass damper for stabilizing the load suspended on a floating crane’, IHI Engineering Review 31(2), 1998, 61–69.

    Google Scholar 

  12. Patel, M., Brown, D., and Witz, J., ‘Operability analysis for a monohull crane vessel’, Transactions of the Royal Institute of Naval Architects 129, 1987, 103–113.

    Google Scholar 

  13. McCormick, F. and Witz, J., ‘An investigation into the parametric excitation of suspended loads during crane vessel operations’, Underwater Technology 19, 1993, 30–39.

    Google Scholar 

  14. Witz, J., ‘Parametric excitation of crane loads in moderate sea states’, Ocean Engineering 22, 1995, 411–420.

    Article  Google Scholar 

  15. Henry, R., Masoud, Z., Nayfeh, A., and Mook, D., ‘Cargo pendulation reduction on ship-mounted cranes via boom-luff angle actuation’, Journal of Vibration and Control 7, 2001, 1253–1264.

    Google Scholar 

  16. Todd, M. D., Vohra, S. T., and Leban, F., ‘Dynamical measurements of ship crane load pendulation’, in Oceans '97 MTS/IEEE Conference Proceedings, Vol. 2, 1997, pp. 1230–1236.

    Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Department of Engineering Science and Mechanics, Virginia Polytechnic Institute and State University, MC 0219, Blacksburg, VA, 24061, U.S.A.

    Z. N. Masoud, A. H. Nayfeh & D. T. Mook

Authors
  1. Z. N. Masoud
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. A. H. Nayfeh
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. D. T. Mook
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to A. H. Nayfeh.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Masoud, Z.N., Nayfeh, A.H. & Mook, D.T. Cargo Pendulation Reduction of Ship-Mounted Cranes. Nonlinear Dynamics 35, 299–311 (2004). https://doi.org/10.1023/B:NODY.0000027917.37103.bc

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1023/B:NODY.0000027917.37103.bc

Search

Navigation