Halide Abstraction-Mediated Synthesis of a Highly Twisted Amide

Highly strained [3.2.1] bicyclic twisted amide 2 and corresponding amidium 10 were synthesized for the first time through Ag(I)-mediated halide abstraction. After initial lactamization attempts failed, a second-generation strategy was devised to target amidium 10 via intramolecular alkylation. The 3,4-dihydroisoquinolone cyclization precursor was regioselectively prepared via a Rh(III)-catalyzed C–H activation/annulation reaction. After Ag(I)-assisted cyclization, the [3.2.1] bicyclic framework of amidium 10 was confirmed by X-ray crystallography and enabled full solution characterization of twisted amide 2.

A mides are normally robust and planar structures that resist hydrolysis due to stabilization through the n N −π* C�O resonance.−4 As a result of the reduced level of amide conjugation, twisted amides feature increased N-nucleophilicity and carbonyl electrophilicity and thus behave more like "amino ketones" than traditional planar amides.As demonstrated by a number of experimental and computational studies, amide distortion increases the reactivity of twisted amides, which can potentially lead to undesired side reactions during synthesis and isolation.Since Lukešfirst proposed the distorted amide bond in [2.2.1] and [2.2.2] bicyclic structures in 1938, 5 a variety of cyclization strategies have been developed to synthesize bicyclic twisted amides, including direct condensation reactions, 6−13 Schmidt−Aubeŕ eactions, 14−18 Diels−Alder reactions, 19−21 Heck reactions, 22−26 carbene insertion reactions, 27−30 and other methods. 1,31,32ecently, we have introduced a new class of living polymerization based on the ability of nucleophilic twisted amides to undergo alkylation/halide-rebound processes. 13,33hile it was found that remote electron-donating groups could increase both amide distortion and N-nucleophilicity in a benzo-fused [3.3.1]twisted amide system 1 (Figure 1A), interest was directed toward further enhancing the twisted amide reactivity via modifying geometric parameters.Instead of substitution, the [3.2.1] analogue of 2 was targeted, which removes one carbon atom in the bicyclic skeleton (Figure 1A).This modification leads to a more strained framework and a more twisted amide bond, as shown by Brown. 10,34To compare the degree of distortion of 1 and 2, the Winkler− Dunitz parameters of twist angle τ and N-pyramidalization χ N were calculated, leading to the additive Winkler−Dunitz parameter τ + χ N that accurately correlates to amide distortion. 35,36The computationally optimized ground state geometry revealed that the τ + χ N value (87.4°vs 118.0°) significantly increased as a result of this geometric modification (Figure 1A).However, synthesis and isolation of highly twisted amides have been challenging due to their propensity for hydrolysis or polymerization. 27,28−39 These examples of bridged highly twisted amides required the multistep synthesis of precursors and have regioselectivity issues in the key cyclization step.To produce twisted amide 2, two pathways were proposed after considering the different retrosynthetic disconnections (Figure 1C).Pathway a involves the formation of the amide bond from a pyrrole precursor, which follows the strategy developed for the less strained [3.3.1]twisted amide 1. 13 The second approach involves directly twisting a planar amide through an intramolecular alkylation strategy starting from a 3,4-dihydroisoquinolone precursor (pathway b). 38Herein, these two straightforward strategies are detailed for the synthesis of [3.2.1] bridged twisted amide 2.
Initial attempts to prepare twisted amide 2 through pathway a were investigated starting from commercially available pyrrolidinium salt 3. Upon treatment with cesium carbonate in acetonitrile at a concentration of 0.01 M at room temperature, clean conversion to a new product was observed by 1 H nuclear magnetic resonance (NMR) after 30 min.However, further examination of the reaction mixture by NMR and GC-MS suggested it was only free amine 4 (Scheme 1 and Figure S1).Heating the reaction mixture to 60 °C under these conditions led to cyclization to form twisted amide 2, as evidenced by NMR and GC-MS analyses.The use of 1,8diazabicyclo[5.4.0]undec-7-ene (DBU) as a base at a higher concentration of 3 (0.1 M) also produced 2 within 2 h at room temperature (Figure S2).The conversion to 2 was further supported by an in situ reaction with excess iodomethane.The isolation of halide-rebound ring-opening product 6 in 53% yield via intermediate methyl amidium 5 supports the generation of 2 from direct lactamization (Scheme 1).
Although the formation of twisted amide 2 was observed in solution, stirring the reaction mixture for extended periods of time eventually led to broadened peaks in the 1 H NMR spectrum, likely due to the oligomerization of 2 under the reaction conditions (Figure S2).The instability of 2 prevented the successful isolation of the pure twisted amide through column chromatography or filtration.Even rotary evaporation of the solution containing twisted amide 2 resulted in an insoluble residue, likely due to oligomerization and/or hydrolysis.This suggests that twisted amide 2 is persistent only in a moderately dilute solution due to intermolecular reactions.The oligomerization of a highly twisted amide has also been observed by Stoltz and co-workers during their attempt to neutralize the protonated [2.2.2] bicyclic 2quinoclidone. 15Given the unsuccessful isolation of twisted amide 2 with pathway a, synthetic pathway b was then examined.
To explore alkylation strategy b, a route to the bromide precursor, 4-(2-bromoethyl)-3,4-dihydroisoquinolone 7, was needed.−43 When linear α-olefins are used in this reaction, the regioselectivity of annulation is known to be low.Indeed, the reaction between O-pivaloyl benzohydroxamate and 4-bromo-1-butene using the [Cp*RhCl 2 ] 2 catalyst (Cp* = 1,2,3,4,5pentamethylcyclopentadienyl ligand) resulted in nearly equal amounts of 7 and 8 (Scheme 2).Gratifyingly, when the more sterically hindered Rh(III) catalyst 9 reported by Perekalin and co-workers was used in the reaction between O-Boc benzohydoxamate and 4-bromo-1-butene, the desired product 7 was obtained in 79% yield with complete regioselectivity (Scheme 2). 44Here, switching the protecting group from pivaloyl to Boc is essential for highly regioselective annulation.Notably, this synthesis of 7 could be readily scaled up to halfgram quantities, enabling subsequent tests of the cyclization step in strategy b.
With precursor 7 prepared, cyclization experiments were performed to produce [3.2.1] twisted amide 2. In a recent report on the total synthesis of gracilamine, a chlorinecontaining 3,4-dihydroisoquinolone intermediate was successfully converted into a [3.2.1] twisted amide. 38In that synthesis, deprotonation of the amide nitrogen by NaH induced the intramolecular substitution of alkyl chloride to generate the twisted amide.Unfortunately, when 7 was mixed with NaH, only broad NMR peaks were observed, indicating the formation of 2 followed by in situ oligomerization (Figure S3).
Due to the unsuccessful preparation of twisted amide 2 under basic conditions, focus was directed toward the synthesis and isolation of its conjugate acid, amidium 10 (Figure 2).As demonstrated by Stoltz, protonation of the nucleophilic nitrogen atom in highly strained twisted amides can enhance the stability of amide bonds under anhydrous conditions. 15A silver-assisted halide abstraction approach was proposed for the cyclization on the basis of the high affinity between the silver(I) cation and halides, which has been well-documented to promote the nucleophilic substitution of alkyl halides. 45he cyclization tests were then performed on a 50 mg scale.When bromide 7 was treated with AgBF 4 in acetonitrile at 80 The isolation of parent twisted amide 2 via deprotonation of 10 was attempted; however, both rapid column chromatography and filtration led to decomposition and insoluble products.Despite the failure to isolate 2, in situ neutralization of 10 in solution using the inorganic base Cs 2 CO 3 did not lead to oligomerization and enabled the solution characterization of pure 2 via NMR spectroscopy.Notably, the 1 H NMR spectrum of 2 was consistent with the spectrum obtained in pathway a during cyclization of 3 under basic conditions (Figure S4), further suggesting that both pathways can lead to the formation of twisted amide 2. In addition, the 13 C NMR spectrum of 2 clearly revealed a carbonyl chemical shift at 182 ppm that is downfield compared to the carbonyl shift of [3.3.1]analogue 1 (178 ppm), suggesting reduced amide resonance and enhanced distortion of amide 2 (Figure 2C).
In conclusion, the first synthesis of [3.2.1] bicyclic twisted amide 2 was reported via two distinct pathways.First, cyclization of pyrrolidinium salt 3 led to the formation of 2 in solution, as supported by the in situ reaction with MeI to form alkyl iodide 6.Further purification and isolation of 2, though, were unsuccessful due to its inherent reactivity.Through the use of a silver(I)-assisted cyclization, planar amide 7 could be coerced into cyclization to give stable amidium 10, which was successfully isolated and characterized through X-ray crystallography.The expeditious preparation of twisted amide precursors via a Rh(III)-mediated C−H activation/annulation chemistry in conjunction with straightforward silver(I)-promoted cyclization holds promise for accessing other challenging amide frameworks in the future.
■ EXPERIMENTAL SECTION General Information.All reactions were carried out under a nitrogen atmosphere with dry solvents using anhydrous conditions, unless otherwise stated.Dry, degassed tetrahydrofuran (THF), acetonitrile (CH 3 CN), and dichloromethane (DCM) were obtained from a JC Meyer solvent purification system.Anhydrous acetonitrile and diethyl ether used in the syntheses and crystal growth of amidiums 10 and 11 were purchased from Acros Organics.Pyrrolidinium hydrochloride 3 was purchased from Sigma-Aldrich.Unless otherwise stated, all other reagents were purchased at the highest commercial quality and used without further purification.Yields refer to chromatographically and spectroscopically ( 1 H NMR) homogeneous materials unless otherwise stated.Reactions were monitored by thin layer chromatography (TLC) carried out on 0.25 mm E. Merck silica gel plates (60F-254) using ultraviolet light as the visualizing agent and basic aqueous potassium permanganate (KMnO 4 ) and heat as the developing agents.Silica gel [60 Å, 40− 63 μm (230−400 mesh)] from Silicycle was used for flash column chromatography.NMR spectra were recorded on Bruker Avance 400 or 500 MHz instruments, calibrated using residual undeuterated solvent as an internal reference (CHCl 3 at 7.26 ppm for 1 H NMR and 77.16 ppm for 13 C NMR, CH 3 CN at 1.94 ppm for 1 H NMR and 1.32 ppm for 13 C NMR, and DMSO at 2.50 ppm for 1 H NMR and 39.52 ppm for 13 C NMR), and then analyzed by MestReNova.The following abbreviations (or combinations thereof) were used to explain the multiplicities: s, singlet; d, doublet; t, triplet; q, quartet; m, multiplet; br, broad.Mass spectra (MS) were recorded on a GC-MS instrument (Agilent Technologies 7890A GC system/5975C with Triple-Axis Detector).High-resolution mass spectra (HRMS) were recorded via ESI by using a Thermo IDX mass spectrometer or a Thermo Scientific QEHF mass spectrometer.Melting points were measured on a MEL-TEMP II Laboratory Devices instrument (uncorrected).
Synthesis and Characterization.In Situ Formation of 2 from 3 and Subsequent Synthesis of 6.Under N 2 , to a solution of pyrrolidinium salt 3 (24.2mg, 0.1 mmol, 1 equiv) in anhydrous acetonitrile (1 mL, 0.1 M for 3) in an 8 mL vial was added DBU (18.3 mg, 18 μL, 0.12 mmol, 1.2 equiv).The reaction mixture was stirred at room temperature for 2 h, and aliquots of the reaction mixture were taken for 1 H NMR and GC-MS analyses.The formation of twisted amide 2 was observed on the basis of 1 H NMR and GC-MS (m/z 173.1).

Scheme 1 .
Scheme 1. Cyclization of Pyrrolidinium 3 to Synthesize Twisted Amide 2 and Subsequent Formation of 6 via the Halide-Rebound Reaction
■ ASSOCIATED CONTENT