Elsevier

Minerals Engineering

Volume 9, Issue 7, July 1996, Pages 727-741
Minerals Engineering

Contact angle and surface analysis studies of sphalerite particles

https://doi.org/10.1016/0892-6875(96)00064-7Get rights and content

Abstract

Capillary penetration techniques were used to determine the wettability of sphalerite particles under flotation related conditions. Particle contact angles were determined separately from measurements of wetting rates (Washburn technique) and equilibrium capillary pressures across a sphalerite particle bed. For sphalerite of different size fractions, particle contact angles ranged from 75 to ∼90°, whereas synthetic ZnS (99.9%) gave values of 46° and 53°. The strong hydrophobic nature of the natural sphalerite samples was due to inadvertent copper activation and the ensuing formation of sulfur-rich surfaces, determined by bulk chemical and surface analysis (X-ray photoelectron spectroscopy and scanning Auger microscopy) studies. Scanning Auger microscopy also revealed variations in the levels of surface copper from mineral grain to grain and confirmed the heterogeneous chemical nature of sphalerite surfaces. The latter enables the contact angle variability to be discussed.

References (24)

  • C.A. Prestidge et al.

    The Interaction of Ethyl Xanthate with Copper (II) Activated Zinc Sulphide: Kinetic Effects

    Colloids and Surfaces

    (1994)
  • L.E. Davis et al.
  • Cited by (66)

    • Separation of plastic wastes using froth flotation – An overview

      2022, Advances in Colloid and Interface Science
    • Effective capillary pressure and permeability of a granular material during imbibition in a closed column

      2022, Colloids and Surfaces A: Physicochemical and Engineering Aspects
      Citation Excerpt :

      However, there are certain drawbacks to using the Washburn column method. In many cases, hydrostatic effects are neglected in the analysis, and only the initial stage of the capillary rise is considered [16–23]. Alternatively, a horizontal column can be used in the experiments [24].

    • Surface chemistry of oxidised pyrite during grinding: ToF-SIMS and XPS surface analysis

      2021, Minerals Engineering
      Citation Excerpt :

      The hydrophobicity of minerals is normally quantified by contact angle (CA) measurements. The contact angle of mineral particles is commonly measured by the Washburn technique (Subrahmanyam et al., 1996; Subrahmanyam et al., 1999). However, this technique only gives an average contact angle for the whole bed of particles and requires a minimum amount of specimen for a reliable measurement.

    • Capillary rise in a closed column: Application to the characterization of powders

      2020, Colloids and Surfaces A: Physicochemical and Engineering Aspects
    View all citing articles on Scopus
    View full text