The human exposure assessment workshop
Cluster analysis of electron microprobe analysis data of individual particles for source apportionment of air particulate matter

https://doi.org/10.1016/0004-6981(88)90141-2Get rights and content

Abstract

Resuspended soil particles were sampled in the vicinity of a zinc smelter and analyzed for 16 elements using automated electron microprobe X-ray analysis (EPMA) of the individual particles. The data sets containing the concentrations of the fine and coarse mode particles were interpreted using a combination of both hierarchical and nonhierarchical cluster analysis. The clusters were used as an initial training set in a nearest centroid sorting clustering over all receptor sites to gain insight in the spatial distribution of the clusters.

Several aspects of the method are discussed, such as the data processing, the optimization of the cluster algorithm, the analytical error, the cluster compositions and the uncertainties on the cluster abundances.

The composition of the samples was found to be mainly dominated by particles of crustal origin, associated with metals as Zn, Mn and Pb. Considerable differences in composition and abundance were observed between coarse and fine mode particle fractions and between different sampling sites.

References (25)

  • E.W. Forgy

    Cluster analysis of multivariate data: efficiency versus interpretability of classification

    Biometrics

    (1965)
  • G. Fritz

    TN-1912 PRC. Particle Recognition and Characterization

    (1982)
  • Cited by (31)

    • Diesel/biofuel exhaust particles from modern internal combustion engines: Microstructure, composition, and hygroscopicity

      2015, Fuel
      Citation Excerpt :

      The result of EDX analysis was obtained as a data matrix for 20 elements at measured weight concentrations above the detection limit of 0.3 wt%. A combination of hierarchical and non-hierarchical cluster analysis was applied for separation of individual particles on definable groups of similar chemical composition with an accuracy of 3% [29,30]. Final number of groups was proposed when the analysis with lower numbers does not give a good separation with respect to different particle types, while a higher number of clusters leads to duplicate groups with similar composition [15].

    • Chapter 17 A review of atmospheric aerosol measurements

      2002, Developments in Environmental Science
    View all citing articles on Scopus
    View full text