Abstract
The geometry of plate after edge pre-bending mode is compared with that after roll-bending mode and the relationship among edge pre-bending angle, pre-bending edge length, and cylindrical desired radius is presented for a three-roller plate bender with bottom rollers adjustable horizontally. The analytical moment-curvature model and springback model for pure bending are established, assuming that the stress-strain relationship of material is linear, and the material is in plain strain and yields according to Mises yield criterion. The mathematical model for three-roller edge pre-bending of plate is developed considering the effect of pre-bending edge length, bottom roller radius, friction between plate and roller, etc. The plate tensile test and plate bending test are done and the numerical results agree well with the test data. The results are shown graphically and analyzed in the following aspects: (1) the error between numerical results and test data of top roller force; (2) the influence of bottom roller radius, relative curvature, and bending arc length on springback angle; (3) the relationship between springback ratio and edge pre-bending angle.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
M. Hua, D. H. Sansome, K. Baines, J. Mater. Process. Technol. 52 (1995) 425–459.
A. H. Gandhi, H. K. Raval, J. Mater. Process. Technol. 197 (2008) 268–278.
N. E. Hansen, O. Jannerup, Journal of Engineering for Industry 101 (1979) 304–310.
M. I. Lysov, N. V. Sosov, Shaping of Parts by Bending, Mashinostroenie, Moscow, 2001.
N. M. Bodunov, Russian Aeromatics 54 (2011) 6
M. Hua, Y. H. Lin, J. Mater. Process. Technol. 4-6-7. (1999) 12–18.
Y. H. Lin, M. Hua, Int. J. Noniin. Mech. 35 (2002) 883–896.
T. X. Yu, W. Johnson, Int. J. Noniin. Mech. 5 (2002) 883–896.
W. L. Hu, The Theoretical Analysis and Experimental Study of the Plate Roll Bending, Harbin Institute of Technology, Harbin, 1992.
J. G. Shin, T.J. Park, H. Yim, J. Manuf. Sci. E-T. ASME. 123 (2001) 284–290.
T. X. Yu, L. C. Zhang, Plastic Bending: Theory and Application, Science Press, Beijing, 1992.
R. Hill, The Mathematical Theory of Plasticity, Oxford University Press, New York, 1950.
C. T. Wang, K. Gary, A. Taylan, J. Mater. Process. Technol. 39 (1993) 279–304.
X. C. Li, Y. Y. Yang, Y. Z. Wang, J. Bao, S. P. Li, J. Mater. Process. Technol. 123 (2002) 209–211.
Author information
Authors and Affiliations
Corresponding author
Additional information
Foundation Item: Item Sponsored by Shanxi Major Special Plan of Science and Technology of China (20111101032)
Rights and permissions
About this article
Cite this article
Zhang, Zq., Song, Jl., Fu, Jh. et al. A Refined Model of Three-roller Elastoplastic Asymmetrical Pre-bending of Plate. J. Iron Steel Res. Int. 21, 328–334 (2014). https://doi.org/10.1016/S1006-706X(14)60050-9
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1016/S1006-706X(14)60050-9