Local electric fields at individual atomic surface sites: field ion appearance energy measurements

https://doi.org/10.1016/0169-4332(93)90300-ZGet rights and content

Abstract

A new method of determining local electric fields is reported. Under conditions of highest field ion image contrast, absolute appearance energy measurements were carried out at a weakly corrugated step of a Rh(001) plane and at strongly corrugated step across the atom rows of a Rh(113) facet. Data of local fields, Fhklloc, are derived from appearance energies. A comparison is made with external electric field strengths, Fhkl0, determined by electron energy spectroscopy and i-V (Fowler-Nordheim) measurements. Significantly different enhancement factors, Fhklloc/Fhkl0, were found, 1.27 for steps at the (001) plane, and 1.54 for steps across the rows of Rh(113). In both cases the step-site atoms were covered with field-adsorbed Ne. The experimental results are discussed in view of recent self-consistent calculations of local-field distributions in the proximity of protruding surface atoms. The occurence of field ionization of image gas atoms, released from field-adsorbed states at step sites by atom-collision processes, is in accord with the present observations.

References (22)

  • D.J. Rose

    J. Appl. Phys.

    (1956)
  • E.W. Müller et al.

    Field Ion Microscopy

    (1969)
  • K.D. Rendulic

    Surf. Sci.

    (1971)
  • N. Ernst

    Surf. Sci.

    (1989)
  • W. Drachsel et al.

    J. Phys.

    (1988)
  • R.D. Young

    Phys. Rev.

    (1959)
  • E.W. Müller et al.

    J. Appl. Phys.

    (1961)
  • T. Sakurai et al.

    Phys. Rev. Lett.

    (1973)

    J. Appl. Phys.

    (1977)
  • N. Ernst et al.

    Abstracts of the 38th IFES

    (Wien 1991)
  • H.J. Kreuzer et al.

    Phys. Rev. B

    (1992)
  • H.J. Kreuzer

    Surf. Sci.

    (1991)
  • Cited by (50)

    • Making sustainable aluminum by recycling scrap: The science of “dirty” alloys

      2022, Progress in Materials Science
      Citation Excerpt :

      In addition, the critical electric field necessary to trigger field evaporation depends on the composition, and probably also the structure, of each of the phases [615–617]. Subtle roll-up-type, short-range displacements of atoms on a specimen’s surface prior to their departure cause the spatial precision of the measurement to degrade [618–620]. Because a second phase precipitate intersects a specimen’s emitting surface, a different radius of curvature also develops locally according to the magnitude of the electric field (and local work function) required to initiate field evaporation, i.e. the so-called evaporation field.

    • Advanced data mining in field ion microscopy

      2018, Materials Characterization
      Citation Excerpt :

      This variation in electric field strength across the surface atoms gives the final contrast in the FIM image. The contrast in FIM also depends on the gas supply function and adsorption behavior [6-8]. Atomic resolution can be attained in some cases on certain high index facets where the surface field distribution is corrugated enough to give contrast in the image.

    • Field ion and field desorption microscopy: Surface chemistry applications

      2018, Encyclopedia of Interfacial Chemistry: Surface Science and Electrochemistry
    • Coadsorption of lithium and oxygen on W(112): Nanosized facets versus single crystals

      2011, Ultramicroscopy
      Citation Excerpt :

      After W surface preparation (cleaning by visually controlled field evaporation at 79 K and characterization by FIM using Ne as imaging gas), the system was exposed to oxygen, Li was evaporated on the W surface, and the Li/O-covered surface was imaged with Li+ ions, similarly as it was done in Ref. [21] for Li/O-covered Rh surface. In a probe-hole experiment, the local Li+ ion emission flux from few (typically ≤10) selected surface sites on the W-tip was mass-to-charge resolved in a magnetic sector field and energy-analyzed with a five-electrode electrostatic retarding potential analyzer [22] (Fig. 1). By varying the threshold voltage δ=Ur–Ue (with Ur and Ue being the potentials of the retarder net and of the W emitter tip, respectively) the field ion retardation curves N=N(δ) can be obtained for any imaging gas ions emitted from the chosen surface sites on the tip surface.

    View all citing articles on Scopus
    1

    On leave from Technical University Lviv, Lviv, Ukraine.

    View full text