Skip to main content
Log in

Analysis of Boundary Layer Structure, Turbulence, and Flux Variations before and after the Passage of a Sea Breeze Front Using Meteorological Tower Data

  • Original Paper
  • Published:
Journal of Meteorological Research Aims and scope Submit manuscript

Abstract

A detailed analysis of a sea breeze front (SBF) that penetrated inland in the Beijing–Tianjin–Hebei urban agglomeration of China was conducted. We focused on the boundary layer structure, turbulence intensity, and fluxes before and after the SBF passed through two meteorological towers in the urban areas of Tianjin and Beijing, respectively. Significant changes in temperature, humidity, winds, CO2, and aerosol concentrations were observed as the SBF passed. Differences in these changes at the two towers mainly resulted from their distances from the ocean, boundary layer conditions, and background turbulences. As the SBF approached, a strong updraft appeared in the boundary layer, carrying near-surface aerosols aloft and forming the SBF head. This was followed by a broad downdraft, which destroyed the near-surface inversion layer and temporarily increased the surface air temperature at night. The feeder flow after the thermodynamic front was characterized by low-level jets horizontally, and downdrafts and occasional up-drafts vertically. Turbulence increased significantly during the SBF’s passage, causing an increase in the standard deviation of wind components in speed. The increase in turbulence was more pronounced in a stable boundary layer compared to that in a convective boundary layer. The passage of the SBF generated more mechanical turbulences, as indicated by increased friction velocity and turbulent kinetic energy (TKE). The shear term in the TKE budget equation increased more significantly than the buoyancy term. The atmosphere shifted to a forced convective state after the SBF’s passage, with near isotropic turbulences and uniform mixing and diffusion of aerosols. Sensible heat fluxes (latent heat and CO2 fluxes) showed positive (negative) peaks after the SBF’s passage, primarily caused by horizontal and vertical transport of heat (water vapor and CO2) during its passage. This study enhances understanding of boundary layer changes, turbulences, and fluxes during the passage of SBFs over urban areas.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

References

Download references

Acknowledgments

Some material used in this paper is based on the work supported by the National Center for Atmospheric Research of USA.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Ju Li.

Additional information

Supported by the Beijing Natural Science Foundation (8222048), Open Grants of the State Key Laboratory of Severe Weather (2022LASW-A03), Key Innovation Team of China Meteorological Administration (CMA2022ZD09), China Meteorological Administration Innovation Development Project (CXFZ2023J061), and Tianjin Meteorology Service Project (202113ybxm05).

Electronic supplementary material

13351_2023_3057_MOESM1_ESM.pdf

Analysis of boundary layer structure, turbulence, and flux variations before and after the passage of a sea breeze front using meteorological tower data

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Li, J., Dou, J., Lenschow, D.H. et al. Analysis of Boundary Layer Structure, Turbulence, and Flux Variations before and after the Passage of a Sea Breeze Front Using Meteorological Tower Data. J Meteorol Res 37, 855–877 (2023). https://doi.org/10.1007/s13351-023-3057-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s13351-023-3057-y

Key words

Navigation