Skip to main content
Log in

Impacts of Atmospheric Boundary Layer Vertical Structure on Haze Pollution Observed by Tethered Balloon and Lidar

  • Original Paper
  • Published:
Journal of Meteorological Research Aims and scope Submit manuscript

Abstract

In this paper, the characteristics of the atmospheric boundary layer (ABL) vertical structure over the North China Plain (NCP) during a comprehensive observation experiment conducted during 15–21 December 2018 were investigated. Observational data were obtained with a large tethered balloon, Doppler wind lidar, and ground-level instruments. The maximum concentration of PM2.5 exceeded 200 µg m−3, and the ratio of PM2.5/PM10 was approximately 0.4 (its maxi-mum was approximately 0.8) during the whole observation period, indicating the explosive growth of dominant fine-mode aerosols in the winter heating season. Elevated concentrations of pollutants decreased the solar irradiance received by the ground, resulting in lower temperature at ground level. Our results illustrate three distinct types of vertical profiles: Type 1 (convective state)—the concentration of PM2.5 decreased nearly linearly with increase of the height below approximately 600 m; Type 2 (stable state)—the PM2.5 concentration sharply decreased from the ground to approximately 200 m; and Type 3 (multilayer structure)—some pollutants were suspended aloft in the upper air layer. Diurnal evolution of the vertical profiles of PM2.5 and their relationship with the changes in meteorological factors were identified. From daytime to nighttime, the vertical profiles evolved from Type 1 to Type 2 or Type 3. All the 33 vertical PM2.5 profiles that we obtained showed a strong relationship with elements of the ABL structure, such as the distributions of winds, the inversion layer, and turbulence activities. A light-wind layer and weak turbulence activity, especially within the inversion layer, contributed greatly to the accumulation of pollutants. Vertical PM2.5 concentration patterns were also greatly affected by local ground-level emission sources and regional transport processes.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

Download references

Acknowledgments

The authors gratefully acknowledge the staff of Shanghai Environmental Monitoring Center for providing the valuable data.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Yu Shi.

Additional information

Supported by the National Key Research and Development Program of China (2017YFC0209605), National Natural Science Foundation of China (41975108), and General Financial Grant from the China Postdoctoral Science Foundation (2020M670420).

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Sun, H., Shi, Y., Liu, L. et al. Impacts of Atmospheric Boundary Layer Vertical Structure on Haze Pollution Observed by Tethered Balloon and Lidar. J Meteorol Res 35, 209–223 (2021). https://doi.org/10.1007/s13351-021-0076-4

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s13351-021-0076-4

Key words

Navigation