Skip to main content
Log in

Identification of photoproducts of florasulam in water using UPLC-QTOF-MS

  • Research Article
  • Published:
Environmental Science and Pollution Research Aims and scope Submit manuscript

Abstract

Here, we aimed to investigate florasulam photodegradation in aquatic environments under UV-visible irradiation. LC-MS/MS was used to explore the photolysis kinetics of florasulam degradation with respect to different light source types, florasulam concentrations, water sources, and pH. We also tested whether the addition of the nitrate ions, Fe3+, or I to the reaction solution influences florasulam photolysis kinetics. NO3 accelerates florasulam degradation at low concentrations (0.01–1 mg L−1), but decreases the process at higher concentrations. At low concentrations (≤ 0.1 mg L−1), Fe3+ enhanced florasulam photodegradation obviously. However, the addition of 0.01–10 mg L−1 I decreased the degradation rate linearly. The florasulam photolysis rates in alkaline and neutral solutions were higher than that in acidic solutions. The florasulam degradation rate under mercury light irradiation was greater than that under xenon light. The rate of florasulam degradation in distilled water was greater than in tap water, lake water, and rice paddy water. As the concentration of florasulam increased, the photodegradation rate decreased. Six kinds of transformation products (TPs) were isolated and identified using UPLC/Q-TOF-MS. Based on these TPs and their evolutionary processes, we inferred the florasulam degradation mechanisms, identifying four possible florasulam degradation pathways. Cleavage of the florasulam sulfonamide bond yielded TPs2. TPs2 was intermolecularly rearranged to form a SO2 extrusion compound, TPs3. Cleavage of the [C-F] bonds led to the formation of TPsl, TPs4, and TPs5, while hydroxylation led to the formation of TPs6. We then predicted the stability of each of the florasulam TPs in water. TPs2 and TPs3 rapidly degraded after reaching maximum concentration due to poor light stability. TPs4 and TPs6 were more photostable than florasulam (the parent compound) and may be important contributors to water pollution.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14

Similar content being viewed by others

References

Download references

Acknowledgments

The author would like to thank all the editors and the reviewers for helping to improve this paper.

Funding

This work was supported by the National key R&D Program of China (Project NO.2016YFD0200507-6).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Bo Tao.

Additional information

Responsible editor: Ester Heath

Publisher’s Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Qiao, Y., Chen, G., Ma, C. et al. Identification of photoproducts of florasulam in water using UPLC-QTOF-MS. Environ Sci Pollut Res 26, 7132–7142 (2019). https://doi.org/10.1007/s11356-019-04169-3

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11356-019-04169-3

Keywords

Navigation