Abstract
The torsional vibration phenomenon of the crankshaft system can trigger faults such as burned tile and flywheel deformation. The coupling is an important structure for regulating the torsional vibration of a shaft system. Most of the literature has only studied the effects of coupling misalignment, damping nonlinearity, and excitation nonlinearity on the torsional response of the system, while ignoring the vibration bifurcation caused by the coupling structure and fit parameters. To address the above limitations, this paper establishes a torsional vibration mechanics model of crankshaft, coupling, and rotor based on Lagrange dynamics. Mathematical models of coupling inclination angle, excess, and torsional stiffness are constructed using the finite element method. The effects of coupling inclination angle, excess, and angular velocity on the vibration bifurcation of the shaft system are discussed separately by the 4th-order Runge–Kutta methods. The results show that with an increase in the inclination angle, the vibration state of the shaft system switches between chaos and divergence, which is not conducive to the torsional vibration control of the shaft system. At the same time, the increase in the excess will lead to an increase in the angular velocity of vibration, which in turn will lead to increased wear of the shaft system and bearings. In addition, after considering the nonlinear characteristics of the coupling stiffness, the vibration amplitude of the shaft system rises with the increase in angular velocity, and the vibration state transforms from periodic to divergent. Finally, a coupling field vibration test study was carried out to verify the accuracy of the numerical model. The research results of this paper have a theoretical reference value for determining the coupling structure-fit parameters and the angular velocity of the shaft system.
Similar content being viewed by others
Data availability
The data that support the findings of this study are available from [Chengdu Compressor Branch, CNPC Jichai Power Company Limited] but restrictions apply to the availability of these data, which were used under license for the current study, and so are not publicly available. Data are however available from the authors upon reasonable request and with permission of [Chengdu Compressor Branch, CNPC Jichai Power Company Limited].
References
Wang, H.: Torsional vibration analysis of 8M80 symmetrical full balance high speed crankshaft. Shenyang University of Technology, (2020)
Barickman, J.R.: Flexible elastomeric couplings for torsional vibration isolation. Earthmov. Ind. Conf. 9, 11 (1984)
Xiao, L., Xu, Y.Q., Chen, Z.Y., Zhang, L.: Non-linear dynamic response of misaligned spline coupling: theoretical modeling and experimental investigation. J. Vib. Control. (2022). https://doi.org/10.1177/10775463211067104
Prabhakar, S., Sekhar, A.S., Mohanty, A.R.: Vibration analysis of a misaligned rotor-coupling-bearing system passing through the critical speed. P I Mech. Eng. C-J Mec. 215(12), 1417–1428 (2001). https://doi.org/10.1243/0954406011524784
Wang, M., Wen, B., Han, Q.: Dynamic characteristics of a misaligned rigid rotor system with flexible supports. Shock Vib. 3, 1–16 (2021). https://doi.org/10.1155/2021/8876190
Zhao, G., Liu, Z.S., Ye, J.H., Chen, F.: Study on the dynamic characteristics of rotor-uncentered spline coupling system. Vib. Shock. 28(03), 78–200 (2009). https://doi.org/10.13465/j.cnki.jvs.2009.03.016
Rong, L., Zhang, Q., Liu, M., Zhang, S.: Study on numerical simulation of rotor-diaphragm coupling-bearing system. Appl. Energy Technol. 04, 7–11 (2019)
Jiang, L.L., Chen, Y.M., Li, X.J., Zhang, H.X.: Vibration analysis of Dual-rotor system with coupling misalignment. Mechan. Sci. Technol. Aerosp. Eng. 38(09), 1350–1356 (2019). https://doi.org/10.13433/j.cnki.1003-8728.20190007
Zhu, C.Z., Wang, M., Du, X.S.: Analysis of nonlinear dynamic characteristics of the Schmidt offset coupling. J. Chongq University. 35(11), 8–14 (2012)
Tian, J., Xu, Y.L.: Analysis of vibration characteristics of radial permanent magnet coupling under installation error. J. Mechan. Transm. 44(01), 137–142 (2020). https://doi.org/10.16578/j.issn.1004.2539.2020.01.023
Zhang, G.Y., Liang, M.T., Guo, J.X., Niu, X.Z.: Dynamic characteristics of misaligned gear coupling-bearing-rotor system. J. Aerosp. Power 37(02), 225–234 (2022). https://doi.org/10.13224/j.cnki.jasp.20210017
Xia, Y., Pang, J., Yang, L.: Study on vibration response and orbits of misaligned rigid rotors connected by hexangular flexible coupling. Appl. Acoust. 155, 286–296 (2019). https://doi.org/10.1016/j.apacoust.2019.05.022
Shen, T.L.F., Zhao, Q.J., Yang, P., Qin, S.B., S.Y.J.: Nonlinear dynamics analysis of angularly misaligned laminated coupling system. J. Mechan. Strength 40(03), 552–558 (2018). https://doi.org/10.16579/j.issn.1001.9669.2018.03.008
Xue, X.Z., Huo, Q.X., Liu, J., Jia, J.P.: Nonlinear dynamic load analysis of aviation spline coupling with mass eccentricity and misalignment. Adv. Mech. Eng. 13(2), 168 (2021). https://doi.org/10.1177/1687814021996511
Xue, X.Z., Huo, Q.X., Liu, J.: Nonlinear vibration characteristics of the involute spline coupling in aeroengine with the parallel misalignment. Int. J. Aerospace Eng. 2021, 1–19 (2021). https://doi.org/10.1155/2021/6689442
Lu, K., Jin, Y., Huang, P.: The applications of POD method in dual rotor-bearing systems with coupling misalignment. Mech. Syst. Signal PR. 150, 107236 (2021). https://doi.org/10.1016/j.ymssp.2020.107236
Lin, B.C., Chen, B., Li, Y.H.: Linear and nonlinear frequency analyses for the rotating diaphragm of the coupling. J. Struct. Mechan. (2020). https://doi.org/10.1080/15397734.2020.1822179
Zhang Y.F.: Vibration characteristics and parametric vibration research of diaphragm coupling. Southwest Jiaotong University (2018)
Zhang, F.: Study on torsional vibration of Geislinger coupling. Machin. Des. Manuf. 01, 127–129 (2009). https://doi.org/10.3969/j.issn.1001-3997.2009.01.049
Francis, A., Avdeev, I., Hamann, J., Sundar, A.: Accurate characterization of torsional stiffness of flexible disk couplings. J. Eng. Gas Turb. Power. 137(8), 1–8 (2015). https://doi.org/10.1115/1.4029392
Wang, G.P., Chen, H.L., Qi, S.M., Yu, L.: Axial vibration characteristics of a metal diaphragm coupling. IET Sci. Meas. Technol. 239–240, 443–451 (2013). https://doi.org/10.4028/www.scientific.net/AMM.239-240.443
Fu, S.P., Luo, N., Huang, H.L., Zhou, Y.H., Ming, W.: Torsional vibration attenuation characteristics and stiffness identification of flexible coupling in vehicle power train. Shock Vib. 2020(1), 1–13 (2020). https://doi.org/10.1155/2020/8851581
Yan, M., Sun, T., Tian, Y.S., Zhang, H.L., Tan, C.Q.: Dynamics analysis of gas turbine generator unit with diaphragm coupling. Gas Turb. Technol. 32(02), 44–51 (2019). https://doi.org/10.16120/j.cnki.issn1009-2889.2019.02.008
Su F.: Study on the effect of flexible coupling on dynamic response of vibration system. Fudan University (2011)
Spruogis, B., Turla, V., Jurkonis, E.: Research of dynamics of the centrifugal ring coupling with the additional masses. J. Vib. 10(4), 565–570 (2008)
Yu, Y.X., Ding, K.K., Zhao, T.Y., Li, K.: Nonlinear dynamics of flexible diaphragm coupling’s rotor system during maneuvering flight. J. Strain. Anal. Eng. (2022). https://doi.org/10.1177/03093247221095281
Ma, J.M., Han, P.C.: influence of nonlinear stiffness of flexible coupling on torsional vibration. J. Vib. Shock. 04, 6–133 (2005). https://doi.org/10.13465/j.cnki.jvs.2005.04.002
Dong, H.B., Wang, W.J., Guo, Y.H., Yan, B.: Study on the effect of coupling characteristics on torsional vibration performance of diesel generator shaft systems. Mechan. Des. Manuf. 7, 33–38 (2020). https://doi.org/10.19356/j.cnki.1001-3997.2020.2020.07.009
Fu, C., Lu, K., Yang, Y.F., Xie, Z.L., Ming, A.B.: Nonlinear vibrations of an uncertain dual-rotor rolling bearings system with coupling misalignment. J. Nonlinear Math. Phy. (2022). https://doi.org/10.1007/s44198-022-00044-x
Yan, M., Tian, Y.S., Sun, T., Zhang, H.L., Tan, C.Q.: Nonlinear dynamics of two-span rotor-bearing system with flexible coupling misalignment. J. Mech. Eng. 56(16), 109–117 (2020). https://doi.org/10.3901/JME.2020.16.109
Li, H.L., Hou, L., Xu, M.P., Chen, Y.Z.: Superharmonic resonance analysis of misaligned rotor system based on HB-AFT method. J. Mech. Eng. 55(13), 80–86 (2019). https://doi.org/10.3901/ME.2019.13.080
Jin, Y.L., Liu, Z.W., Yang, Y., Li, F.S., Chen, Y.S.: nonlinear vibrations of a dual-rotor-bearing-coupling misalignment system with blade-casing rubbing. J. Sound Vib. 497, 115948 (2021). https://doi.org/10.1016/j.jsv.2021.115948
Zhang S.S.: Dynamics analysis of cascade reciprocating compressor. Harbin Engineering University (2013)
Zhu, X.Z., Yuan, H.Q.: Numerical study on nonlinear dynamic characteristic of crankshaft system of diesel engine. Chin. Int. Combust. Engine Eng. 30(03), 65–69 (2009). https://doi.org/10.13949/j.cnki.nrjgc.2009.03.016
Han, S.: A study of the effects of variable inertia on the torsional vibrations of ice. J. Arm. Force Eng. Inst. 8(03), 16–21 (1994)
Che, D.X.: The torsional vibration calculation and the experimental study for an engine crankshaft. South China University of Technology (2012)
ISO 898: Mechanical properties of fasteners made of carbon steel and alloy steel-Part 1: Bolts, screws and studs with specified property classes-Coarse thread and fine pitch thread. First Edition. (2013).
Funding
This work was partly funded by the National Science and Technology Major Project under Grant No. 2016ZX05040-006.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
The authors declare that they have no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Li, T., Huang, Z., Chen, Z. et al. Influence of laminated coupling structure-fit parameters on the dynamics of a shaft system. Nonlinear Dyn 112, 8025–8042 (2024). https://doi.org/10.1007/s11071-024-09488-w
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11071-024-09488-w