Abstract
We investigate the nonlinear dynamic response of a device made of two electrically coupled cantilever microbeams. The vibrations of the microbeams triggered by the electric actuation lead to the redistribution of the air flow in the gap separating them and induce a damping effect, known as the squeeze-film damping. This nonlinear dissipation mechanism is prominent when encapsulating and operating the microstructure under high gas pressure. We present different modeling approaches to analyze the impact of the squeeze-film damping on the dynamic behavior of the microsystem. We first develop a nonlinear multi-physics model of the device by coupling Euler–Bernoulli beam equations with the nonlinear Reynolds equation and use the Galerkin decomposition and differential quadrature method to discretize the structural and fluidic domains, respectively. We consider also another modeling approach based on approximating the squeeze-film damping force by a nonlinear analytical expression. This approach is widely used in the literature and referred to as partially coupled model in this paper. We conduct a comparative study of the nonlinear dynamic responses obtained from the two models under different operating conditions in terms of electric actuation and applied pressure. The simulated frequency and force-response curves show the limitations of the partially coupled model to capture properly the microsystem dynamics, especially when approaching the onset of the pull-in instability and exciting the microsystem with an AC voltage near resonance. As such, we propose a correction factor to the partially coupled model which is much less computationally demanding to obtain good match with the fully coupled model. The selection of the correction factor depends on the thickness ratio, the ambient pressure, and the excitation frequency. The influence of the ambient pressure and the thickness ratio between the two microbeams were also examined. We observe that operating the microsystem at a reduced ambient pressure or when reducing one of the microbeams’ thickness can lead to a premature instability of the dynamic solution which reduces the maximum amplitude of the vibrating microbeams. This feature can be exploited for switching applications but it constitutes an undesirable effect for resonators.
Similar content being viewed by others
References
Nayfeh, A.H., Ouakad, H.M., Najar, F., Choura, S., Abdel-Rahman, E.M.: Nonlinear dynamics of a resonant gas sensor. Nonlinear Dyn. 59, 607–618 (2010)
Ghommem, M., Abdelkefi, A.: Novel design of microgyroscopes employing electrostatic actuation and resistance-change based sensing. J. Sound Vib. 411, 278–288 (2017)
Ghommem, M., Abdelkefi, A.: Nonlinear analysis of rotating nanocrystalline silicon microbeams for microgyroscope applications. Microsyst. Technol. 23, 5931–5946 (2017)
Ghommem, M., Abdelkefi, A.: Nonlinear reduced-order modeling and effectiveness of electrically-actuated microbeams for bio-mass sensing applications. Int. J. Mech. Mater. Design 15, 125–143 (2019)
Ben Sassi, S., Khater, M.E., Najar, F., Abdel-Rahman, E.M.: A square wave is the most efficient and reliable waveform for resonant actuation of micro switches. J. Micromech. Microeng. 28, 1–14 (2018)
Samaali, H., Najar, F.: Design of a capacitive MEMS double beam switch using dynamic pull-in actuation at very low voltage. Microsyst. Technol. 23, 5317–5327 (2017)
Bouchaala, A., Jaber, N., Yassine, O., Shekhah, O., Chernikova, V., Eddaoudi, M., Younis, M.I.: Nonlinear-based MEMS sensors and active switches for gas detection. Sensors 16, 758 (2016)
Jrad, M., Younis, M.I., Najar, F.: Modeling and design of an electrically actuated resonant microswitch. J. Vib. Control 22, 559–569 (2016)
Ouakad, H., Younis, M.: On using the dynamic snap-through motion of MEMS initially curved microbeams for filtering applications. J. Sound Vib. 2, 555–568 (2014)
Samaali, H., Najar, F., Choura, S., Nayfeh, A.H., Masmoudi, M.: A double microbeam MEMS ohmic switch for RF-applications with low actuation voltage. Nonlinear Dyn. 63, 719–734 (2011)
Hammad, B.K., Abdel-Rahman, E.M., Nayfeh, A.H.: Modeling and analysis of electrostatic MEMS filters. Nonlinear Dyn. 60, 385–401 (2010)
Ilyas, S., Jaber, N., Younis, M.I.: MEMS logic using mixed-frequency excitation. J. Microelectromech. Syst. 26, 1140–1146 (2017)
Chappanda, K.N., Ilyas, S., Younis, M.I.: Micro-mechanical resonators for dynamically reconfigurable reduced voltage logic gates. J. Micromech. Microeng. 28, 055009 (2018)
Younis, M.I.: MEMS Linear and Nonlinear Statics and Dynamics. Springer, Berlin (2011)
Ahmed, M.S., Ghommem, M., Abdelkefi, A.: Shock response of electrostatically coupled microbeams under the squeeze-film damping effect. Acta Mech. 229(12), 5051–5065 (2018)
Yagubizade, H., Younis, M.I.: The effect of squeeze-film damping on the shock response of clamped-clamped microbeams. J. Dyn. Syst. Meas. Control 134(1), 011017 (2012)
Mo, Y., Du, L., Qu, B., Peng, B., Yang, J.: Squeeze film air damping ratio analysis of a silicon capacitive micromechanical accelerometer. Microsyst. Technol. 24, 1089–1095 (2014)
Ouakad, H., Al-Qahtani, H., Hawwa, M.A.: Influence of squeeze-film damping on the dynamic behavior of a curved micro-beam. Adv. Mech. Eng. 8, 1–8 (2016)
Liu, C.-C., Wang, C.-C.: Numerical investigation into nonlinear dynamic behavior of electrically-actuated clamped-clamped micro-beam with squeeze-film damping effect. Appl. Math. Model. 38, 3269–3280 (2014)
Ilyas, S., Al-Hafiz, M.A., Chappanda, K.N., Ramini, A., Younis, M.: An experimental and theoretical investigation of electrostatically-coupled cantilever microbeams. Sens. Actuators A Phys. 247, 368–378 (2016)
Ahmed, M.S., Ghommem, M., Abdelkefi, A.: Nonlinear analysis and characteristics of electrically-coupled microbeams under mechanical shock. Microsyst. Technol. 25(3), 829–843 (2019)
Meirovitch, L., Parker, R.G.: Fundamentals of vibrations. Appl. Mech. Rev. 54, B100 (2001)
Sassi, S.B., Najar, F.: Strong nonlinear dynamics of MEMS and NEMS structures based on semi-analytical approaches. Commun. Nonlinear Sci. Numer. Simul. 61, 1–21 (2018)
Samaali, H., Najar, F., Choura, S.: Dynamic study of a capacitive MEMS switch with double clamped-clamped microbeams. Shock Vib. 2014, 1–7 (2014). https://doi.org/10.1155/2014/807489
Khater, M.E., Vummidi, K., Abdel-Rahman, E.M., Nayfeh, A.H., Raman, S.: Dynamic actuation methods for capacitive MEMS shunt switches. J. Micromech. Microeng. 21(3), 035009 (2011)
Pandey, A.K., Pratap, R.: Effect of flexural modes on squeeze film damping in MEMS cantilever resonators. J. Micromech. Microeng. 17(12), 2475 (2007)
Najar, F., Nayfeh, A.H., Abdel-Rahman, E.M., Choura, S., El-Borgi, S.: Nonlinear analysis of MEMS electrostatic microactuators: primary and secondary resonances of the first mode. J. Vib. Control 16(9), 1321–1349 (2010)
Acknowledgements
The author M. Ghommem gratefully acknowledges the financial support via the Biosciences and Bioengineering Research Institute and American University of Sharjah Grant Number EN0277-BBRI18.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
The authors declare that they have no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Najar, F., Ghommem, M. & Abdelkefi, A. Multifidelity modeling and comparative analysis of electrically coupled microbeams under squeeze-film damping effect. Nonlinear Dyn 99, 445–460 (2020). https://doi.org/10.1007/s11071-019-04928-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11071-019-04928-4