Abstract
Hydrogen sulfide (H2S) is the most predominant malodorous gas released during the thermal drying of municipal wastewater sludge. Experiment using a laboratory-scale tube furnace was conducted to determine the characteristics of H2S release and the changes of sludge moisture content. The addition of calcium oxide (CaO) in the original sludge was also tested and evaluated for its inhibitory effect on the H2S release. The results showed that the amount of H2S released increases with the increase of temperature in the tested range of temperature from 80 to 280 °C. The critical temperature range defined as the turn point of temperature at which the H2S or other odorous gases release starts to drastically increase was determined to be 200–240 °C. It was found that the drying process could be divided into two stages according to the changes of H2S release speed and the corresponding moisture content, and the majority of H2S release was detected in the second stage. The reduction of element sulfur in sludge was approximately proportional to the H2S released in the temperature range from 80 to 280 °C. The addition of CaO in the sludge could significantly repress the release of H2S during thermal drying. This inhibitory effect was observed to last for the entire drying process and not be changed with the change of temperature.
Similar content being viewed by others
References
Meng XZ, Venkatesan AK, Ni YL, Steele JC, Wu LL, Bignert A, Bergman A, Halden RU (2016) Organic contaminants in Chinese sewage sludge: a meta-analysis of the literature of the past 30 years. Environ Sci Technol 50:5454–5466. doi:10.1021/acs.est.5b05583
Yang G, Zhang G, Wang H (2015) Current state of sludge production, management, treatment and disposal in China. Water Res 78:60–73. doi:10.1016/j.watres.2015.04.002
Werle S, Wilk RK (2010) A review of methods for the thermal utilization of sewage sludge: the polish perspective. Renew Energy 35:1914–1919. doi:10.1016/j.renene.2010.01.019
Sawai O, Nunoura T, Yamamoto K (2013) Supercritical water gasification of sewage sludge using bench-scale batch reactor: advantages and drawbacks. J Mater Cycles Waste Manag 16:82–92. doi:10.1007/s10163-013-0144-7
Su L, Shi X, Guo G, Zhao A, Zhao Y (2013) Stabilization of sewage sludge in the presence of nanoscale zero-valent iron (nZVI): abatement of odor and improvement of biogas production. J Mater Cycles Waste Manag 15:461–468. doi:10.1007/s10163-013-0150-9
Jin L, Zhang G, Tian H (2014) Current state of sewage treatment in China. Water Res 66:85–98. doi:10.1016/j.watres.2014.08.014
Li B, Wang F, Chi Y, Yan J-H (2014) Study on optimal energy efficiency of a sludge drying-incineration combined system. J Mater Cycles Waste Manag 16:684–692. doi:10.1007/s10163-014-0293-3
Kelessidis A, Stasinakis AS (2012) Comparative study of the methods used for treatment and final disposal of sewage sludge in European countries. Waste Manag 32:1186–1195. doi:10.1016/j.wasman.2012.01.012
Yuan H, Lu T, Zhao D, Huang H, Noriyuki K, Chen Y (2013) Influence of temperature on product distribution and biochar properties by municipal sludge pyrolysis. J Mater Cycles Waste Manag 15:357–361. doi:10.1007/s10163-013-0126-9
Huang Y, Yu L, Wang R, Wu J, Takaoka M (2015) Pilot study of intense dewatering of urban sewage sludge. J Mater Cycles Waste Manag 19:88–101. doi:10.1007/s10163-015-0387-6
Weng H, Dai Z, Ji Z, Gao C, Liu C (2015) Release and control of hydrogen sulfide during sludge thermal drying. J Hazard Mater 296:61–67. doi:10.1016/j.jhazmat.2015.04.037
Liu W, Xu J, Liu J, Cao H, Huang XF, Li G (2015) Characteristics of ammonia emission during thermal drying of lime sludge for co-combustion in cement kilns. Environ Technol 36:226–236. doi:10.1080/09593330.2014.942705
Vaxelaire J, Puiggali JR (2006) Analysis of the drying of residual sludge: from the experiment to the simulation of a belt dryer. Dry Technol 20:989–1008. doi:10.1081/drt-120003773
Lowe P (2007) Developments in the thermal drying of sewage sludge. Water Environ J 9:306–316. doi:10.1111/j.1747-6593.1995.tb00944.x
Deng WY, Yan JH, Li XD, Wang F, Zhu XW, Lu SY, Cen KF (2009) Emission characteristics of volatile compounds during sludges drying process. J Hazard Mater 162:186–192. doi:10.1016/j.jhazmat.2008.05.022
Weng H-X, Ji Z-Q, Chu Y, Cheng CQ, Zhang J-J (2011) Benzene series in sewage sludge from China and its release characteristics during drying process. Environ Earth Sci 65:561–569. doi:10.1007/s12665-011-1100-2
Tian Y, Zhang J, Zuo W, Chen L, Cui Y, Tan T (2013) Nitrogen conversion in relation to NH3 and HCN during microwave pyrolysis of sewage sludge. Environ Earth Sci 47:3498–3505. doi:10.1021/es304248j
Gostelow P, Parsons SA, Stuetz RM (2001) Odour measurements for sewage treatment works. Water Res 35:579–597. doi:10.1016/S0043-1354(00)00313-4
Liu S, Wei M, Qiao Y, Yang Z, Gui B, Yu Y, Xu M (2015) Release of organic sulfur as sulfur-containing gases during low temperature pyrolysis of sewage sludge. Proc Combust Inst 35:2767–2775. doi:10.1016/j.proci.2014.06.055
Liu H, Luo GQ, Hu HY, Zhang Q, Yang JK, Yao H (2012) Emission characteristics of nitrogen- and sulfur-containing odorous compounds during different sewage sludge chemical conditioning processes. J Hazard Mater 235–236:298–306. doi:10.1016/j.jhazmat.2012.07.060
Godayol A, Alonso M, Besalu E, Sanchez JM, Antico E (2011) Odour-causing organic compounds in wastewater treatment plants: evaluation of headspace solid-phase microextraction as a concentration technique. J Chromatogr A 1218:4863–4868. doi:10.1016/j.chroma.2011.02.017
He R, Xia FF, Bai Y, Wang J, Shen DS (2012) Mechanism of H2S removal during landfill stabilization in waste biocover soil, an alterative landfill cover. J Hazard Mater 217–218:67–75. doi:10.1016/j.jhazmat.2012.02.061
Carrera-Chapela F, Donoso-Bravo A, Souto JA (2014) Modeling the odor generation in WWTP: an integrated approach review. Water Air Soil Pollut 225:1–15. doi:10.1007/s11270-014-1932-y
Liu H, Zhang Q, Hu H, Xiao R, Li A, Qiao Y, Yao H, Naruse I (2014) Dual role of conditioner CaO in product distributions and sulfur transformation during sewage sludge pyrolysis. Fuel 134:514–520. doi:10.1016/j.fuel.2014.06.020
Liu H, Liu P, Hu H, Zhang Q, Wu Z, Yang J, Yao H (2014) Combined effects of Fenton peroxidation and CaO conditioning on sewage sludge thermal drying. Chemosphere 117:559–566. doi:10.1016/j.chemosphere.2014.09.038
Ministry of Housing and Urban-Rural Development of People’s Republic China (2005) Determination method for municipal sludge in wastewater treatment plant. Standards Press of China, Beijing
Reiffenstein RJ, Hulbert WC, Roth SH (1992) Toxicology of hydrogen sulfide. Annu Rev Pharmacol 32:109–134. doi:10.1146/annurev.pa.32.040192.000545
Logan TJ, Harrison BJ (1995) Physical characteristics of alkaline stabilized sewage sludge (N-Viro soil) and their effects on soil physical properties. J Environ Qual 24:153–164. doi:10.2134/jeq1995.00472425002400010022x
Hwang Y, Matsuo T, Hanaki K, Suzuki N (1995) Identification and quantification of sulfur and nitrogen containing odorous compounds in wastewater. Water Res 29:711–718. doi:10.2134/jeq1995.00472425002400010022x
North JM, Becker JG, Seagren EA, Ramirez M, Peot C (2008) Methods for quantifying lime incorporation into dewatered sludge. i: bench-scale evaluation. J Environ Eng 134:750–761. doi:10.1061/(ASCE)0733-9372(2008)134:9(750)
Zhou Q, Hu H, Liu Q, Shengwei Zhu A, Rui Z (2005) Effect of atmosphere on evolution of sulfur-containing gases during coal pyrolysis. Energ Fuel 19:892–897. doi:10.1021/ef049773p
Guan R, Li W, Li B (2003) Effects of Ca-based additives on desulfurization during coal pyrolysis. Fuel 82:1961–1966. doi:10.1016/s0016-2361(03)00188-1
Acknowledgements
This study was supported by the Major Science and Technology program for water pollution control and treatment (2010ZX07319-001-06).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Wu, M., Wang, Z., Zhou, J. et al. Release characteristics and control of hydrogen sulfide during thermal drying of municipal wastewater sludge. J Mater Cycles Waste Manag 20, 946–954 (2018). https://doi.org/10.1007/s10163-017-0657-6
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10163-017-0657-6