Skip to main content
SpringerLink
Log in

Effect of temperature on electrical conductivity of green sapwood of Pinus radiata (radiata pine)

  • Original
  • Published:
Wood Science and Technology Aims and scope Submit manuscript

Abstract

Joule heating of green Pinus radiata, if controlled in a range 60–90 °C, has the potential to be used for veneer cutting, improving the peeling process and the quality of veneer. This research attempts to study the wood’s electrical conductivity, one of the key variables in controlling the Joule heating effect. Electrical conductivity of green New Zealand grown radiata pine sapwood was studied over a 20–90 °C temperature range. The sapwood studied had moisture content in the range of 100–200%. The effects of wood parameters such as grain orientation, moisture content, and basic density were evaluated. The effects of temperature and grain orientation on the conductivity were found to be much greater than those of moisture content and basic density. At 23 °C, conductivity in the longitudinal direction was around 20 times higher than in the tangential and 10 times higher than in the radial direction. Between 23 and 90 °C the longitudinal conductivity increased threefold, near linearly with temperature, whereas the tangential and radial conductivities increased nonlinearly by factors of 6 and 4, respectively. A statistical model based on the experimental results has been developed using the linear mixed effect model.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6

Similar content being viewed by others

References

  • Ansari MZ, Cho C (2010) An analytical model of joule heating in piezoresistive microcantilevers. Sensors 10(11):9668–9686

    Article  CAS  PubMed  PubMed Central  Google Scholar 

  • Bamber RK, Burley J (1983) The wood properties of radiata pine. Commonwealth Agricultural Bureaux, Wallingford

    Google Scholar 

  • Bard AJ, Faulkner LR (2001) Electrochemical methods: fundamentals and applications, 2nd edn. Wiley, New York

    Google Scholar 

  • Bates D, Mächler M, Bolker B, Walker S (2015) Fitting linear mixed-effects models using lme4. J Stat Softw 67(1):1–48. doi:10.18637/jss.v067.i01

    Article  Google Scholar 

  • Brischke C, Rapp AO, Bayerbach R (2008) Measurement system for long-term recording of wood moisture content with internal conductively glued electrodes. Build Environ 43(10):1566–1574

    Article  Google Scholar 

  • Brown J, Davidson R, Skaar C (1963) Mechanism of electrical conduction in wood. For Prod J 13(10):455–459

    Google Scholar 

  • Burr HK, Stamm AJ (1947) Diffusion in wood. J Phys Colloid Chem 51(1):240–261

    Article  CAS  PubMed  Google Scholar 

  • Cengel YA, Boles MA (2011) Thermodynamics: an engineering approach, 7th edn. McGraw-Hill, New York

    Google Scholar 

  • Chen Z, Wengert EM, Lamb FM (1994) A technique to electrically measure the moisture content of wood above fiber saturation. For Prod J 44(9):57

    Google Scholar 

  • Dupleix A, Denaud LE, Bleron L, Marchal R, Hughes M (2013) The effect of log heating temperature on the peeling process and veneer quality: beech, birch, and spruce case studies. Eur J Wood Prod 71(2):163–171

    Article  CAS  Google Scholar 

  • Faraway JJ (2005) Linear models with R. Chapman & Hall, London

    Google Scholar 

  • Fleischer HO, Downs LE (1953) Heating veneer logs electrically. Techical report, United States Department of Agriculture, Forest Service, Forest Products Laboratory, Madison, Wisconsin

  • Forsén H, Tarvainen V (2000) Accuracy and functionality of hand held wood moisture content meters. Technical Research Centre of Finland (VTT), Finland

    Google Scholar 

  • Fredriksson M, Wadsö L, Johansson P (2013) Small resistive wood moisture sensors: a method for moisture content determination in wood structures. Eur J Wood Prod 71(4):515–524

    Article  CAS  Google Scholar 

  • Harris JM (1991a) Formation of wood and bark. In: Kininmonth JA, Whitehouse LJ (eds) Properties and uses of New Zealand radiata pine. Ministry of Forestry, Forest Research Institute, Rotorua, pp 3.1–3.18

    Google Scholar 

  • Harris JM (1991b) Structure of wood and bark. In: Kininmonth JA, Whitehouse LJ (eds) Properties and uses of New Zealand radiata pine. Ministry of Forestry, Forest Research Institute, Rotorua, pp 2.1–2.16

    Google Scholar 

  • Harris JM, Cown DJ (1991) Basic wood properties. In: Kininmonth JA, Whitehouse LJ (eds) Properties and uses of New Zealand radiata pine. Ministry of Forestry, Forest Research Institute, Rotorua, pp 6.1–6.28

    Google Scholar 

  • Haynes WM (2014) CRC handbook of chemistry and physics. CRC Press, Boca Raton

    Google Scholar 

  • Kuznetsova A, Bruun Brockhoff P, Haubo Bojesen Christensen R (2016) lmerTest: tests in linear mixed effects models. https://CRAN.R-project.org/package=lmerTest, R package version 2.0-32

  • Langrish T, Walker JCF (2006) Drying of timber. Primary wood processing: principles and practice. Springer, Dordrecht, pp 251–295

    Book  Google Scholar 

  • Lin R (1967) Review of the dielectric properties of wood and cellulose. For Prod J 17(7):61

    CAS  Google Scholar 

  • McCleskey RB (2011) Electrical conductivity of electrolytes found in natural waters from (5 to 90) °C. J Chem Eng Data 56(2):317–327

    Article  CAS  Google Scholar 

  • Pang S, Herritsch A (2005) Physical properties of earlywood and latewood of Pinus radiata D. Don: anisotropic shrinkage, equilibrium moisture content and fibre saturation point. Holzforschung 59(6):654–661

    Article  CAS  Google Scholar 

  • Pang S, Keey R, Langrish T (1995) Modelling the temperature profiles within boards during the high-temperature drying of Pinus radiata timber: the influence of airflow reversals. Int J Heat Mass Transf 38(2):189–205

    Article  Google Scholar 

  • Perré P (2004) Electrical heating of green logs using Joule’s effect: a comprehensive computational model used to find a suitable electrode design. Wood Sci Technol 38(6):429–449

    Google Scholar 

  • R Core Team (2016) R: a language and environment for statistical computing. R Foundation for Statistical Computing, Vienna, Austria. https://www.R-project.org/

  • Sakamoto Y, Ishiguro M, Kitagawa G (1986) Akaike information criterion statistics. D Reidel, Dordrecht

    Google Scholar 

  • Sakr M, Liu S (2014) A comprehensive review on applications of ohmic heating (OH). Renew Sustain Energy Rev 39:262–269

    Article  Google Scholar 

  • Salmén L (1984) Viscoelastic properties of in situ lignin under water-saturated conditions. J Mater Sci 19(9):3090–3096

    Article  Google Scholar 

  • Sharma S, Shukla S, Kamala B (1997) Studies on dc electrical resistivity of plantation grown timbers. Holz Roh-Werkst 55(6):391–394

    Article  CAS  Google Scholar 

  • Skaar C (1988) Wood-water relations. Springer, Berlin

    Book  Google Scholar 

  • Stamm AJ (1927) The electrical resistance of wood as a measure of its moisture content. Ind Eng Chem 19(9):1021–1025

    Article  CAS  Google Scholar 

  • Stamm AJ (1929) The fiber-saturation point of wood as obtained from electrical conductivity measurements. Ind Eng Chem Anal Ed 1(2):94–97

    Article  CAS  Google Scholar 

  • Stamm AJ (1960) Bound-water diffusion into wood in across-the-fibre directions. For Prod J 10(10):524–528

    CAS  Google Scholar 

  • Stamm AJ (1964) Wood and cellulose science. Ronald Press Co., New York

    Google Scholar 

Download references

Acknowledgements

The authors are thankful to McVicar Timber, New Zealand, for providing fresh wood used in this research. The authors also wish to thank Associate Professor Elena Moltchanova, Statistics Consulting Unit, University of Canterbury, for helpful comments in the statistical modelling. This work has been supported by Scion under the NZ Ministry of Business, Innovation and Employment (MBIE) and Stakeholders in Methyl Bromide Reduction (STIMBR) funded Market Access Programme.

Author information

Authors and Affiliations

  1. Department of Chemical and Process Engineering, University of Canterbury, Private Bag 4800, Christchurch, 8140, New Zealand

    N. Nursultanov

  2. School of Forestry, University of Canterbury, Private Bag 4800, Christchurch, 8140, New Zealand

    C. Altaner

  3. EPECentre, University of Canterbury, Private Bag 4800, Christchurch, 8140, New Zealand

    W. J. B. Heffernan

Authors
  1. N. Nursultanov
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. C. Altaner
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. W. J. B. Heffernan
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to N. Nursultanov.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Nursultanov, N., Altaner, C. & Heffernan, W.J.B. Effect of temperature on electrical conductivity of green sapwood of Pinus radiata (radiata pine). Wood Sci Technol 51, 795–809 (2017). https://doi.org/10.1007/s00226-017-0917-6

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00226-017-0917-6

Keywords

Search

Navigation