This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Practical Evaluation and Computational Simulation of the Effect of Engine Front End Accessory Drive (FEAD) Dumpers on OBD Misfire Monitor Signal
Technical Paper
2012-36-0329
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Misfire monitoring is currently a mandatory On Board Diagnostic (OBD) regulatory requirement in most of the main automotive markets. The most common method used for misfire detection is the one based on the calculation of the derivative of the angular crankshaft velocity in which sharp variations of the derivative signal are associated to misfire events. Therefore, the misfire detection calibration is practically unique for a given engine hardware and installation.
Within this context, this Paper will present a practical evaluation and also a computational simulation of the impact of an engine hardware change (front end accessory drive dumpers) on the calculated angular acceleration signal and, therefore, on the overall misfire detection capability. The outcomes of this study will ultimately define the need of calibration changes as well as support a future development of an analytical method to predicted impacts in misfire calibration.
Recommended Content
| Technical Paper | S.I. Engine Misfire Detection Through the Energy Model |
| Technical Paper | Diagnosis of individual Cylinder Misfires by Signature Analysis of Crankshaft Speed Fluctuations |
| Technical Paper | Linear Model Updating Applied to Rotating Machines |
Authors
Citation
Alves, M., Domingues, A., Filho, C., Pedreira, C. et al., "Practical Evaluation and Computational Simulation of the Effect of Engine Front End Accessory Drive (FEAD) Dumpers on OBD Misfire Monitor Signal," SAE Technical Paper 2012-36-0329, 2012, https://doi.org/10.4271/2012-36-0329.Also In
References
- Alves, M. et al. “Preliminary Investigation of OBDBr-2 Catalyst Monitor Performance with Aftermarket Catalysts” SIMEA Paper 027/2009
- Cavina, N. Poggio, L. Sartoni, G. “Misfire and Partial Burn Detection based on Ion Current Measurement,” SAE Int. J. Engines 4 2 2451 2460 2011 10.4271/2011-24-0142
- Sellnau, M. et al. “Cylinder-Pressure-Based Engine Control Using Pressure-Ratio-Management and Low-Cost Non-Intrusive Cylinder Pressure Sensors” SAE Paper 2000-01-0932
- Shimasaki, Y. et al. “Study on Engine Management System Using In-cylinder Pressure Sensor Integrated with Spark Plug” SAE Paper 2004-01-0519
- Saitzkoff, A. Reinmann, R. Berglind, T. Glavmo, M. “An Ionization Equilibrium Analysis of the Spark Plug as an Ionization Sensor,” SAE Technical Paper 960337 1996 10.4271/960337
- Doi, K. Nakamura, Y. Hanashi, K. Hashizume, K. “Development of Spark Plug for Ion Current Misfire Detection System,” SAE Int. J. Engines 5 3 1387 1393 2012 10.4271/2012-01-1253
- Dong, G. et al. “Misfiring Control in Current Cycle at Engine Start Employing” SAE Paper 2009-01-2713
- Walter, A. et al. “Misfire Detection for Vehicles with Dual Mass Flywheel (DMF) Based on Reconstructed Engine Torque” SAE Paper 2007-01-3544
- Baltusis, P. “On Board Vehicle Diagnostics” SAE Paper 2004-21-0009 2004