Calculation of the Heat Content of the Electrode Metal Droplet When Applying Power Supplies for Manual Arc Welding with Different Volt-Ampere Characteristic
p.101
p.101
Diffusion and Mechanical Stresses in a Material with Two-Component Coating at External Heating
p.105
p.105
Towards Energy Intensity Reduction of Machining Fabrication Procedures
p.111
p.111
Machinability of Calcium Steel in Deep Hole Drilling with Small Diameters Gun Drills
p.116
p.116
Study of the Rheological Properties of Materials at the Blade Processing on Example of Milling Nickel-Chromium Alloy 10H11N23T3 MR VD
p.120
p.120
Influence of Chip Formation Characteristics on Flank Contact Load Distribution in Titanium Alloy Cutting
p.126
p.126
Increasing Efficiency by Applying the Arc Covered-Electrode Welding for Repairing Magnetized Pipelines
p.132
p.132
Specifics of Welded Joint Destruction Obtained by Friction Stir Welding at Strain
p.137
p.137
Reduction of Metal Consumption in View of Mining Cutting Tools Operation
p.144
p.144
Study of the Rheological Properties of Materials at the Blade Processing on Example of Milling Nickel-Chromium Alloy 10H11N23T3 MR VD
Abstract:
This article describes a method of determination of the parameters of the rheological material properties of nickel-chromium alloy 10H11N23T3 MR VD used in aircraft engine building, while milling. To register a component of the cutting force Fx, Fy, Fz realtime we used the dynamometer Kistler 9257V. The calculations were performed in the CAE system Deform with the use of FEM-model.
You might also be interested in these eBooks
Info:
Periodical:
Applied Mechanics and Materials (Volume 756)
Pages:
120-125
Citation:
Online since:
April 2015
Price:
Permissions: