Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.17559/TV-20160615125650

Evaluation of Residual Stresses after Irregular Interrupted Machining

Sarka Malotova ; VŠB-Technical University of Ostrava, Faculty of Mechanical Engineering, Department of Machining, Assembly and Engineering Metrology, 17.listopadu 15, 708 33 Ostrava, Czech Republic
Robert Cep orcid id orcid.org/0000-0001-9610-4215 ; VŠB-Technical University of Ostrava, Faculty of Mechanical Engineering, Department of Machining, Assembly and Engineering Metrology, 17.listopadu 15, 708 33 Ostrava, Czech Republic
Tomas Zlamal ; VŠB-Technical University of Ostrava, Faculty of Mechanical Engineering, Department of Machining, Assembly and Engineering Metrology, 17.listopadu 15, 708 33 Ostrava, Czech Republic
Petr Mohyla ; Faculty of Mechanical Engineering, Department of Mechanical Technology, 17. listopadu 15, 708 33 Ostrava, Czech Republic
Andrej Czán orcid id orcid.org/0000-0002-8826-1832 ; Faculty of Mechanical Engineering, University of Žilina, Univerzitna 1, 010 26, Zilina, Slovakia
Aco Antić ; Faculty of Technical Sciences, University of Novi Sad, Trg Dositeja Obradovića 6, 21000 Novi Sad, Republic of Serbia
Igor Budak ; Faculty of Technical Sciences, University of Novi Sad, Trg Dositeja Obradovića 6, 21000 Novi Sad, Republic of Serbia
Lobonţiu Mircea ; Faculty of Mechanical Engineering, Universitatea Tehnicá din Cluj – Napoca, B-dul Muncii nr. 103-105, 400641, Cluj-Napoca, România


Puni tekst: engleski pdf 1.106 Kb

str. 1009-1013

preuzimanja: 561

citiraj


Sažetak

Residual stress occurs in many machined components and parts. Over time, several methods have been developed for the investigation of residual stress in the material – destructive and non-destructive. This article deals with the evaluation and comparison of residual stress in the material when machining steel C45 and 11CrMo9-10, when the tool enters into the cut and stands out in conditions of an interrupted cut. A non-destructive method, based on X-Ray diffraction, was applied to evaluate the residual stress. The points were measured on the last machined slat by using interrupted cut simulator. An irregular interrupted cut was achieved by gradually machining 4, 3, 2 and 1 slat. The experiments were realized in co-operation with the Faculty of Mechanical Engineering, VSB – Technical University of Ostrava, Czech Republic and the Faculty of Mechanical Engineering, the University of Žilina, Slovakia.

Ključne riječi

interrupted cut; machining; residual stress; X-Ray diffraction

Hrčak ID:

204446

URI

https://hrcak.srce.hr/204446

Datum izdavanja:

20.8.2018.

Posjeta: 1.259 *