Details

Title

Application of a two-phase thermosyphon loop with minichannels and a minipump in computer cooling

Journal title

Archives of Thermodynamics

Yearbook

2016

Issue

No 1

Authors

Keywords

thermosyphon loop ; two phase flow ; computer cooling

Divisions of PAS

Nauki Techniczne

Coverage

3-16

Publisher

The Committee of Thermodynamics and Combustion of the Polish Academy of Sciences and The Institute of Fluid-Flow Machinery Polish Academy of Sciences

Date

2016

Type

Artykuły / Articles

Identifier

DOI: 10.1515/aoter-2016-0001

Source

Archives of Thermodynamics; 2016; No 1; 3-16

References

CavalliniA (2003), Condensation inside and outside smooth and enhanced tubes a review of recent research, Int J Refrigeration, 26, 373, doi.org/10.1016/S0140-7007(02)00150-0 ; ZhangM (2001), Correlation of two - phase friction for refrigerants in small - diameter tubes, Exp Therm Fluid Sci, 25, 131, doi.org/10.1016/S0894-1777(01)00066-8 ; SaitohS (2007), Correlation for boiling heat transfer of R - a in horizontal tubes including effect of tube diameter, Int J Heat Mass Tran, 50, 5215, doi.org/10.1016/j.ijheatmasstransfer.2007.06.019 ; BielińskiH (2004), The effect of geometrical parameters on the mass flux in a two phase thermosyphon loop heated from one side, Arch Thermodyn, 29, 59. ; BielińskiH (2004), Natural circulation in two - phase thermosyphon loop heated from below, Arch Thermodyn, 25, 15. ; BielińskiH (1995), Natural convection of thermal diode, Arch Thermodyn, 16. ; MikielewiczD (2010), The new concept of capillary forces aided evaporator for application in domestic organic Rankine cycle Heat Pipe Sci, Int J Techn, 1, 359. ; MikielewiczD (2007), Improwed semi - empirical method for determination of heat transfer coefficient in flow boiling in conventional and small diameter tubes, Int J Heat Mass Tran, 50, 3949, doi.org/10.1016/j.ijheatmasstransfer.2007.01.024 ; El (2003), Condensation in horizontal tubes part Two - phase flow pattern map, Int J Heat Mass Tran, 46, 1. ; BielińskiH (2010), Computer cooling using a two phase minichannel thermosyphon loop heated from horizontal and vertical sides and cooled from vertical side, Arch Thermodyn, 31, 51. ; TranT (2000), Two phase pressure drop of refrigerants during flow boiling in small channels : an experimental investigations and correlation development, Int J Multiphas Flow, 26, 1739, doi.org/10.1016/S0301-9322(99)00119-6 ; BlanchardD (2004), Performance and Development of a Miniature Rotary Shaft Pump In Expo Nov Anaheim California, Proc Int Mech Eng Cong USA, 13. ; MadejskiJ (1971), Liquid fin a new device for heat transfer equipment, Int J Heat Mass Tran, 14, 357, doi.org/10.1016/0017-9310(71)90155-4 ; BielińskiH (2001), New solutions of thermal diode with natural laminar circulation, Arch Thermodyn, 22, 1. ; ShahM (1979), A general correlation for heat transfer during film condensation inside pipes, Int J Heat Mass Tran, 22, 547, doi.org/10.1016/0017-9310(79)90058-9 ; BielińskiH (2011), Natural circulation in single and two phase thermosyphon loop with conventional tubes and minichannels In : Heat Transfer Modeling Numerical Methods and Information Technology Belmiloudi Ed ISBN, Mathematical InTech, 978. ; AgostiniF (2011), Non intrusive measurement of the mass flow rate inside a closed loop two - phase thermosyphon th Minsk Int Heat Pipes , Heat Pumps Refrigerators Minsk, In Proc Sem Power Sources Sept, 12, 8. ; BielińskiH (2010), Energetic analysis of natural circulation in the closed loop thermosyphon with minichannels, Arch Energ, 40. ; KhodabandehR (2005), Heat transfer in the evaporator of an advanced two - phase thermosyphon loop, Int J Refrig, 28, 190, doi.org/10.1016/j.ijrefrig.2004.10.006

Editorial Board

International Advisory Board

J. Bataille, Ecole Central de Lyon, Ecully, France

A. Bejan, Duke University, Durham, USA

W. Blasiak, Royal Institute of Technology, Stockholm, Sweden

G. P. Celata, ENEA, Rome, Italy

L.M. Cheng, Zhejiang University, Hangzhou, China

M. Colaco, Federal University of Rio de Janeiro, Brazil

J. M. Delhaye, CEA, Grenoble, France

M. Giot, Université Catholique de Louvain, Belgium

K. Hooman, University of Queensland, Australia

D. Jackson, University of Manchester, UK

D.F. Li, Kunming University of Science and Technology, Kunming, China

K. Kuwagi, Okayama University of Science, Japan

J. P. Meyer, University of Pretoria, South Africa

S. Michaelides, Texas Christian University, Fort Worth Texas, USA

M. Moran, Ohio State University, Columbus, USA

W. Muschik, Technische Universität Berlin, Germany

I. Müller, Technische Universität Berlin, Germany

H. Nakayama, Japanese Atomic Energy Agency, Japan

S. Nizetic, University of Split, Croatia

H. Orlande, Federal University of Rio de Janeiro, Brazil

M. Podowski, Rensselaer Polytechnic Institute, Troy, USA

A. Rusanov, Institute for Mechanical Engineering Problems NAS, Kharkiv, Ukraine

M. R. von Spakovsky, Virginia Polytechnic Institute and State University, Blacksburg, USA

A. Vallati, Sapienza University of Rome, Italy

H.R. Yang, Tsinghua University, Beijing, China



×