All Printed Edge-Triggered Register Using Single Walled Carbon Nanotube-Based Thin Film Transistor
We have studied the fabrication of Single Walled Carbon Nanotube (SWNT)-based Thin Film Transistors (TFTs) using Roll-to-Roll (R2R) gravure printer and inkjet printer on PET foils to show the possibility of printed electronics in point of mass production and low cost. In this paper,
for realization of all printed multi-bits digital circuit, all printed positive-edge triggered master–slave D flip–flop (DFF) was fabricated on PET foil using printed SWNT TFTs. The printed DFF, consists of 8 NAND gates and 4 inverters, exhibit propagation delay of 75 ms
at the input clock signal of 5 Hz.
Document Type: Research Article
Publication date: 01 May 2012
- Journal for Nanoscience and Nanotechnology (JNN) is an international and multidisciplinary peer-reviewed journal with a wide-ranging coverage, consolidating research activities in all areas of nanoscience and nanotechnology into a single and unique reference source. JNN is the first cross-disciplinary journal to publish original full research articles, rapid communications of important new scientific and technological findings, timely state-of-the-art reviews with author's photo and short biography, and current research news encompassing the fundamental and applied research in all disciplines of science, engineering and medicine.
- Editorial Board
- Information for Authors
- Subscribe to this Title
- Terms & Conditions
- Ingenta Connect is not responsible for the content or availability of external websites
- Access Key
- Free content
- Partial Free content
- New content
- Open access content
- Partial Open access content
- Subscribed content
- Partial Subscribed content
- Free trial content