Abstract
The structural and phase composition and magnetostatic and microwave properties of powders produced by simultaneous milling of carbonyl iron and paraffin taken in volume ratios ranging from 10 : 90 to 80 : 20 have been studied. It has been shown that the shape of the powder particles depends substantially on the amount of Fe in the mixture. At an Fe content of 30 vol %, the particles acquire a platelet shape; at an Fe content of more than 40 vol %, the agglomeration of the particles is observed. At an Fe content above 30 vol %, the Fe3C phase is formed in the particles, which leads to an increase in the coercive force and a decrease in the specific saturation magnetization of the powder. The frequency dependences of the microwave magnetic and dielectric permeabilities of the composite materials containing the prepared powders have been measured, and the frequency dependences of the intrinsic magnetic permeability of these powders have been determined. It has been shown that the static magnitude of the intrinsic magnetic permeability reaches a maximum in powders containing 30 vol % Fe in the initial mixture.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
J. H. He, W. Wang, and J. G. Guan, “Internal strain dependence of complex permeability of ball milled carbonyl iron powders in 2–18 GHz,” J. Appl. Phys. 111, 093924 (2012).
Z. Raolison, C. Lefevre, J. Neige, A.-L. Adenot-Engelvin, G. Pourroy, and N. Vukadinovic, “Preparation and microwave properties of silica-coated Ni-Fe-Mo flake composites,” IEEE Trans. Magn. 49, 986–989 (2013).
F. Ma, Y. Qin, and Y. Z. Li, “Enhanced microwave performance of cobalt nanoflakes with strong shape anisotropy,” Appl. Phys. Lett. 96, 202507 (2010).
Z. W. Li, Z. H. Yang, and L. B. Kong, “Ultrabroad bandwidth of single-layer electromagnetic attenuation composites with flaky fillers,” Appl. Phys. Lett. 96, 092507 (2010).
M. Han, D. Liang, K. N. Rozanov, and L. Deng, “Microwave permeability and Mössbauer spectra of flaky Fe-Si-Al particles,” IEEE Trans. Magn. 49, 982–985 (2013).
O. V. Ermakov, O. I. Kolesova, and A. V. Raevskii, “Change in UHF magnetic permeability of carbonyl iron subjected to mechanical comminution,” Phys. Met. Metallogr. 81, 249–254 (1996).
E. P. Elsukov, K. N. Rozanov, S. F. Lomaeva, A. V. Osipov, D. A. Petrov, D. V. Surnin, A. A. Chulkina, and A. S. Shuravin, “Structure, magnetostatic properties, and microwave characteristics of mechanoactivated nanocrystalline Fe and Fe-Si powders,” Phys. Met. Metallogr. 104, 248–256 (2007).
E. Yu. Gerashchenkova, E. A. Samodelkin, P. A. Kuznetsov, M. S. Pervukhina, and N. V. Yakovleva, “Study of the mechanism of universal superfast disintegration-activation treatment for the production of soft-magnetic powder materials from amorphous ribbon of Fe-Cu-Nb-Si-B alloy,” Vopr. Materialoved., No. 1, 102–112 (2013).
E. P. Elsukov, K. N. Rozanov, S. F. Lomaeva, A. V. Osipov, D. A. Petrov, A. S. Shuravin, A. A. Chulkina, G. N. Konygin, and A. L. Ul’yanov, “Microwave absorbing properties of Fe powders milled in various media,” Phys. Met. Metallogr. 106, 465–471 (2008).
K. N. Rozanov, A. V. Osipov, D. A. Petrov, S. N. Starostenko, and E. P. Yelsukov, “The effect of shape distribution of inclusions on the frequency dependence of permeability in composites,” J. Magn. Magn. Mater. 321, 738–741 (2009).
K. N. Rozanov, M. Y. Koledintseva, and J. L. Drewniak, “A mixing rule for predicting of frequency dependence of material parameters in magnetic composites,” J. Magn. Magn. Mater. 324, 1063 (2012).
D. J. Bergman and D. Stroud, “Physical properties of macroscopically inhomogeneous media,” Solid. State Phys.: Adv. Res. Appl. 46, 147–269 (1992).
A. N. Maratkanova, S. F. Lomayeva, D. A. Petrov, K. N. Rozanov, A. A. Chulkina, O. M. Nemtsova, and E. P. Yelsukov, “Microwave properties of mechanosynthesized Fe-paraffin nanocomposites,” Solid State Phenom. 168-169, 345–348 (2011).
E. V. Voronina, N. V. Ershov, A. L. Ageev, and Yu. A. Babanov, “Regular algorithm for the solution of the inverse problem in Mössbauer spectroscopy,” Phys. Status Solidi B 160, 625–634 (1990).
K. N. Rozanov, N. A. Simonov, and A. V. Osipov, “Microwave measurements of the magnetic film permeability,” J. Commun. Technol. Electr. 47, 210–216 (2002).
E. P. Yelsukov, G. A. Dorofeev, A. V. Zagainov, N. F. Vildanova, and A. N. Maratkanova, “Initial stage of mechanical alloying in the Fe-C system,” Mater. Sci. Eng., A 369, 16–22 (2004).
T. Bellini, F. Mantegazza, V. Degiorgio, V. R. Avallone, and D. A. Saville, “Electric polarizability of polyelectrolytes: Maxwell-Wagner and electrokinetic relaxation,” Phys. Rev. Lett. 82, 5160 (1999).
S. B. Wilson, “Modal analysis of the “gap effect” in waveguide,” IEEE Trans. Microw. Theor. Tech. 36, 752–756 (1998).
A. V. Osipov, K. N. Rozanov, N. A. Simonov, and S. N. Starostenko, “Reconstruction of intrinsic parameters of a composite from the measured frequency dependence of permeability,” J. Phys.: Condens. Matter. 14, 9507 (2002).
K. Miyasaka, K. Watanabe, E. Jojima, H. Aida, M. Sumita, and K. Ishikawa, “Electrical conductivity of carbon-polymer composites as a function of carbon content,” J. Mater. Sci. 17, 1610–1616 (1982).
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © K.N. Rozanov, D.A. Petrov, A.N. Maratkanova, A.A. Chulkina, S.F. Lomayeva, 2014, published in Fizika Metallov i Metallovedenie, 2014, Vol. 115, No. 7, pp. 682–690.
Rights and permissions
About this article
Cite this article
Rozanov, K.N., Petrov, D.A., Maratkanova, A.N. et al. Microwave properties of powders produced by high-energy milling of iron with paraffin. Phys. Metals Metallogr. 115, 642–649 (2014). https://doi.org/10.1134/S0031918X14040139
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0031918X14040139