Issue 45, 2015

Optimisation of the process variables in production of activated carbon by microwave heating

Abstract

This study aims to investigate the optimal operating conditions in order to obtain cost effective production of activated carbon (AC) from palm kernel shell (PKS) by microwave heating. Interactions among the independent variables, namely irradiation time (T), microwave power (W), impregnation ratio between impregnating substances and PKS, and the concentration of impregnating substance (sulphuric acid) were considered for optimising the process parameters during the production of AC, aided by Central Composite Design. The optimum conditions for the independent process variables were 11.02 minutes of irradiation time, microwave power of 676 W and impregnation ratio of 0.68. The AC produced in this work had a surface area of 1011 m2 g−1 with high porosity as shown by scanning electron microscopy (SEM). Zinc was used to verify the potential of AC as an adsorbent. Zinc removal at the optimum conditions was found to be 13.72 mg g−1. Such a Zn removal value is comparable with the earlier work of other researchers who used a conventional way of producing the AC. It is believed that microwave technology can be used for the production of AC in a short time with high energy efficiency, e.g., 11 minutes against 2–5 hours of reactivation for conventional methods.

Graphical abstract: Optimisation of the process variables in production of activated carbon by microwave heating

Article information

Article type
Paper
Submitted
23 Dec 2014
Accepted
10 Apr 2015
First published
10 Apr 2015

RSC Adv., 2015,5, 35899-35908

Author version available

Optimisation of the process variables in production of activated carbon by microwave heating

A. Kundu, B. S. Gupta, M. A. Hashim, J. N. Sahu, M. Mujawar and G. Redzwan, RSC Adv., 2015, 5, 35899 DOI: 10.1039/C4RA16900J

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements