Abstract
Purpose. To obtained rate constants from weight-averaged (Mw) or z-averaged (Mz) molecular weights for polymers of Schule-Flory distribution and undergoing random scission. These constants were compared with those obtained by parallel 1HNMR studies.
Methods. The hydrolysis of two poly(ortho ester)s were followed by 1HNMR and gel permeation chromatography (GPC).
Results. Equations to convert number-averaged (Mn), Mw and Mz into fraction of backbone remaining (fc) were derived. First-order hydrolytic rate constants of two poly(ortho ester)s; DETOSU-HD and DETOSU-CDM were calculated using these relationships. The rate constants calculated from 1HNMR, Mz and Mw were 0.215, 0.218 and 0.182 hr−1, respectively, for DETOSU-CDM and 0.152, 0.086 and 0.038 hr−l for DETOSU-HD. The large discrepancy in the rates determined by 1HNMR and GPC in the latter case was attributed to that the detector response (refractive index) of the monomers was lower than that of the high molecular weight polymer. The difference is small in the case of DETOSU-CDM, and the rates calculated from GPC data were comparable or nearly identical to that obtained from 1HNMR data.
Conclusions. Although GPC can yield rapid and valuable kinetic data for the degradation of biodegradable polymers, the system, however, must be carefully calibrated to account for the variations in Mark-Houwink coefficients and in the response of the mass detector between the high and low MW polymers.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
REFERENCES
C. Shih, J. Fix, and R.L. Seward. In vivo and in vitro release of ivermectin from poly(ortho ester) matrices. I. Crosslinked matrix prepared from ketene acetal end-capped prepolymer. J. Controlled Release 25:155–162 (1993).
C. Pitt. Poly(ε-caprolactone) and its copolymers. In M. Chasin and R. Langer, (eds.) Biodegradable polymer, Marcel-Deckker, New York, New York (1990), pp. 97–103.
R.A. Kenley, M.O. Lee, T.R. Mahoney, II, and L.M. Sanders. Poly(lactide-co-glycolide) decomposition kinetics in vivo and in vitro. Macromolecules 20:2398–2403 (1987).
E.A. Schmitt, D.R. Flanagan and R. Linhardt. Degradation and release properties of pellets fabricated from three commercial poly(D,L-lactide-co-glycolide) biodegradable polymers. J. Pharm. Sci. 82:326–329 (1993).
J. Helder, P.J. Dijkstra and J. Feijen. In vitro degradation of glycin/D,L-lactic acid copolymers. J. Biomed. Materials Res. 24:1005–1020 (1990).
F.W. Billmeyer, Jr. Textbook of polymer science, second edition, Wiley-Interscience, New York, 1971, pp. 53–56.
A.E. Hamielec, A.C. Ouano and L.L. Nebenzahl. Characterization of branched poly(vinyl acetate) by GPC and low angle light scattering photometry. J. Liq. Chromatography 1:527–554 (1978).
J.A.P.P. Van Dijk, J.A.M. Smit, F.E. Kohn and J. Feijen. Characterization of poly(D,L-lactic acid) by gel permeation chromatography. J. Polym. Sci. 21:197–208 (1983).
C.A. Pryde, P.G. Kelleher, M.Y. Hellman and R.P. Wentz. The hydrolytic stability of some commercially available polycarbonates. Polym. Eng. and Sci. 22:370–375 (1982).
J. Heller, D.W.H. Penhale and R.F. Helwing. Preparation of poly(ortho esters) by the reaction of ketene acetals and polyols. J. Polym. Sci., Polym. Lett. Ed. 18:82–83 (1980).
J. Brandrup and E.H. Immergut. Polymer Handbook, second edition, John Wiley & Sons, New York, 1975, p. IV-288.
C. Shih. A graphical method for the determination of the mode of scission in the hydrolysis of biodegradable polymers. Submitted for publication in the Journal of Pharmaceutical Research.
W. Kuhn. Über die kinetik des abbanes hochmolekularer ketten. Ber. 63B:1503–1509 (1930).
H.H.G. Jellinek. Degradation and depolymerization kinetics. In H.H.G. Jellinek (ed.), Aspects of degradation and stabilization of polymers, Elsevier Scientific Publishing Company, New York, 1978, pp. 1–38.
G. Grancher. A stochastic model for oligomers produced by degradation of linear polymers. In M. Vert, J. Feijen, A. Albertsson, G. Scott, and E. Chiellini (eds.), Biodegradable Polymers and Plastics, The Royal Society of Chemistry, Cambridge, 1992, pp. 191–199.
M.L. Wolfram, D.R. Myers and E.N. Lassettre. The molecular size of starch by the mercaptalation method. J. Am. Chem. Soc. 61:2172–2175 (1939).
W.J. Tchir, A. Rudin and C.A. Fyfe. Effects of data analysis on accuracy and precision of GPC results. J. Polym. Sci., Polym, Phys. Ed. 20:1443–1451 (1982).
E.W. Montroll and R. Simha. Theory of depolymerization of long chain molecules. J. Chem. Phys. 8:721–727 (1940).
I. Sakurada and S. Okamura. Über die abban langer ketten förmiger Moleküle. Z. Physik. Chem. 187A:289–296 (1940).
M. Inokuti. Weight-average and z-averaged degree of polymerization for polymers undergoing random scission. J. Chem. Phys. 28:1174–1178 (1963).
P. Flory. Principles of Polymer Chemistry, Cornell University Press, Ithaca, New York, 1953, pp. 318–326.
C. Shih, T. Higuchi and K.J. Himmelstein. Drug delivery from catalysed erodible polymeric matrices of poly(ortho ester)s. Biomaterials 5:237–240 (1984).
M.A. Haney, and J.E. Armones and L. Rosen. Gel permeation chromagraphy — viscometry of polystyrene standards in tetrahydrofuran. In T. Provider (ed), Detection and data analysis in size exclusion chromatography. ACS Symposium series 352:119–129 (1987).
E.M. Barrall, II, M.J.R. Cantow and J.F. John. Variation of refractive index of polystyrene with molecular weight: Effect on the determination of molecular weight distribution. J. Applied Polym. Sci. 12:1373–1377 (1968).
P.C. Heimenz. Polymer Chemistry — The Basic Concept, Marcel-Dekker, New York, 1984, pp 37–38.
Rights and permissions
About this article
Cite this article
Shih, C. Calculation of Hydrolytic Rate Constants of Poly(ortho ester)s from Molecular Weights Determined by Gel Permeation Chromatography. Pharm Res 12, 2041–2048 (1995). https://doi.org/10.1023/A:1016229014535
Issue Date:
DOI: https://doi.org/10.1023/A:1016229014535