Effect of heat treatment conditions on microstructure and wear behaviour of Al4Cu2Ni2Mg alloy
References (21)
- et al.
Microstructural evolution of nanostructure 7075 aluminum alloy during isothermal annealing [J]
Journal of Alloys and Compounds
(2010) - et al.
Synthesis and characterization of high volume fraction Al-Al2O3 nanocomposite powders by high-energy milling [J]
Materials Science and Engineering A
(2006) - et al.
Mechanical behaviour of the interphase between matrix and reinforcement of Al 2014 matrix composites reinforced with (Ni3Al)p [J]
Composites Part A: Applied Science and Manufacturing
(2002) - et al.
Effect of Al-TiB master alloy addition on microstructure, wear and compressive deformation behaviour of aluminum alloys [J]
Transactions of Nonferrous Metals Society of China
(2012) - et al.
Interrelationship between matrix microhardness and ultimate tensile strength of discontinuous particulate-reinforced aluminum alloy composites [J]
Materials Letters
(2001) - et al.
Tribological behaviour of cast hypereutectic Al-Si-Cu alloy subjected to sliding wear [J]
Wear
(2009) - et al.
Effect of iron-rich intermetallics on the sliding wear behavior of Al-Si alloys [J]
Materials Science and Engineering A
(2008) The effect of heat-treatment on aluminum-based piston alloys [J]
Materials and Design
(2007)- et al.
A characterization of the inhibiting effect of Cu on metastable pitting in dilute Al-Cu solid solution alloys [J]
Electrochimica Acta
(2007) - et al.
Constituent phase diagrams of the Al-Cu-Fe-Mg-Ni-Si system and their application to the analysis of aluminium piston alloys [J]
Acta Materialia
(2005)
There are more references available in the full text version of this article.
Cited by (0)
Copyright © 2013 The Nonferrous Metals Society of China. Published by Elsevier Ltd. All rights reserved.