Abstract
This paper describes the grain refinement due to equal-channel angular pressing (ECAP) and the creep properties of the ECAP-processed AZ91 magnesium alloy. The resulting microstructure and creep properties were examined by scanning electron microscope and impression creep test method. Microstructural evolution reveals that the grains were refined to 14 µm after four ECAP passes at 628 K, following route Bc. The creep tests were carried out under stresses in the range of 35 to 95 MPa at temperatures in the range of 538 to 583 K. Based on a power law between the impression rate and stress, the stress exponents were about 2 and the activation energies were about 129 kJ/mol, which are close to that for lattice diffusion of magnesium. Considering the obtained results, it can be stated that the grain boundary sliding is the dominant creep mechanism at low stresses and high temperatures.
Graphic Abstract
Deformation mechanism is grain boundary sliding (GBS) during creep of the AZ91 alloy at low stresses and high temperature and deformation behavior can be determined from:
Similar content being viewed by others
References
X.U. Yan, L.X. Hu, S.U.N. Yu, J.B. Jia, J.F. Jiang, Trans. Nonferrous Met. Soc. China 25, 381 (2015)
X.C. Luo, D.T. Zhang, W.W. Zhang, C. Qiu, D.L. Chen, Mater. Sci. Eng., A 725, 398 (2018)
G. Zeng, C. Liu, Y. Wan, Y. Gao, S. Jiang, Z. Chen, Mater. Sci. Eng., A 734, 59 (2018)
B.L. Mordike, T. Ebert, Mater. Sci. Eng., A 302, 37 (2001)
M. Celikin, M. Pekguleryuz, in TMS Annual Meeting & Exhibition (Springer, Cham, 2018), p. 337
D.H. Hou, S.M. Liang, R.S. Chen, C. Dong, E.H. Han, Acta Metall. Sin. (Engl. Lett.) 28, 115 (2015)
B.A. Esgandari, H. Mehrjoo, B. Nami, S.M. Miresmaeili, Mater. Sci. Eng., A 528, 5018 (2011)
R. Panicker, A.H. Chokshi, R.K. Mishra, R. Verma, P.E. Krajewski, Acta Mater. 57, 3683 (2009)
J. Xu, X. Wang, X. Zhu, M. Shirooyeh, J. Wongsa-Ngam, D. Shan, B. Guo, T.G. Langdon, J. Mater. Sci. 48, 4117 (2013)
Y. Yuan, A. Ma, X. Gou, J. Jiang, G. Arhin, D. Song, H. Liu, Mater. Sci. Eng., A 677, 125 (2016)
R.Z. Valiev, Y. Estrin, Z. Horita, T.G. Langdon, M.J. Zechetbauer, Y.T. Zhu, JOM 58, 33 (2006)
T.G. Langdon, Mater. Sci. Eng., A 462, 3 (2007)
R.Z. Valiev, T.G. Langdon, Prog. Mater Sci. 51, 881 (2006)
A. Yamashita, D. Yamaguchi, Z. Horita, T.G. Langdon, Mater. Sci. Eng., A 287, 100 (2000)
R.B. Figueiredo, T.G. Langdon, J. Mater. Sci. 43, 7366 (2008)
P.S. Roodposhti, A. Sarkar, K.L. Murty, H. Brody, R. Scattergood, Mater. Sci. Eng., A 669, 171 (2016)
M. Alvarez-Leal, A. Orozco-Caballero, F. Carreno, O.A. Ruano, Mater. Sci. Eng., A 710, 240 (2018)
Y.H. Wei, Q.D. Wang, Y.P. Zhu, H.T. Zhou, W.J. Ding, Y. Chino, M. Mabuchi, Mater. Sci. Eng., A 360, 107 (2003)
R.B. Figueiredo, T.G. Langdon, Mater. Sci. Eng., A 501, 105 (2009)
L. Li, W. Wei, Y. Lin, C. Lijia, L. Zheng, J. Mater. Sci. 41, 409 (2006)
K. Kubota, M. Mabuchi, K. Higashi, J. Mater. Sci. 34, 2255 (1999)
B. Nami, H. Razavi, S. Mirdamadi, S.G. Shabestari, S.M. Miresmaeili, Metall. Mater. Trans. A 41, 1973 (2010)
F. Kabirian, R. Mahmudi, Metall. Mater. Trans. A 40, 116 (2009)
R. Jahadi, M. Sedighi, H. Jahed, Mater. Sci. Eng., A 593, 178 (2014)
S.H. Kang, Y.S. Lee, J.H. Lee, J. Mater. Process. Technol. 201, 436 (2008)
K.R. Gopi, H.S. Nayaka, S. Sahu, J. Mater. Eng. Perform. 26, 3399–3409 (2017)
S.B. Xu, Q.I.N. Zhen, L.I.U. Ting, C.N. Jing, G.C. Ren, Trans. Nonferrous Met. Soc. China 22, 61 (2012)
X.M. Feng, T.T. Ai, Trans. Nonferrous Met. Soc. China 19, 293–298 (2009)
C.W. Chung, R.G. Ding, Y.L. Chiu, W. Gao, J. Phys: Conf. Ser. 241, 012101 (2010)
Y. Yuan, A. Ma, J. Jiang, F. Lu, W. Jian, D. Song, Y.T. Zhu, Mater. Sci. Eng., A 588, 329 (2013)
B. Chen, D.L. Lin, L. Jin, X.Q. Zeng, C. Lu, Mater. Sci. Eng., A 483, 113 (2008)
K. Ishikawa, H. Watanabe, T. Mukai, Mater. Lett. 59, 1511 (2005)
F. Yang, J.C. Li, Mater. Sci. Eng., R 74, 233 (2013)
E.M. Mazraeshahi, B. Nami, S.M. Miresmaeili, Mater. Des. 51, 427 (2013)
R.J. Nabariya, S. Goyal, M. Vasudevan, N. Arivazhagan, Mater. Today Proc. 5, 12320 (2018)
M.E. Kassner, M.T. Perez-Prado, Fundamentals of Creep in Metals and Alloys, 1st edn. (Elsevier Science, Amsterdam, 2004)
A. Heczel, F. Akbaripanah, M.A. Salevati, R. Mahmudi, A. Vida, J. Gubicza, J. Alloys Compd. 763, 629 (2018)
M. Janeček, J. Čížek, J. Gubicza, J. Vrátná, J. Mater. Sci. 47, 7860 (2012)
J.N. Wang, A.J. Schwartz, T.G. Nieh, D. Clemens, Mater. Sci. Eng., A 206, 63 (1996)
R. Mahmudi, R. Alizadeh, A.R. Geranmayeh, Scr. Mater. 64, 521 (2011)
H. Somekawa, K. Hirai, H. Watanabe, Y. Takigawa, K. Higashi, Mater. Sci. Eng. A 407, 53 (2005)
S.M. Miresmaeili, B. Nami, Mater. Des. 56, 286 (2014)
B. Kondori, R. Mahmudi, Mater. Sci. Eng., A 700, 438 (2017)
S.N.G. Chu, J.C.M. Li, J. Mater. Sci. 12, 2200 (1977)
J.C. Li, Mater. Sci. Eng., A 322, 23 (2002)
S.M. Miresmaeili, B. Nami, R. Abbasi, I. Khoubrou, JOM 71, 2128–2135 (2019)
S. Ganguly, A.K. Mondal, Mater. Sci. Eng., A 718, 377 (2018)
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Khoubrou, I., Nami, B. & Miresmaeili, S.M. Investigation on the Creep Behavior of AZ91 Magnesium Alloy Processed by Severe Plastic Deformation. Met. Mater. Int. 26, 196–204 (2020). https://doi.org/10.1007/s12540-019-00318-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12540-019-00318-y