Abstract
Thermodynamic irreversibility in the flow system provides information on the energy and power losses in the system. Minimization of entropy generation in the flow system enables for the parametric optimization of the system operation. In the present study, parallel plates, in between, filled with the fluid are considered. The fluid motion resulted from the bi-vertical compression of the top plate of the parallel plates is examined. The entropy generation rate in the flow system is formulated after considering the constant movement of the top plate, constant applied load, and the combination of the constant velocity and applied load to the top plate. The optimum operating conditions related to the fluid motion in between the parallel plates is determined through the entropy analysis. It is found that the combination of the constant velocity and the constant applied load resulted in the low entropy generation rate.
Similar content being viewed by others
References
Demirel Y 2000 Thermodynamic analysis of thermomechanical coupling in Couette flow. Int. J. Heat and Mass Transfer 43(22): 4205–4212
Denn M 1998 Process Fluid Mechanics, (New York: Prentice Hall)
Erbay L B, Ercan M S, Sulus B, Yalcin M M 2003 Entropy generation during fluid flow between two parallel plates with moving bottom plate. Entropy 5(5)
Esfahani J A, Jafarian M M 2005 Entropy generation analysis of a flat plate boundary layer with various solution methods. Scientia Iranica 12(2): 233–240
Farkas J, Simoes L M C V, Jamai K 2005 Minimum cost design of a welded stiffened square plate loaded by biaxial compression. Structural and Multidisciplinary Optimization 29(4): 298–303
Lin W W, Lee D J 2000 Second-law analysis on a flat plate fin array under crossflow. International Communications in Heat and Mass Transfer 27(2): 179–190
Ordonez J C, Bejan A 2000 Entropy generation minimization in parallel-plates counterflow heat exchangers. Int. J. Energy Res. 24(10): 843–864
Ratts E B, Brown J S 2004 Laminar entropy generation over a flat plate with isothermal and constant heat flux boundary conditions using the von Karman integral method, In: Proceedings of the ASME Heat Tranfer/Fluids Engineering Summer Conference, HT/FED 2004, Charlotte, NC, USA 1: 61–69
Takeda Y 1999 Quasi-periodic state and transition to turbulence in a rotating Couette system. J. Fluid Mechanics 389: 81–99
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sahin, A.Z., Yilbas, B.S. Entropy generation in the flow system generated in between two parallel plates due to bivertical motion of the top plate. Sadhana 34, 455–466 (2009). https://doi.org/10.1007/s12046-009-0021-1
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12046-009-0021-1