Skip to main content
Log in

Study of Defects in the Petrochemical Storage Tank Floor using the Magnetic Flux Leakage (MFL) Technique

  • Technical Article---Peer-Reviewed
  • Published:
Journal of Failure Analysis and Prevention Aims and scope Submit manuscript

Abstract

In this work, the magnetic flux leakage (MFL) technique has been used for analyzing the defects in the floor of a petrochemical storage tank. Tank floors are more vulnerable to many damages because of the stored materials. The chemical reaction that occurs between the stored substances and the floor causes the floor to corrode easily. Mostly, tank floors are made up of ferromagnetic materials and to inspect these floors the MFL technique is preferred. Here, a robotic MFL system is designed to interrogate the defects through flux leakage, because it improves the health and safety inspection in hazardous working environments. This system has two major units namely the power and the detection unit. The robot’s displacement is controlled by the power unit and the detection unit is responsible for the defect analysis. Two types of defects such as grooves and holes were introduced in the low carbon steel plate. The plate is electro magnetized and for every movement of the robot, the respective magnetic flux is sensed by the Hall sensor. The acquired data are plotted with the help of Arduino connecting to the computer. Thus, by analyzing the plotted waveform graph, the defects were detected due to the leakage of magnetic flux at the defect region with good signal-to-noise ratio. And error percentage was calculated within 10% for the measured signal.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8

Similar content being viewed by others

References

  1. D. Probert, Design and performance of hot-oil storage tanks. Appl. Energy. 1(4), 247–278 (1975)

    Article  Google Scholar 

  2. P.C. Porter, Use of magnetic flux leakage (MFL) for the inspection of pipelines and storage tanks. Nondestruct. Eval. Aging Util. 2454, 172–184 (1995)

    Article  Google Scholar 

  3. N. Anvo, Internal in-service inspection of petrochemical storage tank floors to detect underside corrosion with Non-Destructive Testing Robot. London South Bank University (2018)

  4. F.W. Luo, R. Ran, L. Wang, Study on corrosion law of large crude oil storage tank floor and risk-based inspection and maintenance technology. Corros. Sci. Technol. 19(2), 66–74 (2020)

    Google Scholar 

  5. H.M. Kim, Y.W. Rho, H.R. Yoo, S.H. Cho, D.K. Kim, S.J. Koo, G.S. Park, in A study on the measurement of axial cracks in the magnetic flux leakage NDT system. IEEE Int. Autom. Sci. Eng. (CASE), pp. 624–629 (2012)

  6. O.C. Sheng, W.K. Ngui, H.K. Hoou, L.M. Hee, M.S. Leong, Review of underground storage tank condition monitoring techniques. MATEC Web Conf. 255, 02009 (2019)

    Article  Google Scholar 

  7. R. Bogue, Applications of robotics in test and inspection. Ind. Robot Int. J. 45(2), 169–174 (2018)

    Article  Google Scholar 

  8. T. Singh, D.R. Tiwari, P. Anand, M. Raza, R.K. Singh, S. Sharma, Pipe inspection robot, invertis. J. Sci. Technol. 2(2), 34–36 (2019)

    Article  Google Scholar 

  9. X.C. Song, S.L. Huang, W. Zhao, Optimization of the magnetic circuit in the MFL inspection system for storage-tank floors. Russ. J. Nondestr. Test. 43(5), 326–331 (2007)

    Article  Google Scholar 

  10. F.J. Liu, Z.W. Ling, S. Kong, M.L. Zheng, Application of zero-phase digital filter in magnetic flux leakage testing for tank floor inspection. Appl. Mech. Mater. 333, 1644–1648 (2013)

    Article  Google Scholar 

  11. J.I. Chang, C.C. Lin, A study of storage tank accidents. J. Loss Prev. Process Ind. 19(1), 51–59 (2006)

    Article  Google Scholar 

  12. L.H. Dong, B.S. Xu, S.Y. Dong, Q.Z. Chen, Y.Y. Wang, L. Zhang, D. Wang, D.W. Yin, Metal magnetic memory testing for early damage assessment in ferromagnetic materials. J. Cent. South Univ. Technol. 12(2), 102–106 (2005)

    Article  CAS  Google Scholar 

  13. P.S. Lowe, W. Duan, J. Kanfoud, T.-H. Gan, ‘Structural health monitoring of above-ground storage tank floors by ultrasonic guided wave excitation on the tank wall. Sensors. 17(11), 2542 (2017)

    Article  Google Scholar 

  14. H. Bi, H. Li, W. Zhang, L. Wang, Q. Zhang, S. Cao, I. Toku-Gyamerah, Evaluation of the acoustic emission monitoring method for stress corrosion cracking on aboveground storage tank floor steel. Int. J. Press. Vessels Pip. 179, 104035 (2020)

    Article  Google Scholar 

  15. S. Ding, F. Liu, Y. Xu, X. Guo, Nondestructive testing technique for atmospheric storage tanks. ASME Press. Vessels Pip. Conf. 48241, 509–517 (2008)

    Google Scholar 

  16. M.R. Kandroodi, B.N. Araabi, M.N. Ahmadabadi, F. Shirani, M.M. Bassiri, in Detection of natural gas pipeline defects using magnetic flux leakage measurements. Proc. 21st Iranian Conf. Elect. Eng. (ICEE), pp. 1–6 (2013)

  17. M.M. Salama, B.J. Nestleroth, M.A. Maes, C. Rodriguez, D. Blumer, in Characterization of the accuracy of the MFL pipeline inspection tools. Proc. 31st Int. Conf. Ocean Offshore Arctic Eng., vol. 6, pp. 247–251 (2012)

  18. Z. Deng, Y. Sun, Y. Yang, Y. Kang, Effects of surface roughness on magnetic flux leakage testing of micro-cracks. Meas. Sci. Technol. 28(4), 045003 (2017)

    Article  Google Scholar 

  19. X. Peng, U. Anyaoha, Z. Liu, K. Tsukada, Analysis of magnetic-flux leakage (MFL) data for pipeline corrosion assessment. IEEE Trans. Magn. 56(6), 1–15 (2020)

    Article  Google Scholar 

  20. M.M. Tehranchi, M. Ranjbaran, H. Eftekhari, Double core giant magneto-impedance sensors for the inspection of magnetic flux leakage from metal surface cracks’. Sens. Actuators A Phys. 170(1–2), 55–61 (2011)

    Article  CAS  Google Scholar 

  21. F. Niese, A. Yashan, H. Willems, Wall thickness measurement sensor for pipeline inspection using EMAT technology in combination with pulsed eddy current and MFL’. Proc. ECNDT. 18, 45–52 (2006)

    Google Scholar 

  22. P.E. Mix, Introduction to nondestructive testing: a training guide. (Wiley, New York, 2005)

    Google Scholar 

  23. M. Yilai, L. Li, G. Po, G. Xuan, Improving SNR of MFL detecting defect signal of drill pipe by using pole piece. Insight Non Destruct. Test. Cond. Monit. 54(9), 489–492 (2012)

    Article  Google Scholar 

  24. Y. Ma, R. He, J. Chen, A method for improving SNR of drill pipe leakage flux testing signals by means of magnetic concentrating effect. IEEE Trans. Magn. 51(9), 1–7 (2015)

    Article  Google Scholar 

  25. Z. Liu, Y. Kang, X. Wu, S. Yang, Study on local magnetization of magnetic flux leakage testing for storage tank floors. Insight. 45(5), 328–331 (2003)

    Article  Google Scholar 

  26. H.J.M. Jansen, P.B.J. van de Camp, M. Geerdink, Magnetisation as a key parameter of magnetic flux leakage pigs for pipeline inspection. NDTE Int. 1(30), 35 (1997)

    Google Scholar 

  27. A.L. Pullen, P.C. Charlton, N.R. Pearson, N.J. Whitehead, Magnetic flux leakage scanning velocities for tank floor inspection. IEEE Trans. Magn. 54(9), 1–8 (2018)

    Article  Google Scholar 

  28. W. Liu, J. Zhou, Y. Ma, J. Wang, J. Xu, Fabrication of PLA filaments and its printable performance. IOP Conf. Ser. Mater. Sci. Eng. 275, 012033 (2017)

    Article  Google Scholar 

  29. S. Farah, D.G. Anderson, R. Langer, Physical and mechanical properties of PLA, and their functions in widespread applications-A comprehensive review. Adv. Drug Deliv Rev. 107, 367–392 (2016)

    Article  CAS  Google Scholar 

  30. B. Tymrak, M. Kreiger, J.M. Pearce, Mechanical properties of components fabricated with open-source 3-D printers under realistic environmental conditions. Mater. Des. 58, 242–246 (2014)

    Article  CAS  Google Scholar 

  31. P.A. Eutionnat-Diffo, Y. Chen, J. Guan, A. Cayla, C. Campagne, X. Zeng, V. Nierstrasz, Stress, strain and deformation of poly-lactic acid filament deposited onto polyethylene terephthalate woven fabric through 3D printing process. Sci. Rep. 9(1), 1–18 (2019)

    Article  CAS  Google Scholar 

Download references

Acknowledgments

This research was supported by the Ministry of Science and Technology of Taiwan (Contract No. MOST 106-2221-E-027-069).

Author information

Authors and Affiliations

Authors

Corresponding authors

Correspondence to Mathivanan Durai or Ho Chang.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Durai, M., Lin, ZQ., Lan, CW. et al. Study of Defects in the Petrochemical Storage Tank Floor using the Magnetic Flux Leakage (MFL) Technique. J Fail. Anal. and Preven. 22, 807–814 (2022). https://doi.org/10.1007/s11668-022-01373-1

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11668-022-01373-1

Keywords

Navigation