Abstract
Yb-doped fiber laser (YDFL) is a promising kind of laser source due to high efficiency, excellent beam quality, robust configuration, diverse applications and so on. The progress of large-mode-area double cladding active fiber and high power laser diodes have been continuously promoting the power scaling of the YDFLs. However, the further power scaling is blocked by some physic issues including nonlinear effect, thermal-induced mode instability (MI), optical damage and so forth. So, newly-designed fibers with special structures are invented to address or relieve these limitations. The tapered fiber, which has changed mode area along its longitudinal direction, has been demonstrated to benefit suppressing the nonlinear effect, especially the stimulated Brillouin scattering (SBS) effect. In this paper, we will review the previous work done to explore the advantages of the tapered fiber for high power output, and then for the first time to our knowledge, demonstrate an all-fiberized high power narrow linewidth fiber laser based on a homemade tapered Yb-doped fiber (T-YDF). As a result, an output power of 260 W with a narrow linewidth of ∼2 GHz is obtained, with SBS effectively suppressed owing to gradually increased mode area of the T-YDF as well as continuously changed Brillouin frequency shift dependent on the core diameter. Further power scaling is limited by MI, and the features of MI are studied in detail. It is pointed out that, the MI seems the primary and durative limitation factor of the tapered fiber amplifier for high power narrow linewidth output due to the gradually increased effective numerical aperture (NA) and the excitation of the high-order modes, even although it has the advantage to reduce other nonlinear effects. At last, worthwhile discussion about the optimization of the T-YDF and the whole fiber laser system for both SBS and MI suppression is conducted based on the previous and our results. It is concluded that the small diameter at the small-diameter end and low optical NA are preferred in the design of a T-YDF to ensure good beam quality and improve the MI threshold. The good splicing quality and proper coiling or bend state are also necessary.
Similar content being viewed by others
References
Jauregui C, Limpert J, Tünnermann A. High-power fibre lasers. Nat Photon, 2013, 7: 861–867
Zhong K, Shi W, Xu D G, et al. Optically pumped terahertz sources. Sci China Tech Sci, 2017, 60: 1801–1818
Li G P, Wang H, Qi X Q, et al. Widely tunable microwave photonic filter based on self-adaptive optical carrier regeneration. Sci China Tech Sci, 2017, 60: 872–877
Zhou P, Huang L, Xu J M, et al. High power linearly polarized fiber laser: Generation, manipulation and application. Sci China Tech Sci, 2017, 60: 1784–1800
Stiles E. New developments in ipg fiber laser technology. In: Proceedings of the 5th International Workshop on Fiber Lasers, Dresden, 2009
Fang Q, Li J, Shi W, et al. 5 kW near-diffraction-limited and 8 kW high-brightness monolithic continuous wave fiber lasers directly pumped by laser diodes. IEEE Photonics J, 2017, 9: 1–7
Zhou P, Xiao H, Leng J, et al. High-power fiber lasers based on tandem pumping. J Opt Soc Am B, 2017, 34: A29–A36
Beier F, Hupel C, Nold J, et al. Narrow linewidth, single mode 3 kW average power from a directly diode pumped ytterbium-doped low NA fiber amplifier. Opt Express, 2016, 24: 6011–6020
Ma P, Tao R, Su R, et al. 1.89 kW all-fiberized and polarizationmaintained amplifiers with narrow linewidth and near-diffractionlimited beam quality. Opt Express, 2016, 24: 4187–4195
Yu C X, Shatrovoy O, Fan T Y, et al. Diode-pumped narrow linewidth multi-kilowatt metalized Yb fiber amplifier. Opt Lett, 2016, 41: 5202–5205
Su R, Tao R, Wang X, et al. 2.43 kW narrow linewidth linearly polarized all-fiber amplifier based on mode instability suppression. Laser Phys Lett, 2017, 14: 085102
Dawson J W, Messerly M J, Beach R J, et al. Analysis of the scalability of diffraction-limited fiber lasers and amplifiers to high average power. Opt Express, 2008, 16: 13240–13266
Zervas M N, Codemard C A. High power fiber lasers: A review. IEEE J Sel Top Quantum Electron, 2014, 20: 219–241
Gray S, Liu A, Walton D T, et al. 502 Watt, single transverse mode, narrow linewidth, bidirectionally pumped Yb-doped fiber amplifier. Opt Express, 2007, 15: 17044–17050
Ma P, Zhou P, Ma Y, et al. Single-frequency 332 W, linearly polarized Yb-doped all-fiber amplifier with near diffraction-limited beam quality. Appl Opt, 2013, 52: 4854–4857
Jeong Y, Nilsson J, Sahu J K, et al. Power scaling of single-frequency ytterbium-doped fiber master-oscillator power-amplifier sources up to500 W. IEEE J Sel Top Quantum Electron, 2007, 13: 546–551
Huang L, Wu H, Li R, et al. 414 W near-diffraction-limited all-fiberized single-frequency polarization-maintained fiber amplifier. Opt Lett, 2017, 42: 1–4
Fang Q, Shi W, Kieu K, et al. High power and high energy monolithic single frequency 2 μm nanosecond pulsed fiber laser by using large core Tm-doped germanate fibers: experiment and modeling. Opt Express, 2012, 20: 16410–16420
Wang X, Zhou P, Wang X, et al. 102 W monolithic single frequency Tm-doped fiber MOPA. Opt Express, 2013, 21: 32386–32396
Eidam T, Wirth C, Jauregui C, et al. Experimental observations of the threshold-like onset of mode instabilities in high power fiber amplifiers. Opt Express, 2011, 19: 13218–13224
Smith A V, Smith J J. Mode instability in high power fiber amplifiers. Opt Express, 2011, 19: 10180–10192
Ward B, Robin C, Dajani I. Origin of thermal modal instabilities in large mode area fiber amplifiers. Opt Express, 2012, 20: 11407–11422
Huang L, Xu J, Ye J, et al. Power scaling of linearly polarized random fiber laser. IEEE J Sel Top Quantum Electron, 2018, 24: 1–8
Zervas M N. Transverse mode instability analysis in fibre amplifiers. In: Proceedings of Fiber Lasers XIV: Technology and Systems. San Francisco: SPIE, 2017
Liu Z, Ma P, Su R, et al. High-power coherent beam polarization combination of fiber lasers: Progress and prospect [Invited]. J Opt Soc Am B, 2017, 34: A7–A14
Beier F, Sattler B, Liem A, et al. Detailed investigations on thermal mode instabilities in LMA Yb-doped fibers. In: proceedings of OSA Technical Digest. Nagoya: OSA, 2017
Tao R, Ma P, Wang X, et al. Mitigating of modal instabilities in linearly-polarized fiber amplifiers by shifting pump wavelength. J Opt, 2015, 17: 045504
Shiraki K, Ohashi M, Tateda M. Suppression of stimulated Brillouin scattering in a fibre by changing the core radius. Electron Lett, 1995, 31: 668–669
Liu A. Suppressing stimulated Brillouin scattering in fiber amplifiers using nonuniform fiber and temperature gradient. Opt Express, 2007, 15: 977–984
Filippov V, Chamorovskii Y, Kerttula J, et al. Double clad tapered fiber for high power applications. Opt Express, 2008, 16: 1929–1944
Alvarez-Chavez J A, Grudinin A B, Nilsson J, et al. Mode selection in high power cladding pumped fibre lasers with tapered section. In: proceedings of Lasers and Electro-Optics. Baltimore: IEEE, 1999
Filippov V, Chamorovskii Y, Kerttula J, et al. 600 W power scalable single transverse mode tapered double-clad fiber laser. Opt Express, 2009, 17: 1203–1214
Kerttula J, Filippov V, Chamorovskii Y, et al. Principles and performance of tapered fiber lasers: from uniform to flared geometry. Appl Opt, 2012, 51: 7025–7038
Kerttula J, Filippov V, Chamorovskii Y, et al. Actively Q-switched 16-mJ tapered double-clad ytterbium-doped fiber laser. Opt Express, 2010, 18: 18543–18549
Filippov V, Kerttula J, Chamorovskii Y, et al. Highly efficient 750 W tapered double-clad ytterbium fiber laser. Opt Express, 2010, 18: 12499–12512
Shi C, Wang X, Zhou P, et al. Theoretical study of mode evolution in active long tapered multimode fiber. Opt Express, 2016, 24: 19473–19490
Kerttula J, Filippov V, Chamorovskii Y, et al. Tapered fiber amplifier with high gain and output power. Laser Phys, 2013, 22: 1734–1738
Zhang H, Du X, Zhou P, et al. Tapered fiber based high power random laser. Opt Express, 2016, 24: 9112–9118
Lou Z, Jin X, Zhang H, et al. High power, high-order random Raman fiber laser based on tapered fiber. IEEE Photonics J, 2017, 9: 1–6
Trikshev A I, Kurkov A S, Tsvetkov V B, et al. A 160 W singlefrequency laser based on an active tapered double-clad fiber amplifier. Laser Phys Lett, 2013, 10: 065101
Zhou Z, Zhang H, Wang X, et al. All-fiber-integrated single frequency tapered fiber amplifier with near diffraction limited output. J Opt, 2016, 18: 065504
Filippov V, Chamorovskii Y K, Golant K M, et al. Optical amplifiers and lasers based on tapered fiber geometry for power and energy scaling with low signal distortion. In: Proceedings of Fiber Lasers XIII: Technology, Systems and Application. San Francisco: SPIE, 2016
Filippov V, Chamorovskii Y, Kerttula J, et al. Single-mode 212 W tapered fiber laser pumped by a low-brightness source. Opt Lett, 2008, 33: 1416–1418
Ran Y, Su R, Ma P, et al. Standard deviation index for stimulated Brillouin scattering suppression with different homogeneities. Appl Opt, 2016, 55: 3809–3813
Filippov V, Ustimchik V, Chamorovskii Y, et al. Impact of axial profile of the gain medium on the mode instability in lasers: Regular versus tapered fibers. In: proceedings of European Conference on Lasers and Electro-Optics. Munich: OSA, 2015
Tao R, Ma P, Wang X, et al. 1.3 kW monolithic linearly polarized single-mode master oscillator power amplifier and strategies for mitigating mode instabilities. Photon Res, 2015, 3: 86–93
Tao R, Ma P, Wang X, et al. Comparison of the threshold of thermalinduced mode instabilities in polarization-maintaining and non-polarization- maintaining active fibers. J Opt, 2016, 18: 065501
Otto H J, Stutzki F, Jansen F, et al. Temporal dynamics of mode instabilities in high-power fiber lasers and amplifiers. Opt Express, 2012, 20: 15710–15722
Johansen M M, Laurila M, Maack M D, et al. Frequency resolved transverse mode instability in rod fiber amplifiers. Opt Express, 2013, 21: 21847–21856
Ran Y, Tao R, Ma P, et al. 560 W all fiber and polarization-maintaining amplifier with narrow linewidth and near-diffraction-limited beam quality. Appl Opt, 2015, 54: 7258–7263
Smith A V. Influence of signal bandwidth on mode instability thresholds of fiber amplifiers. In: Proceedings of Fiber Lasers XII: Technology Systems and Applications. San Francisco: SPIE, 2014
Kuznetsov M, Vershinin O, Tyrtyshnyy V, et al. Low-threshold mode instability in Yb3+-doped few-mode fiber amplifiers. Opt Express, 2014, 22: 29714–29725
Tao R, Ma P, Wang X, et al. Influence of core NA on thermal-induced mode instabilities in high power fiber amplifiers. Laser Phys Lett, 2015, 12: 085101
Tao R, Wang X, Zhou P, et al. Seed power dependence of mode instabilities in high-power fiber amplifiers. J Opt, 2017, 19: 065202
Xiao H, Zhou P, Wang X L et al. High power 1018 nm ytterbium doped fiber laser with an output power of 309 W. Laser Phys Lett, 2013, 10: 65102
Xiao H, Leng J, Zhang H, et al. High-power 1018 nm ytterbiumdoped fiber laser and its application in tandem pump. Appl Opt, 2015, 54: 8166–8169
Naderi S, Dajani I, Grosek J, et al. Theoretical analysis of effect of pump and signal wavelengths on modal instabilities in Yb-doped fiber amplifiers. In: Proceedings of Nonlinear Frequency Generation and Conversion: Materials, Devices and Applications. San Francisco: SPIE, 2014
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Huang, L., Zhou, Z., Shi, C. et al. Towards tapered-fiber-based all-fiberized high power narrow linewidth fiber laser. Sci. China Technol. Sci. 61, 971–981 (2018). https://doi.org/10.1007/s11431-017-9221-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11431-017-9221-3