Abstract
A Pt microelectrode was used to measure the oxygen consumption by redox reduction (ORR) on electrochemically polarised zinc in the redox competition mode. Zinc was polarised in the active and passive state, using a pH 7 and pH 13 solution, respectively. At pH 7, the oxygen concentration measured at a distance of 50 μm from the zinc surface, using the Pt microelectrode, is 15–60 % of the bulk oxygen concentration. Therefore, correspondingly, the oxygen consumption by zinc (due to ORR) is 40–85 % of the bulk oxygen concentration. At pH 13, where zinc undergoes passivation, the oxygen consumption by zinc is 70–80 % of the bulk oxygen concentration. The ORR rate on the surface of zinc passive films (ZnO/Zn(OH)2) is thus significant when compared to that on bare/actively corroding zinc. The influence of the electrode kinetics of zinc corrosion, on oxygen diffusion towards the metal surface has been investigated in this study.
Similar content being viewed by others
References
Oldham KB, Myland JC (1994) Fundamentals of electrochemical science. Academic Press Inc., San Diego
Boto KG, Williams LFG (1977) Rotating disc electrode studies of zinc corrosion. J Electroanal Chem Interfacial Chem 77:1–20
Wroblowa HS, Qaderi SB (1990) The mechanism of oxygen reduction on zinc. J Electroanal Chem Interfacial Electrochem 26:153–161
Zs Pilbath, Sziraki L (2008) The electrochemical reduction of oxygen on zinc corrosion films in alkaline solutions. Electrochim Acta 53:3218–3230
Yadav AP, Nishikata A, Tsuru T (2005) Oxygen reduction mechanism on corroded zinc. J Electroanal Chem 585:142–149
Dafydd H, Worsley DA, McMurray HN (2005) The kinetics and mechanism of cathodic oxygen reduction on zinc and zinc-aluminium alloy galvanised coatings. Corros Sci 47:3006–3018
Goux A, Pauporte T, Lincot D (2006) Oxygen reduction reaction on electrodeposited zinc oxide electrodes in KC1 solution at 70 °C. Electrochim Acta 51:3168–3172
Thomas S, Cole IS, Sridhar M, Birbilis N (2013) Revisiting zinc passivation in alkaline solutions. Electrochim Acta 97:192–201
Stratmann M, Streckel H (1990) On the atmospheric corrosion of metals which are covered with thin electrolyte layers. I. Verification of the experimental technique. Corros Sci 30:681–696
Stratmann M, Streckel H (1990) On the atmospheric corrosion of metals which are covered with thin electrolyte layers. II. Experimental results. Corros Sci 30:697–714
Venkatraman MS, Cole IS, Emmanuel B (2011) Corrosion under a porous layer: a porous electrode model and its implications for self-repair. Electrochim Acta 56:8192–8203
Macdonald DD, Ismail KM, Sikora EJ (1998) Characterization of the passive state on zinc. J Electrochem Soc 145:3141–3149
Macdonald DD (2011) The history of the point defect model for the passive state: a brief review of film growth aspects. Electrochim Acta 56:1761
Thomas S, Cole IS, Birbilis N (2012) Compact oxides formed on zinc during exposure to a single sea-water droplet. J Electrochem Soc 160:C59–C63
Dubuisson E, Lavie P, Dalard F, Caire J, Szunerits S (2006) Study of the atmospheric corrosion of galvanised steel in a micrometric electrolytic droplet. Electrochem Commun 8:911–915
Nishikata A, Ichihara V, Hayashi V, Tsuru T (1997) Influence of electrolyte layer thickness and pH on the initial stage of the atmospheric corrosion of iron. J Electrochem Soc 144:1244–1251
Cheng YL, Zhang Z, Cao FH, Li JF, Zhang JQ, Wang JM, Cao CN (2004) A study of the corrosion of aluminum alloy 2024-T3 under thin electrolyte layers. Corros Sci 46:1649–1667
Flitt HJ, Schweinsberg DP (2010) Synthesis, matching and deconstruction of polarization curves for the active corrosion of zinc in aerated near-neutral NaCl solutions. Corros Sci 52:1905–1914
Venkatraman MS, Cole IS, Emmanuel B (2011) Model for corrosion of metals covered with thin electrolyte layers: pseudo-steady state diffusion of oxygen. Electrochim Acta 56:7171–7179
Cole IS, Muster TH, Lau D, Wright N, Azmat NS (2010) Products formed during the interaction of seawater droplets with zinc surfaces. II. Results from short exposures. J Electrochem Soc 157:C213–C222
Cole IS, Muster TH, Furman SA, Wright N, Bradbury A (2008) Products formed during the interaction of seawater droplets with zinc surfaces. I. Results from 1- and 2.5-day exposures. J Electrochem Soc 155:C244–C255
Thomas S, Birbilis N, Venkatraman MS, Cole IS (2013) Self-Repairing oxides to protect zinc: review, discussion and prospects. Corros Sci 69:11–22
Lasia A (1999) Electrochemical impedance spectroscopy and its applications. Modern aspects of electrochemistry, Kluwer Academic/Plenum, New York, vol. 32:143–248
Pourbaix M (1974) Atlas of electrochemical equilibria in aqueous solutions, 2nd edn. National Association of Corrosion Engineers, Houston
Wagner C, Traud W (2006) On the interpretation of corrosion processes through the superposition of electrochemical partial processes and on the potential of mixed electrodes. Corrosion 62:844–856
Andersen TN, Ghandehari MH, Eyring H (1975) A limitation to the mixed potential concept: copper in oxygenated sulfuric acid solutions. J Electrochem Soc 122:1580–1585
Atrens A, Dietzel W (2007) The negative difference effect and unipositive Mg+. Adv Eng Mater 9:292–297
Frankel GS (1990) Growth of 2D pits in thin film aluminium. Corros Sci 30:1203–1218
Kirkland NT, Williams G, Birbilis N (2012) Observations of the galvanostatic dissolution of pure magnesium. Corros Sci 65:5–9
Frankel GS, Samaniego A, Birbilis N (2003) Evolution of hydrogen at dissolving magnesium surfaces. Corros Sci 70:104–111
Fernandez JL, Bard AJ (2003) Scanning electrochemical microscopy. 47. Imaging electrocatalytic activity for oxygen Reduction in an acidic medium by the tip generation-substrate collection mode. Anal Chem 75:2967–2974
Eckhard K, Schuhmann W (2007) Localised visualisation of O2 consumption and H2O2 formation by means of SECM for the characterisation of fuel cell catalyst activity. Electrochim Acta 53:1164–1169
Nagaiah TC, Maljusch A, Chen X, Bron M, Schuhmann W (2009) Visualization of the local catalytic activity of electrodeposited Pt–Ag Catalysts for oxygen reduction by means of SECM. ChemPhysChem 10:2711–2718
Simoes AM, Bastos AC, Ferreira MG, Gonzalez-Garcia Y, Gonzalez S, Souto RM (2007) Use of SVET and SECM to study the galvanic corrosion of an iron–zinc cell. Corros Sci 49:726–739
Gonzalez-Garcia Y, Mol JMC, Muselle T, De Graeve I, Van Assche G, Scheltjens G, Van Mele B, Terryn H (2011) SECM study of defect repair in self-healing polymer coatings on metals. Electrochem Commun 13:169–173
Bastos AC, Simoes AM, Gonzalez S, Gonzalez-Garcia Y, Souto RM (2005) Application of the scanning electrochemical microscope to the examination of organic coatings on metallic substrates. Prog Org Coat 53:177–182
Gilbert JL, Zarka L, Chang E, Thomas CH (1998) The reduction half cell in biomaterials corrosion: oxygen diffusion profiles near and cell response to polarized titanium surfaces. J Biomed Mater Res 42:321–330
Thomas S, Birbilis N, Venkatraman MS, Cole IS (2012) Corrosion of zinc as a function of pH. Corrosion 68:015009
Muster TH, Ganther WD, Cole IS (2007) The influence of microstructure on surface phenomena: rolled zinc. Corros Sci 49:2037–2058
Snook GA, Duffy NW, Pandolfo AG (2008) Detection of oxygen evolution from nickel hydroxide electrodes using scanning electrochemical microscopy. J Electrochem Soc 155:A262–A267
Mokaddem M, Volovitch P, Ogle K (2010) The anodic dissolution of zinc and zinc alloys in alkaline solution. I. Oxide formation on electrogalvanised steel. Electrochim Acta 55:7867–7875
Acknowledgments
The authors thank the Australian Research Council and the CSIRO for their financial support. Sebastian Thomas is grateful to the Department of Material Science and Engineering (MSE) of the Delft University of Technology (The Netherlands) and to the office of the Monash University International Graduate Research (MIGR) for accommodating his travel study. Lisa Rossrucker (Max Planck Institute, Germany) is also sincerely thanked for her helpful comments on the manuscript.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Thomas, S., Cole, I.S., Gonzalez-Garcia, Y. et al. Oxygen consumption upon electrochemically polarised zinc. J Appl Electrochem 44, 747–757 (2014). https://doi.org/10.1007/s10800-014-0684-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10800-014-0684-0