Elsevier

Icarus

Volume 153, Issue 1, September 2001, Pages 130-147
Icarus

Regular Article
Three-Dimensional Modeling of the Tropospheric Methane Cycle on Titan

https://doi.org/10.1006/icar.2001.6659Get rights and content

Abstract

The tropospheric methane cycle on Titan including advection, diffusion, condensation, precipitation, evaporation, and surface source is simulated by a three-dimensional general circulation model. The model takes into account the different nucleation of methane in Titan's troposphere, and assumes condensation whenever the saturation ratio (relative humidity) exceeds a critical value of either 100 or 150%. The simulation with the latter critical saturation is shown to be more compatible with the Voyager data. The meridional circulation accounts for a seasonal methane transport from the winter to summer hemisphere in the mid-troposphere, causing a higher supersaturation in late summer and early autumn. Condensation preferentially occurs in this season at 15 km altitude at low latitudes. The occasional character may be explained by the high critical saturation ratio, which cannot be often exceeded. Falling rain evaporates during the descent, so no rain arrives at the surface. The hydrological cycle of methane on Titan takes place mostly within the atmosphere. The latitudinal methane distribution near the surface cannot be reproduced by transport, evaporation, condensation, and combinations of them, indicating some undetermined surface processes affecting the methane distribution. The zonal and meridional circulation is sensitive to the methane distribution.

References (44)

Cited by (69)

  • Orbitally and geographically caused seasonal asymmetry in Titan's tropospheric climate and its implication for the lake distribution

    2019, Icarus
    Citation Excerpt :

    Methane rain reaching the surface is locally stored in a surface bucket and is available for evaporation. Unless the surface bucket is empty, the model calculates the methane evaporation rate by the bulk-aerodynamic formula (Appendix of Tokano et al., 2001) as a function of saturation deficit, near-surface wind speed and stability function. The evaporation rate scales with the moisture availability factor (between 0 and 1), which describes the ease of evaporation considering the mechanical property of the surface.

View all citing articles on Scopus
View full text